参数资料
型号: PCA9550DP,118
厂商: NXP Semiconductors
文件页数: 1/26页
文件大小: 0K
描述: IC LED DRIVER BLINKER 8-TSSOP
产品培训模块: LED Controllers
I²C Bus Fundamentals
标准包装: 1
拓扑: 开路漏极,PWM
输出数: 2
内部驱动器:
类型 - 主要: LED 闪烁器
频率: 400kHz
电源电压: 2.3 V ~ 5.5 V
安装类型: 表面贴装
封装/外壳: 8-TSSOP,8-MSOP(0.118",3.00mm 宽)
供应商设备封装: 8-TSSOP
包装: 标准包装
工作温度: -40°C ~ 85°C
产品目录页面: 844 (CN2011-ZH PDF)
配用: 568-4002-ND - DEMO BOARD I2C
其它名称: 568-3387-6
PCA9550
2-bit I 2 C-bus LED driver with programmable blink rates
Rev. 05 — 13 October 2008
Product data sheet
1. General description
The PCA9550 LED blinker blinks LEDs in I 2 C-bus and SMBus applications where it is
necessary to limit bus traf?c or free up the I 2 C master's (MCU, MPU, DSP, chip set, etc.)
timer. The uniqueness of this device is the internal oscillator with two programmable blink
rates. To blink LEDs using normal I/O expanders like the PCF8574 or PCA9554, the bus
master must send repeated commands to turn the LED on and off. This greatly increases
the amount of traf?c on the I 2 C-bus and uses up one of the master's timers. The PCA9550
LED blinker instead requires only the initial set-up command to program BLINK RATE 1
and BLINK RATE 2 (i.e., the frequency and duty cycle). From then on, only one command
from the bus master is required to turn each individual open-drain output ON, OFF, or to
cycle at BLINK RATE 1 or BLINK RATE 2. Maximum output sink current is 25 mA per bit
and 50 mA per package.
Any bits not used for controlling the LEDs can be used for General Purpose parallel
Input/Output (GPIO) expansion.
The active LOW hardware reset pin (RESET) and Power-On Reset (POR) initializes the
registers to their default state, all zeroes, causing the bits to be set HIGH (LED off).
One hardware address pin on the PCA9550 allows two devices to operate on the same
bus.
2. Features
I 2 LED drivers (on, off, ?ashing at a programmable rate)
I 2 selectable, fully programmable blink rates (frequency and duty cycle) between
0.172 Hz and 44 Hz (5.82 seconds and 0.023 second)
I Input/output not used as LED drivers can be used as regular GPIOs
I Internal oscillator requires no external components
I I 2 C-bus interface logic compatible with SMBus
I Internal power-on reset
I Noise ?lter on SCL/SDA inputs
I Active LOW reset input
I 2 open-drain outputs directly drive LEDs to 25 mA
I Controlled edge rates to minimize ground bounce
I No glitch on power-up
I Supports hot insertion
I Low standby current
I Operating power supply voltage range of 2.3 V to 5.5 V
I 0 kHz to 400 kHz clock frequency
相关PDF资料
PDF描述
PCA9551BS,118 IC LED DRIVER BLINKER 16-HVQFN
PCA9552D,118 IC LED DRIVER BLINKER 24-SOIC
PCA9553DP/01,118 IC LED DRIVER LINEAR 8-TSSOP
PCA9624PW,118 IC LED DRIVER RGBA 24-TSSOP
PCA9625D/S911,518 IC LED DRIVER RGBA 32-SOIC
相关代理商/技术参数
参数描述
PCA9550DP-T 功能描述:LED照明驱动器 2-BIT I2C FM OD LED BLK RST RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9550TK 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:2-bit I2C-bus LED driver with programmable blink rates
PCA9551 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:8-bit I2C-bus LED driver with programmable blink rates
PCA9551BS 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:8-bit I2C-bus LED driver with programmable blink rates
PCA9551BS,118 功能描述:LED照明驱动器 8-BIT I2C FM OD LED RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N