参数资料
型号: MPC745BPX350LE
厂商: Freescale Semiconductor
文件页数: 33/56页
文件大小: 0K
描述: IC MPU PPC 350MHZ 255-FCPBGA
标准包装: 60
系列: MPC7xx
处理器类型: 32-位 MPC7xx PowerPC
速度: 350MHz
电压: 2V
安装类型: 表面贴装
封装/外壳: 255-BBGA,FCBGA
供应商设备封装: 255-FCPBGA(21x21)
包装: 托盘
MPC755 RISC Microprocessor Hardware Specifications, Rev. 8
Freescale Semiconductor
39
System Design Information
These capacitors should have a value of 0.01 or 0.1 F. Only ceramic SMT (surface mount technology)
capacitors should be used to minimize lead inductance, preferably 0508 or 0603 orientations where
connections are made along the length of the part.
In addition, it is recommended that there be several bulk storage capacitors distributed around the PCB,
feeding the VDD, L2OVDD, and OVDD planes, to enable quick recharging of the smaller chip capacitors.
These bulk capacitors should have a low ESR (equivalent series resistance) rating to ensure the quick
response time necessary. They should also be connected to the power and ground planes through two vias
to minimize inductance. Suggested bulk capacitors:100–330 F (AVX TPS tantalum or Sanyo OSCON).
8.4
Connection Recommendations
To ensure reliable operation, it is highly recommended to connect unused inputs to an appropriate signal
level through a resistor. Unused active low inputs should be tied to OVDD. Unused active high inputs
should be connected to GND. All NC (no connect) signals must remain unconnected.
Power and ground connections must be made to all external VDD, OVDD, L2OVDD, and GND pins of the
MPC755. Note that power must be supplied to L2OVDD even if the L2 interface of the MPC755 will not
be used; it is recommended to connect L2OVDD to OVDD and L2VSEL to BVSEL if the L2 interface is
unused. (This requirement does not apply to the MPC745 since it has neither an L2 interface nor L2OVDD
pins.)
8.5
Output Buffer DC Impedance
The MPC755 60x and L2 I/O drivers are characterized over process, voltage, and temperature. To measure
Z0, an external resistor is connected from the chip pad to (L2)OVDD or GND. Then, the value of each
resistor is varied until the pad voltage is (L2)OVDD/2 (see Figure 22).
The output impedance is the average of two components, the resistances of the pull-up and pull-down
devices. When data is held low, SW2 is closed (SW1 is open), and RN is trimmed until the voltage at the
pad equals (L2)OVDD/2. RN then becomes the resistance of the pull-down devices. When data is held high,
SW1 is closed (SW2 is open), and RP is trimmed until the voltage at the pad equals (L2)OVDD/2. RP then
becomes the resistance of the pull-up devices.
相关PDF资料
PDF描述
MPC7410RX500LE IC MPU 32BIT 500MHZ PPC 360-CBGA
IDT70V9189L12PF IC SRAM 576KBIT 12NS 100TQFP
IDT70V9089L12PF IC SRAM 512KBIT 12NS 100TQFP
MC68SEC000FU20 IC MPU 32BIT LP 20MHZ 64-QFP
IDT709379L12PF IC SRAM 576KBIT 12NS 100TQFP
相关代理商/技术参数
参数描述
MPC745BVT300LE 功能描述:微处理器 - MPU GF REV2.8105C RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324
MPC745BVT350LE 功能描述:微处理器 - MPU GF REV2.8105C RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324
MPC745CPX350LE 功能描述:微处理器 - MPU GF REV 2.8 105C 6W RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324
MPC745CPX350LE 制造商:Freescale Semiconductor 功能描述:IC 32-BIT MPU 350MHZ 255-FCPBGA
MPC745CVT350LE 功能描述:微处理器 - MPU GF REV2.8@6W RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324