- 您现在的位置：买卖IC网 > Datasheet目录240 > PAXLSG00 (Red Lion Controls)METER STRAIN GAGE 3 1/2-DIGIT Datasheet资料下载
参数资料
| 型号： | PAXLSG00 |
| 厂商： | Red Lion Controls |
| 文件页数： | 6/8页 |
| 文件大小： | 0K |
| 描述： | METER STRAIN GAGE 3 1/2-DIGIT |
| 标准包装： | 1 |
| 系列： | PAX®LITE |
| 类型： | 应力测量仪，毫伏表 |
| 测量范围： | ±2V |
| 显示器样式： | 红色字符，黑色背景 |
| 显示器类型： | LED |
| 显示器正面尺寸： | 3.80" L x 1.95" W（96.5 x 49.5mm） |
| 显示器位数： | 3.5 |
| 显示器位数 - 高度： | 0.560"（14.22mm） |
| 安装类型： | 面板安装 |
| 端子： | 端接块 |
| 电源电压： | 85 ~ 250VAC |
| 其它名称： | RLC114 |
4.0 S CALING
THE
M ETER
PAXLSG SCHEMATIC
+V -V
(-)
S1
5K
(+)
FINE OFFSET
ADJ.
+/-OFFSET
SELECT
COARSE OFFSET
SELECT SWS.
GAIN COARSE
SELECT SWITCHES
(+)SIG.
5
DIGITAL DISPLAY
STRAIN GAGE
TRANSDUCER
5K
K1
30K
COARSE GAIN
ADJ.
FINE GAIN ADJ.
CW
CW
DIGITAL VOLT-
METER & DISPLAY
DRIVER CIRCUIT
100K
S3
S2
S1
V
S4
30K
30K
-SIG.
+SIG.
30K
30K
K3
50K
5K
45K
K4
30K
30K
DECIMAL POINT / BACKLIGHT
SWITCHES
(-)SIG.
6
5K
K2
DESCRIPTION OF OPERATION
The Pax Lite Strain Gage Indicator (PAXLSG) consists of a digital voltmeter
combined with a high-gain, differential input amplifier that has provision for wide
range scaling adjustment (shown above). The unit also incorporates an excitation
power supply (5 or 10 VDC) that delivers up to 120 mA. In the simplified
schematic above, K1, K2, and K3 form a high-gain, high-stability, differential
input preamplifier with a single ended output. The gain of this preamplifier is set
up by coarse gain select switches S5 through S9. These switches can be turned on
in combination to provide discrete steps of gain-range adjustment. The output of
the preamplifier (K3 output) is applied to the summing amplifier (K4) through
coarse and fine adjustable potentiometers. These adjustable potentiometers
provide final vernier gain adjustment over a range of slightly more than 2:1. An
adjustable offset voltage signal is also added in at the input of K4 for zero-balance
or for applications where the transfer curve must be offset from zero.
GAIN ADJUSTMENTS
Gain is defined as the Units of Numerical change seen on the display per mV
(millivolt) of input signal change (disregarding display decimal points). In effect,
gain determines the slope of the transfer curve and is expressed in Units/mV.
GAIN = (Max. Num. Readout) - (Min. Num. Readout)
(Max. mV Input Sig.) - (Min. mV Input Sig.)
Note: Disregarded Decimal Points in Readout.
For example, if an PAXLSG is to display 50.0 @ 2 mV (min.) and 169.0 @
19 mV (max.), the required gain will be:
COARSE GAIN SELECT SWITCHES
Each of the coarse gain select switches is marked with the amount of
maximum gain it will contribute when turned on. They are turned on singly or
in combination (adding up each of their gain contributions), to arrive at a
maximum gain value that is just above the desired gain value. To achieve the
desired gain of 70 Units/mV in the example just given, the following switches
would be turned on:
S6 (Gain 50) + S7 (Gain 16) + S8 (Gain 6.6) = 72.6 Units/mV
With these switches ON, the coarse and fine vernier adjustments cover a gain
range from about 36 Units/mV (? of max.) to 72.6 Units/mV. The required gain
of 70 Units/mV falls within this adjustable range.
COARSE AND FINE GAIN ADJUSTMENTS
Once the gain select switches have been set, the final gain calibration is made
with the Coarse and Fine Gain adjustments. Both of these adjustments are
15-Turn, screwdriver adjustable potentiometers that increase gain with
clockwise rotation. The Coarse adjustment has a 2:1 range. The Fine adjustment
has a range of 5-10% (depending on the setting of the Coarse adjustment). Both
pots are located at the rear of the meter.
OFFSET ADJUSTMENTS
Offset adjustments move the transfer curve up-and-down along the vertical axis
without changing the slope (Gain). They are used to “balance” the output of
transducers or to intentionally introduce an offset, such as tare-load compensation.
The Fine Offset Adjustment is a 15-turn screwdriver adjustable potentiometer,
GAIN = 1690 Units - 500 Units
19 mV - 2 mV
= 70 Units/mV
located at the rear of the meter. It has a range of ±125 Numerical Units of offset
which is sufficient for balancing the output of most transducers.
The Coarse Offset Switches (S2, 3, and 4) can be used to add additional steps
Note: Remember, display decimal points are disregarded.
To establish this gain, the settings of the coarse gain select switches must first
be determined. These switches establish the maximum end of the 2:1 adjustment
range of the coarse and fine vernier gain adjustments.
6
of offset. Like the coarse gain select switches, the offset switches are marked
with the approximate value of offset contributed by each switch, and they can
be turned on in combinations with each switch, contributing its value to the
total. Switch S1 selects the polarity of the offset signal and can be set to either
add or subtract the offset contribution of the switches. The maximum offset that
can be obtained with all switches ON and the Fine Offset at its maximum is
±1000, which is one half of the full scale readout.
相关PDF资料 |
PDF描述 |
|---|---|
| PAXLTC00 | METER THERMOCOUPLE 4-DIGIT |
| PAXLVA00 | VOLTMETER AC 3 1/2-DIGIT |
| PAXLVD00 | VOLTMETER DC 3 1/2-DIGIT |
| PAXTM100 | TIMER DISPLAY 1/8 DIN PRESET 6 D |
| PB-1583-TF | BOX ABS 4.37X3.12X2" BK 1=10PCS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PAXLT000 | 制造商:Red Lion Controls 功能描述:METER, TC/RTD TEMP WITH DUAL RELAY 制造商:Red Lion Controls 功能描述:TC/RTD TEMP WITH DUAL RELAY |
| PAXLT0U0 | 制造商:Red Lion Controls 功能描述:METER, UL LISTED TC/RTD TEMP W/ D RELAY 制造商:Red Lion Controls 功能描述:UL LISTED TC/RTD TEMP WITH DUAL |
| PAXLTC00 | 功能描述:METER THERMOCOUPLE 4-DIGIT RoHS:否 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:PAX®LITE 标准包装:12 系列:* 其它名称:Q7072030 |
| PAXLVA00 | 功能描述:VOLTMETER AC 3 1/2-DIGIT RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:PAX®LITE 标准包装:12 系列:* 其它名称:Q7072030 |
| PAXLVD00 | 功能描述:VOLTMETER DC 3 1/2-DIGIT RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:PAX®LITE 标准包装:12 系列:* 其它名称:Q7072030 |
发布紧急采购，3分钟左右您将得到回复。