参数资料
型号: NUP2202W1T2G
厂商: ON Semiconductor
文件页数: 6/8页
文件大小: 0K
描述: IC DIODE/TVS ARRAY HS SOT-363
标准包装: 1
电压 - 反向隔离(标准值): 5V
电压 - 击穿: 6V
功率(瓦特): 500W
电极标记: 2 通道阵列 - 双向
安装类型: 表面贴装
封装/外壳: 6-TSSOP,SC-88,SOT-363
供应商设备封装: SOT-363
包装: 标准包装
其它名称: NUP2202W1T2GOSDKR
NUP2202W1
Power
Supply
V CC
I ESDpos
inductance will provide significant benefits in transient
immunity.
Even with good board layout, some disadvantages are still
present when discrete diodes are used to suppress ESD
Protected Data Line
Device
D1
D2
I ESDpos
I ESDneg
VF + V CC
I ESDneg
events across datalines and the supply rail. Discrete diodes
with good transient power capability will have larger die and
therefore higher capacitance. This capacitance becomes
problematic as transmission frequencies increase. Reducing
capacitance generally requires reducing die size. These
small die will have higher forward voltage characteristics at
? VF
Looking at the figure above, it can be seen that when a
positive ESD condition occurs, diode D1 will be forward
biased while diode D2 will be forward biased when a
negative ESD condition occurs. For slower transient
conditions, this system may be approximated as follows:
For positive pulse conditions:
typical ESD transient current levels. This voltage combined
with the smaller die can result in device failure.
The ON Semiconductor NUP2202W1 was developed to
overcome the disadvantages encountered when using
discrete diodes for ESD protection. This device integrates a
TVS diode within a network of steering diodes.
Vc = V CC + Vf D1
For negative pulse conditions:
Vc = ? Vf D2
ESD events can have rise times on the order of some
number of nanoseconds. Under these conditions, the effect
of parasitic inductance must be considered. A pictorial
representation of this is shown below.
D1
D2
D3
D4
Power
Supply
V CC
I ESDpos
0
Figure 9. NUP2202W1 Equivalent Circuit
Protected
Device
Data Line
D1
I ESDpos
I ESDneg
During an ESD condition, the ESD current will be driven
to ground through the TVS diode as shown below.
D2
V C = V CC + Vf + (L diESD/dt)
I ESDneg
Power
Supply
V CC
V C = ? Vf ? (L diESD/
dt)
An approximation of the clamping voltage for these fast
transients would be:
For positive pulse conditions:
Protected
Device
Data Line
D1
D2
I ESDpos
Vc = V CC + Vf + (L di ESD /dt)
For negative pulse conditions:
Vc = ? Vf – (L di ESD /dt)
As shown in the formulas, the clamping voltage (Vc) not
only depends on the Vf of the steering diodes but also on the
L di ESD /dt factor. A relatively small trace inductance can
result in hundreds of volts appearing on the supply rail. This
endangers both the power supply and anything attached to
that rail. This highlights the importance of good board
layout. Taking care to minimize the effects of parasitic
The resulting clamping voltage on the protected IC will
be:
Vc = V F + V TVS .
The clamping voltage of the TVS diode is provided in
Figure 8 and depends on the magnitude of the ESD current.
The steering diodes are fast switching devices with unique
forward voltage and low capacitance characteristics.
http://onsemi.com
6
相关PDF资料
PDF描述
NUP2301MW6T1 IC TVS DIODE ARRAY 2LINE SC88
NUP3112UPMUTAG TVS QUAD ARRAY LOW CAP 6-UDFN
NUP3115UPMUTAG TVS QUAD ARRAY LOW CAP 6-UDFN
NUP4000DR2G TVS ARRAY BIDIR 400W 15V 8SOIC
NUP4004M5T1G IC TVS ARRAY QUAD BIDIR 5TSOP
相关代理商/技术参数
参数描述
NUP2202W1T2G-CUT TAPE 制造商:ON 功能描述:NUP2202W Series 20 V 5 pF Uni-Directional Transient Voltage Suppressor - SC-88
NUP2301 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Low cap. diode array for 2 Line High Speed USB protection devic
NUP2301MW6T1 功能描述:整流器 Low Cap. for ESD RoHS:否 制造商:Vishay Semiconductors 产品:Standard Recovery Rectifiers 配置: 反向电压:100 V 正向电压下降: 恢复时间:1.2 us 正向连续电流:2 A 最大浪涌电流:35 A 反向电流 IR:5 uA 安装风格:SMD/SMT 封装 / 箱体:DO-221AC 封装:Reel
NUP2301MW6T1/D 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Low Capacitance Diode Array for ESD Protection in Two Data Lines
NUP2301MW6T1D 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Low Capacitance Diode Array for ESD Protection in Two Data Lines