Dual SPDT Analog Switch
PA4684
ANALOG PRODUCTS DIVISION
2929 South Fair Lane Tempe AZ 85282 Tel: (602)431-8101 Fax: (602)431-2288
www.protekanalog.com
95080 Rev.0. 08/07
NOT FOR USE IN LIFE SUPPORT SYSTEMS
Absolute Maximum Ratings
(1)
Supply Voltage VCC
................................. –0.5V to +7V
DC Switch Voltage (VS)(2) .......–0.5V to VCC +0.5V DC
Input Voltage (VIN)(2) ............................ –0.5V to +7.0V
Continuous Current NO_NC_COM_ .................. ±500mA
Peak Current NO_NC_COM_
(pulsed at 1ms 50% duty cycle) ...........................±650mA
Peak Current NO_NC_COM_
(pulsed at 1ms 10% duty cycle) ...........................±800mA
Storage Temperature Range (TSTG) ....–65°C to +150°C
Junction Temperature under Bias (TJ) ..................150°C
Junction Lead Temperature (TL)
(Soldering, 10 seconds) ...........................................260°C
Power Dissipation (PD) @ +85°C .........................250mW
Recommended Operating Conditions
(3)
Supply Voltage Operating (VCC) . . . . . . . ..1.65V to 5.5V
Control Input Voltage (VIN) . . . . . . . . . . . . . . .0V to VCC
Switch Input Voltage (VIN) . . . . . . . . . . . . . . . .0V to VCC
Output Voltage (VOUT) . . . . . . . . . . . . . . . . . . 0V to VCC
Operating Temperature (TA) . . . . . . . . . . .–40°C to +85°C
Input Rise and Fall Time (tr,tf)
Control Input VCC = 2.3V - 3.6V. . . . 0ns/V to 10ns/V
Control Input VCC = 4.5V - 5.5V. . . . . . . 0ns/V to 5ns/V
Thermal Resistance (ΘJA) . . . . . . . . . . . ……. 350°C/W
Lead Temperature (soldering 10s) . . . . . . . . . . +300°C
Bump Temperature (soldering notes)
Infared (15s). . . . . . . . . . . . . . . . . . . . . . . . . . . +220°C
Vapor Phase (60ns) . . . . . . . . . . . . . . . . . . . . +215°C
Notes:
1.
"Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the
device at these or any other conditions beyond those indicated in the operational sections of this specification is not implied.
2.
The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed.
3.
Control input must be held HIGH or LOW; it must not float.