Revision History
iii
August 2002 Revised August 2003
SPRS197B
REVISION HISTORY
This data sheet revision history highlights the technical changes made to the SPRS197A device-specific data
sheet to make it an SPRS197B revision.
Scope:
This document has been reviewed for technical accuracy; the technical content is up-to-date as of the
specified release date and includes the following changes.
PAGE(S)
NO.
ADDITIONS/CHANGES/DELETIONS
Title
Page
Replaced “Product Preview” description with “Production Data” description.
Important
Notice
Replaced “Important Notice” page.
All
Removed “Product Preview” banners from page margins.
1
Revised “USB2.0 Host Interface” to read “USB (Full/Low Speed) Host Interface” and “USB2.0 Function Interface” to read
“USB (Full Speed) Function Interface”.
4
Added paragraph that reads “In Table 21, signals with multiplexed functions are highlighted in gray. Signals with a
multiplexed pin name are separated with forward slashes as follows:”
7
Replaced Figure 22.
7
Added the following note below Figure 22: “The GDY package has not been released to production and is still in product
preview phase.”
7
Removed paragraph that reads “Figure 22 illustrates the ball locations for the 289-ball GDY ball grid array (BGA) package
and is used in conjun ction with Table 21 to locate signal names and ball grid numbers. GDY BGA ball numbers in
Table 22 are read from left-to-right, top-to-bottom.”
2032
Table 24: Deleted “or 48 MHz” from BCLK description.
Changed signal type from O to I on the configuration input (CONF) and USB.VBUS signals.
Changed signal type from O to I on the USB.VBUS signal.
35
Revised “USB2.0 Host Interface” to read “USB Host Interface” and “USB2.0 Function Interface” to read “USB Function
Interface”.
43
Deleted sentence that read “This is necessary because of the large number of integrated peripherals on the OMAP5910
device” from paragraph 3.5.4.
44
Deleted 2.0 from USB Host Controller in paragraph 3.6.1. Also revised first paragraph to indicate the controller is USB
compliant.
45
Deleted 2.0 from USB Host Controller in paragraph 3.6.2.
50
Changed note from “DSR and DTR are not available on UART1 and UART3” to “DSR and DTR are only available on UART1
and UART3”.
104
Replaced note in Section 5.1.
109
Changed 30
to 60
in second paragraph of Section 5.6.2.
120
Updated Table 513.
121
Replaced Figure 512 and Figure 513.
137
Updated the MMC.CLK from low to high in Table 529.