参数资料
| 型号： | NCP5387MNR2G |
| 厂商： | ON Semiconductor |
| 文件页数： | 27/37页 |
| 文件大小： | 0K |
| 描述： | IC CTLR BUCK 2/3/4PHASE 40-QFN |
| 产品变化通告： | Specification Change MSL Updated 28/Feb/2008 |
| 标准包装： | 2,500 |
| 应用： | 控制器，Intel VR10、VR11、AMD CPU |
| 输入电压： | 4.75 V ~ 5.25 V |
| 输出数： | 4 |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 40-VFQFN 裸露焊盘 |
| 供应商设备封装： | 40-QFN（6x6） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页当前第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页
NCP5387
FUNCTIONAL DESCRIPTION
General
The NCP5387 dual edge modulated multiphase PWM
controller is specifically designed with the necessary
features for a high current VR10, VR11 or AMD CPU
power system. The IC consists of the following blocks:
Precision Programmable DAC, Differential Remote
Schematic. In 4?phase mode all 4 gate outputs are used as
shown in the 4?phase Applications Schematic. The Current
Sense inputs of unused channels should be connected to
CSN of a channel that is used. The following truth table
summarizes the modes of operation:
Gate Output Connections
Voltage Sense Amplifier, High Performance Voltage Error
Amplifier, Differential Current Feedback Amplifiers,
Precision Oscillator and Triangle Wave Generators, and
PWM Comparators. Protection features include
Undervoltage Lockout, Soft?Start, Overcurrent
Mode
2?Phase
3?Phase
4?Phase
G1
Normal
Normal
Normal
G2
OPEN
Normal
Normal
G3
Normal
Normal
Normal
G4
OPEN
GND
Normal
Protection, Overvoltage Protection, and Power Good
Monitor.
Remote Output Sensing Amplifier (RSA)
A true differential amplifier allows the NCP5387 to
measure Vcore voltage feedback with respect to the Vcore
ground reference point by connecting the Vcore reference
point to VS+, and the Vcore ground reference point to VS?.
This configuration keeps ground potential differences
between the local controller ground and the Vcore ground
reference point from affecting regulation of Vcore between
Vcore and Vcore ground reference points. The RSA also
subtracts the DAC (minus VID offset) voltage, thereby
producing an unamplified output error voltage at the
DIFFOUT pin. This output also has a 1.3 V bias voltage to
allow both positive and negative error voltages.
Precision Programmable DAC
A precision programmable DAC is provided. This DAC
has 0.5% accuracy over the entire operating temperature
range of the part. The DAC can be programmed to support
either Intel VR10 or VR11 or AMD K8 specifications. A
program selection pin is provided to accomplish this. This pin
also sets the startup mode of operation. Connect this pin to
1.25 V to select the VR11 DAC table and startup mode.
Connect this pin to ground to select the VR10 DAC table and
the VR11 startup mode. Connect this pin to VREF to select
These are the only allowable connection schemes to
program the modes of operation.
Differential Current Sense Amplifiers
Four differential amplifiers are provided to sense the
output current of each phase. The inputs of each current
sense amplifier must be connected across the current
sensing element of the phase controlled by the
corresponding gate output (G1, G2, G3, or G4). If a phase
is unused, the differential inputs to that phase’s current
sense amplifier must be shorted together and connected
to the output as shown in the 2? and 3?phase Application
Schematics .
A voltage is generated across the current sense element
(such as an inductor or sense resistor) by the current
flowing in that phase. The output of the current sense
amplifiers are used to control three functions. First, the
output controls the adaptive voltage positioning, where the
output voltage is actively controlled according to the
output current. In this function, all of the current sense
outputs are summed so that the total output current is used
for output voltage positioning. Second, the output signal is
fed to the current limit circuit. This again is the summed
current of all phases in operation. Finally, the individual
phase current is connected to the PWM comparator. In this
way current balance is accomplished.
the AMD DAC table and startup mode.
Oscillator and Triangle Wave Generator
High Performance Voltage Error Amplifier
The error amplifier is designed to provide high slew rate
and bandwidth. Although not required when operating as
the controller of a voltage regulator, a capacitor from
COMP to VFB is required for stable unity gain test
configurations.
Gate Driver Outputs and 2/3/4 Phase Operation
The part can be configured to run in 2?, 3?, or 4?phase
mode. In 2?phase mode, phases 1 and 3 should be used to
drive the external gate drivers as shown in the 2?phase
Applications Schematic. In 3?phase mode, gate output G4
must be grounded as shown in the 3?phase Applications
A programmable precision oscillator is provided. The
oscillator ’s frequency is programmed by the resistance
connected from the ROSC pin to ground. The user will
usually form this resistance from two resistors in order to
create a voltage divider that uses the ROSC output voltage
as the reference for creating the current limit setpoint
voltage. The oscillator frequency range is 100 kHz/phase
to 1.0 MHz/phase. The oscillator generates up to 4 triangle
waveforms (symmetrical rising and falling slopes)
between 1.3 V and 2.3 V. The triangle waves have a phase
delay between them such that for 2?, 3?, and 4?phase
operation the PWM outputs are separated by 180, 120, and
90 angular degrees, respectively.
http://onsemi.com
27
相关PDF资料 |
PDF描述 |
|---|---|
| NCP5388MNR2G | IC CTLR BUCK 2/3/4PHASE 40-QFN |
| NCP5389MNR2G | IC CTLR BUCK 2/3PHASE 32-QFN |
| NCP5391MNR2G | IC CTLR BUCK 2/3PHASE 32-QFN |
| NCP5392PMNR2G | IC CTLR BUCK 2/3/4PHASE 40QFN |
| NCP5392QMNR2G | IC PHASE CONTROLLER 2/3/4 40-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| NCP5388 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:2/3/4 Phase Buck Controller for VR10 and VR11 Pentium IV Processor Applications |
| NCP5388MNR2G | 功能描述:其他电源管理 2/3/4 PHASE CNTRLLR RoHS:否 制造商:Texas Instruments 输出电压范围: 输出电流:4 mA 输入电压范围:3 V to 3.6 V 输入电流: 功率耗散: 工作温度范围:- 40 C to + 110 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-48 封装:Reel |
| NCP5389 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:2/3 Phase Buck Controller for VR11 Pentium IV Processor Applications |
| NCP5389MNR2G | 功能描述:IC CTLR BUCK 2/3PHASE 32-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源，ICERA E400，E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA，WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR) |
| NCP5391 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:2/3 Phase Buck Controller for VR11 Pentium IV Processor Applications |
发布紧急采购，3分钟左右您将得到回复。