- 您现在的位置：买卖IC网 > PDF目录15521 > NCP1238AD65R2G (ON Semiconductor)IC REG CTRLR FLYBACK PWM 7SOIC PDF资料下载
参数资料
| 型号： | NCP1238AD65R2G |
| 厂商： | ON Semiconductor |
| 文件页数： | 16/38页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR FLYBACK PWM 7SOIC |
| 标准包装： | 1 |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 70kHz |
| 占空比： | 85% |
| 电源电压： | 9.5 V ~ 28 V |
| 降压： | 无 |
| 升压： | 无 |
| 回扫： | 是 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽）7 引线 |
| 包装： | 标准包装 |
| 其它名称： | NCP1238AD65R2GOSDKR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
NCP1238
?
is set by the voltage on the FB pin. A fixed ramp
compensation is applied internally to prevent
sub ? harmonic oscillations from occurring. The V CC
must be supplied by an external source (such as an
auxiliary winding), as the startup current source cannot
permanently supply the controller without overheating.
Light load operation : When the FB voltage decreases
below V FB(fold) , typically corresponding to a load of
16% of the maximum load (for a DCM design), the
? Overload : The NCP1238 features a timer ? based
overload detection, solely dependent on the feedback
information: as soon as the internal peak current
setpoint hits the V ILIM clamp, the internal overload
timer starts to count. When the timer times out, the
controller stops and enter the protection mode,
autorecovery for the B version (the controller initiates a
new start ? up after t autorec elapses), or latched for the A
version (the latch is released if a brown ? out event
?
switching frequency starts to decrease down to
f OSC(min) . By lowering the switching losses, this feature
helps to improve the efficiency in light load conditions.
The frequency jittering is disabled in light load
operation.
No load operation : When the FB voltage decreases
below V skip(in) , typically corresponding to a load of 1%
of the maximum load, the controller enters Skip mode.
By completely stopping the switching while the
feedback voltage is below V skip(out) , the losses are
further reduced, allowing to minimize the power
dissipation under extremely low load conditions. In
order to avoid audible noise, the peak current is
gradually increased during the t SSKIP duration while
exiting the skip mode (Soft ? Skip function). In case of
abrupt load increase during Soft ? Skip mode, the
soft ? skip portion is bypassed and the peak current
?
?
occurs or V CC is reset).
Brown ? out : The NCP1238 features on its HV pin a
true AC line monitoring circuitry which includes
minimum startup threshold, brown ? out protection, and
overvoltage protection. All of these circuits are
autorecovery and operate independently of any ripple
on the input voltage. They can even work with an
unfiltered, rectified AC input. All thresholds are fixed,
but they are designed to fit most of the standard ac ? dc
conversion applications.
Latch ? off : When the Latch input is pulled up (typically
by an overvoltage condition), or pulled low (typically
by an overtemperature condition, using the provided
current source with an NTC), the controller latches off.
The latch is released when a brown ? out condition
occurs, or when V CC decreases below V CC(reset) .
needed for regulation is directly applied. V CC can be
maintained between V CC(on) and V CC(min) by the DSS.
http://onsemi.com
16
相关PDF资料 |
PDF描述 |
|---|---|
| NCP3011DTBR2G | IC REG CTRLR BUCK PWM VM 14TSSOP |
| RPP50-483.3S | CONV DC/DC 50W 36-75VIN 3.3VOUT |
| RPP40-2424DW | CONV DC/DC 40W 9-36V +/-24VOUT |
| RPP40-2415DW-F | CONV DC/DC 40W 9-36V +/-15VOUT |
| RPP40-2415DW-1F | CONV DC/DC 40W 9-36V +/-15VOUT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCP1238BD65R2G | 功能描述:电流型 PWM 控制器 DSS AUTOR SOCP 65KHZ RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| NCP1239 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Low−Standby High Performance PWM Controller |
| NCP1239D | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Low-Standby High Performance PWM Controller |
| NCP1239F | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:AC-DC Offline Switching Controllers/Regulators |
| NCP1239FDR2 | 功能描述:电流型 PWM 控制器 Low Standby Power RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。