- 您现在的位置：买卖IC网 > PDF目录18774 > OTX-418-HH-CP8-MS (Linx Technologies Inc)TRANSMITTER 418MHZ MS SERIES PDF资料下载
参数资料
| 型号： | OTX-418-HH-CP8-MS |
| 厂商： | Linx Technologies Inc |
| 文件页数： | 2/5页 |
| 文件大小： | 0K |
| 描述： | TRANSMITTER 418MHZ MS SERIES |
| 产品目录绘图： | Compact Handheld Transmitter |
| 标准包装： | 25 |
| 功能： | 发射器 |
| 调制或协议： | ASK，OOK |
| 频率： | 418MHz |
| 应用： | 通用遥控系统，车库门开启器，RKE |
| 接口： | 手持型，8 按钮 |
| 数据传输率 - 最大： | 9.6 kbps |
| 特点： | 8 按钮，1000 英尺 工作距离 |
| 电源电压： | 2.1 V ~ 3.6 V |
ELECTRICAL SPECIFICATIONS
SETTING THE TRANSMITTER ADDRESS
Parameter
POWER SUPPLY
Operating Voltage
Supply Current
Power-Down Current
TRANSMITTER SECTION
Transmit Frequency Range:
OTX-315-HH-CP8-MS
OTX-418-HH-CP8-MS
OTX-433-HH-CP8-MS
Center Frequency Accuracy
ENVIRONMENTAL
Operating Temperature Range
Designation
V CC
I CC
I PDN
F C
–
–
Min.
2.1
–
–
–
–
–
-50
-40
Typical
3.0
3.4
5.0
315
418
433.92
–
–
Max.
3.6
–
–
–
–
–
+50
+85
Units
VDC
mA
nA
MHz
MHz
MHz
kHz
°C
Notes
–
–
1
–
–
–
–
1
The MS Compact Handheld Transmitter
allows the selection of one of
16,777,216 (2 24 ) unique addresses. All
transmitters are supplied set to the
same address. To avoid contention with
other units or to create unique
relationships, the address can be
changed. This is accomplished by using
a paper clip or probe to press the
CREATE button on the board through
the hole in the back of the case. Press
the button and a LED will light up in the
MODE_IND window, indicating that the
MODE_IND Window
CREATE B u tton
Figure 2: CREATE Button Access
address is being created. The address will be randomized for as long as the
Notes
1. Characterized, but not tested
THEORY OF OPERATION
The OTX-***-HH-CP8-MS Compact Handheld Transmitter combines an LR
Series transmitter and an antenna with an on-board MS Series encoder to form
a simple, yet highly reliable RF remote-control transmitter. The LR Series
transmitter is a low-cost, high-performance synthesized ASK / OOK transmitter.
The transmitter’s synthesized architecture delivers outstanding stability and
frequency accuracy, while minimizing the effects of antenna port loading and
mismatching. This reduces or eliminates frequency pulling, bit contraction, and
other negative effects that are common to SAW-based transmitter architectures,
providing a significantly higher level of performance and reliability.
When a button is pressed on the transmitter, power is applied to the internal
button is held down. Release the button and the randomized address will be
saved and the LED will begin flashing to indicate that the Control Permissions
may now be set. Press the buttons that the transmitter will have the authority to
access. Press the CREATE button with the paper clip again or wait 17 seconds
for it to time out. The address and Control Permissions are now set. The decoder
will need to learn the address before it will accept any transmissions. Please see
the Typical Applications section of this data guide or the MS Series Decoder
Data Guide for details.
OTX-***-HH-CP8-MS BUTTON ASSIGNMENTS
This diagram illustrates the relationship between the button locations and
encoder data lines.
circuitry and the encoder is enabled. The encoder then detects the logic states
of the button data lines. These states are formatted into a 2-word transmission
cycle which continues until the button is released. The encoder data is used to
modulate the transmitter which conveys the data into free space through the
antenna. Once data is received, a decoder IC is used to check the transmitter’s
address against an address saved in memory. If a match is confirmed, the
decoder’s outputs are set to replicate the transmitter’s button states. These
outputs can then be used to activate external circuitry required by the
application.
The transmitter is compatible with the LT and LR product families. For
applications where range is critical, the LR Series receiver is the best choice due
to its outstanding sensitivity. When the transmitter is combined with an LR Series
D6
D4
D2
D0
D7
D5
D3
D1
receiver and an MS Series decoder, ranges of up to 750 feet are possible.
Applications operating over shorter distances will also benefit from the increased
link reliability and superior noise immunity provided by the LR Series receiver.
Figure 3: OTX-***-HH-CP8-MS Button Assignments
Page 2
Page 3
相关PDF资料 |
PDF描述 |
|---|---|
| CMD-HHLR-433-MD_ | XMITTER HANDHELD 433MHZ 8 BUTTON |
| CMD-HHLR-315-MD_ | XMITTER HANDHELD 315MHZ 8 BUTTON |
| CMD-HHCP-433-MD_ | XMITTER HANDHELD 433MHZ 8 BUTTON |
| OTX-315-HH-KF5-MS | XMITTER KEYFOB 315MHZ 5 BUTTON |
| OTX-315-HH-KF4-MS | XMITTER KEYFOB 315MHZ 4 BUTTON |
相关代理商/技术参数 |
参数描述 |
|---|---|
| OTX-418-HH-KF1-MS | 功能描述:射频模块 1 Button MS Keyfob Transmitter 418MHz RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm |
| OTX-418-HH-KF2-MS | 功能描述:射频模块 2 Button MS Keyfob Transmitter 418MHz RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm |
| OTX-418-HH-KF3-MS | 功能描述:射频模块 3 Button MS Keyfob Transmitter 418MHz RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm |
| OTX-418-HH-KF4-MS | 功能描述:射频模块 4 Button MS Keyfob Transmitter 418MHz RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm |
| OTX-418-HH-KF5-MS | 功能描述:射频模块 5 Button MS Keyfob Transmitter 418MHz RoHS:否 制造商:Linx Technologies 产品:Transceiver Modules 频带:902 MHz to 928 MHz 输出功率:- 15.5 dBm to + 12.5 dBm 接口类型:UART 工作电源电压:- 0.3 VDC to + 5.5 VDC 传输供电电流:38.1 mA 接收供电电流:22.7 mA 天线连接器类型:U.FL 最大工作温度:+ 85 C 尺寸:1.15 mm x 0.63 mm x 0.131 mm |
发布紧急采购，3分钟左右您将得到回复。