- 您现在的位置：买卖IC网 > Datasheet目录240 > PAXLPV00 (Red Lion Controls)METER PROCESS VOLT 3 1/2-DIGIT Datasheet资料下载
参数资料
| 型号： | PAXLPV00 |
| 厂商： | Red Lion Controls |
| 文件页数： | 4/8页 |
| 文件大小： | 0K |
| 描述： | METER PROCESS VOLT 3 1/2-DIGIT |
| 标准包装： | 1 |
| 系列： | PAX®LITE |
| 类型： | 伏特表 |
| 测量范围： | 0 ~ 25 VDC |
| 显示器样式： | 红色字符，黑色背景 |
| 显示器类型： | LED |
| 显示器正面尺寸： | 3.80" L x 1.95" W（96.5 x 49.5mm） |
| 显示器位数： | 3.5 |
| 显示器位数 - 高度： | 0.560"（14.22mm） |
| 背光： | 无 |
| 安装类型： | 面板安装 |
| 端子： | 螺钉端子 |
| 电源电压： | 85 ~ 250VAC |
| 其它名称： | RLC113 |
1.0 I NSTALLING
Installation
THE
M ETER
The PAX meets NEMA 4X/IP65 requirements when properly installed. The
unit is intended to be mounted into an enclosed panel. Prepare the panel cutout
to the dimensions shown. Remove the panel latch from the unit. Slide the panel
gasket over the rear of the unit to the back of
the bezel. The unit should be installed
fully assembled. Insert the unit into
the panel cutout.
While holding the unit in place, push the panel latch over the rear of the unit
so that the tabs of the panel latch engage in the slots on the case. The panel latch
should be engaged in the farthest forward slot possible. To achieve a proper seal,
tighten the latch screws evenly until the unit is snug in the panel (Torque to
approximately 7 in-lbs [79N-cm]). Do not over-tighten the screws.
Installation Environment
The unit should be installed in a location that does not exceed the maximum
operating temperature and provides good air circulation. Placing the unit near
devices that generate excessive heat should be avoided.
The bezel should be cleaned only with a soft cloth and neutral soap product.
Do NOT use solvents. Continuous exposure to direct sunlight may accelerate the
aging process of the bezel.
PANEL CUT-OUT
2.0 S ETTING
THE
S WITCHES
The meter has switches that must be checked and/or changed prior to
applying power. To access the switches, remove the meter base from the case by
firmly squeezing and pulling back on the side rear finger tabs. This should lower
FRONT DISPLAY
the latch below the case slot (which is located just in front of the finger tabs). It
is recommended to release the latch on one side, then start the other side latch.
Set-Up DIP Switches
Two banks of DIP switches are located inside the meter. The 10 position bank
Main
Circuit
Board
4
3
2
1
ON
D.P./ BACKLIGHT
of switches are used for calibrating the meter. The values of these switches are
discussed in section 5.0 Calibrating the Meter.
The bank of 4 switches located near the front display are used for the
ON
selection of decimal points and backlight annunciator. Selecting “ON” position
enables the function.
1
2
3
4
5
OFFSET
SWITCH
1
2
3
4
FUNCTION
Decimal Point 1 (000.0)
Decimal Point 2 (00.00)
Decimal Point 3 (0.000)
Backlight Annunciator for Units Label
6
7
8
9
10
OFFSET
SPAN
SPAN
REAR TERMINALS
4
相关PDF资料 |
PDF描述 |
|---|---|
| PAXLRT00 | METER RTD TEMP 4-DIGIT |
| PAXLSG00 | METER STRAIN GAGE 3 1/2-DIGIT |
| PAXLTC00 | METER THERMOCOUPLE 4-DIGIT |
| PAXLVA00 | VOLTMETER AC 3 1/2-DIGIT |
| PAXLVD00 | VOLTMETER DC 3 1/2-DIGIT |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PAXLR000 | 功能描述:METER RATE INDICATION 6-DIGIT RoHS:是 类别:工业控制，仪表 >> 计数器 系列:PAX®LITE, PAXLR 其它有关文件:Declaration of Conformity 标准包装:1 系列:99766 计数速率:25Hz 数字/字母数:5 输入类型:机电式脉冲 输出类型:- 电源电压:24V 显示器类型:十进制拨轮 |
| PAXLRT00 | 功能描述:METER RTD TEMP 4-DIGIT RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:PAX®LITE 标准包装:12 系列:* 其它名称:Q7072030 |
| PAXLSG00 | 功能描述:METER STRAIN GAGE 3 1/2-DIGIT RoHS:否 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:PAX®LITE 标准包装:12 系列:* 其它名称:Q7072030 |
| PAXLT000 | 制造商:Red Lion Controls 功能描述:METER, TC/RTD TEMP WITH DUAL RELAY 制造商:Red Lion Controls 功能描述:TC/RTD TEMP WITH DUAL RELAY |
| PAXLT0U0 | 制造商:Red Lion Controls 功能描述:METER, UL LISTED TC/RTD TEMP W/ D RELAY 制造商:Red Lion Controls 功能描述:UL LISTED TC/RTD TEMP WITH DUAL |
发布紧急采购，3分钟左右您将得到回复。