参数资料
| 型号： | OP27GZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 8/20页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP GP 8MHZ LN PREC 8DIP |
| 标准包装： | 48 |
| 放大器类型： | 通用 |
| 电路数： | 1 |
| 转换速率： | 2.8 V/µs |
| 增益带宽积： | 8MHz |
| 电流 - 输入偏压： | 15nA |
| 电压 - 输入偏移： | 30µV |
| 电压 - 电源，单路/双路(±)： | ±4 V ~ 18 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
| 产品目录页面： | 774 (CN2011-ZH PDF) |
OP27
Rev. F | Page 16 of 20
For reference, typical source resistances of some signal sources
are listed in Table 7.
Table 7.
Device
Source
Impedance
Comments
Strain Gauge
<500 Ω
Typically used in low frequency
applications.
Magnetic
Tape Head
<1500 Ω
Low is very important to reduce
self-magnetization problems
when direct coupling is used.
OP27 IB can be neglected.
Magnetic
Phonograph
Cartridges
<1500 Ω
Similar need for low IB in direct
coupled applications. OP27 does
not introduce any self-
magnetization problems.
Linear
Variable
Differential
Transformer
<1500 Ω
Used in rugged servo-feedback
applications. Bandwidth of
interest is 400 Hz to 5 kHz.
Table 8. Open-Loop Gain
Frequency
OP27
@ 3 Hz
100 dB
124 dB
125 dB
@ 10 Hz
100 dB
120 dB
125 dB
@ 30 Hz
90 dB
110 dB
124 dB
AUDIO APPLICATIONS
Figure 41 is an example of a phono pre-amplifier circuit using the
OP27 for A1; R1-R2-C1-C2 form a very accurate RIAA network
with standard component values. The popular method to
accomplish RIAA phono equalization is to employ frequency
dependent feedback around a high quality gain block. Properly
chosen, an RC network can provide the three necessary time
constants of 3180 μs, 318 μs, and 75 μs.
For initial equalization accuracy and stability, precision metal
film resistors and film capacitors of polystyrene or polypro-
pylene are recommended because they have low voltage
coefficients, dissipation factors, and dielectric absorption.
(high-k ceramic capacitors should be avoided here, though
low-k ceramics, such as NPO types that have excellent
dissipation factors and somewhat lower dielectric absorption,
can be considered for small values.)
CA
150pF
A1
OP27
RA
47.5k
MOVING MAGNET
CARTRIDGE INPUT
++
C4 (2)
220F
C1
0.03F
C2
0.01F
C3
0.47F
LF ROLLOFF
OUT
IN
OUTPUT
R5
100k
R4
75k
R1
97.6k
R2
7.87k
R3
100
G = 1kHz GAIN
= 0.101 ( 1 +
)
R1
R3
= 98.677 (39.9dB) AS SHOWN
2
6
3
003
17
-041
Figure 41. Phono Preamplifier Circuit
The OP27 brings a 3.2 nV/√Hz voltage noise and 0.45 pA/√Hz
current noise to this circuit. To minimize noise from other
sources, R3 is set to a value of 100 Ω, generating a voltage noise
of 1.3 nV/√Hz. The noise increases the 3.2 nV/√Hz of the
amplifier by only 0.7 dB. With a 1 kΩ source, the circuit noise
measures 63 dB below a 1 mV reference level, unweighted, in a
20 kHz noise bandwidth.
Gain (G) of the circuit at 1 kHz can be calculated by the
expression:
+
=
R3
R1
G
1
101
.
0
For the values shown, the gain is just under 100 (or 40 dB).
Lower gains can be accommodated by increasing R3, but gains
higher than 40 dB show more equalization errors because of the
8 MHz gain bandwidth of the OP27.
This circuit is capable of very low distortion over its entire
range, generally below 0.01% at levels up to 7 V rms. At 3 V
output levels, it produces less than 0.03% total harmonic
distortion at frequencies up to 20 kHz.
Capacitor C3 and Resistor R4 form a simple 6 dB per octave
rumble filter, with a corner at 22 Hz. As an option, the switch
selected Shunt Capacitor C4, a nonpolarized electrolytic,
bypasses the low frequency roll-off. Placing the rumble filter’s
high-pass action after the preamplifier has the desirable result
of discriminating against the RIAA-amplified low frequency
noise components and pickup produced low frequency
disturbances.
A preamplifier for NAB tape playback is similar to an RIAA
phono preamplifier, though more gain is typically demanded,
along with equalization requiring a heavy low frequency boost.
The circuit in Figure 41 can be readily modified for tape use, as
shown by Figure 42.
相关PDF资料 |
PDF描述 |
|---|---|
| RMCF0603JT10K0 | RES 10K OHM 1/10W 5% 0603 SMD |
| AD708AQ | IC OPAMP GP DUAL PREC 8CDIP |
| AD8643ACPZ-R2 | IC OPAMP JFET R-R 3.5MHZ 16LFCSP |
| OP484FPZ | IC OPAMP GP R-R 4.25MHZ LN 14DIP |
| 0791081059 | CONN RCPT 2MM GOLD DL 20CKT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| OP-27GZ | 制造商:AD 制造商全称:Analog Devices 功能描述:LOW NOISE, PRECISION OPERATIONAL AMPLIFIER |
| OP27NBC | 制造商:Analog Devices 功能描述: |
| OP27SAJ5/38510 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| OP27SAZ5/38510 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| OP280 | 功能描述:红外发射源 SMD RoHS:否 制造商:Fairchild Semiconductor 波长:880 nm 射束角:+/- 25 辐射强度: 最大工作温度:+ 100 C 最小工作温度:- 40 C 封装 / 箱体:Side Looker 封装:Bulk |
发布紧急采购，3分钟左右您将得到回复。