参数资料
型号: MICRF505BML TR
厂商: Micrel Inc
文件页数: 25/42页
文件大小: 0K
描述: TXRX ISM 868-915MHZ 32-MLF
标准包装: 1,000
频率: 850MHz ~ 950MHz
数据传输率 - 最大: 200kbps
调制或协议: FSK
应用: 遥测,无线控制器
功率 - 输出: 10dBm
灵敏度: -111dBm
电源电压: 2.3 V ~ 5.5 V
电流 - 接收: 13.5mA
电流 - 传输: 28mA
数据接口: PCB,表面贴装
天线连接器: PCB,表面贴装
工作温度: -40°C ~ 85°C
封装/外壳: 32-VFQFN 裸露焊盘,32-MLF?
包装: 带卷 (TR)
其它名称: MICRF505BMLTR
MICRF505BMLTR-ND
Micrel
Another much more efficient encoding type is 3B4B
where three data bits are encoded into a four-bit
word. The reason for encoding is to minimize the DC
component in the modulated data. To have minimum
DC component each four bit word should include
two elements of “1” and two elements of “0”.
Following this guidance only 6 out of 8 word
complies and two encoded words needs special
precaution. Whenever 000 and 111 data appear, the
user must set/clear a flag that indicate if last
encoded word was “Word A” and select the
respective encoded word shown in Table 11.
MICRF505BML/YML
divider values need to be programmed. The formula
for calculating the M, N and A values is given in
chapter Frequency synthesizer. The divider values
stored in the M0-, N0-, and A0- registers will be used
when transmitting a ‘0’ and the M1-, N1-, and A1-
registers will be used to transmit a ‘1’. The difference
between the two carrier frequencies corresponds to
the double sided frequency modulation. Opposite
from the modulation with the modulator, the PLL
shall now lock on a new frequency for every change
in the transmitted data. The PLL bandwidth therefore
needs to be relatively high, higher bit rate requires a
higher PLL bandwidth and vice versa. The data to
Data
000
001
010
011
100
101
110
111
Word A
1011
1100
0011
1010
0101
1001
0110
1101
Table 13. 3B4B Encoding
Word B
0100
0010
be transmitted shall be applied to pin DataIXO (see
chapter Transceiver sync-/non-synchronous mode
on how to use the pin DataClk). The DataIXO pin is
set as input in transmit mode and output in receive
mode. When set as input, a weak voltage divider will
set the level to Vdd/2, when it is not pulled up or
down by the controller. When using the modulator, it
is important that the DataIXO is kept tristated until
the transmission shall begin (when PLL is in lock
and the PA is turned on). When Data IXO is
tristated, the PLL will lock on the LO frequency
(used in receive mode). When DataIXO is set either
high or low, the RF frequency will be shifted up or
down, centered around the LO-frequency. This is
only important when using the modulator, for the
Data bits
000 000 000 000 000
Encoded words
1011 0100 1011 0100 1011
Comments
A Flag indicates if “Word
other modulation method, if DATAIXO is tristated,
the M0-, N0- and A0-registers will be used.
A” has been used
111 111 010 110 000
1101 0010 0011 0110 1011
A Flag indicates if “Word
A” has been used
Table 14. Example of 3B4B encoding
When Modulation1 Modulation0 is 10, two sets of
October 2006
25
M9999-103106
+1 408-944-0800
相关PDF资料
PDF描述
A-20GV21 BASIC SWITCH
7W-60.000MBB-T OSC 60.000 MHZ 3.3V SMD
IXFX32N100P MOSFET N-CH 1000V 32A PLUS247
X09-019WNC MOD RF 900MHZ 19.2K W/WIRE ANT
X09-019NSC-TX MOD RF TX 900MHZ 19.2K W/RPSMA
相关代理商/技术参数
参数描述
MICRF505DEV1 功能描述:射频开发工具 MICRF505 Evaluation Kit - For experimental use only RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
MICRF505DEV1 制造商:Micrel Inc 功能描述:KIT MICRF505 EVALUATION
MICRF505L 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:850MHz and 950MHz ISM Band Transceiver
MICRF505LYML 制造商:Rochester Electronics LLC 功能描述: 制造商:RF Micro Devices Inc 功能描述:
MICRF505LYML TR 功能描述:射频收发器 850MHz to 950MHz, 2.25V to 5.5V FSK Transceiver with +10dBm Power Amplifier RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray