- 您现在的位置：买卖IC网 > Datasheet目录349 > PCA9550DP,118 (NXP Semiconductors)IC LED DRIVER BLINKER 8-TSSOP Datasheet资料下载
参数资料
| 型号： | PCA9550DP,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 7/26页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVER BLINKER 8-TSSOP |
| 产品培训模块： | LED Controllers I²C Bus Fundamentals |
| 标准包装： | 1 |
| 拓扑： | 开路漏极，PWM |
| 输出数： | 2 |
| 内部驱动器： | 是 |
| 类型 - 主要： | LED 闪烁器 |
| 频率： | 400kHz |
| 电源电压： | 2.3 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 标准包装 |
| 工作温度： | -40°C ~ 85°C |
| 产品目录页面： | 844 (CN2011-ZH PDF) |
| 配用： | 568-4002-ND - DEMO BOARD I2C |
| 其它名称： | 568-3387-6 |
NXP Semiconductors
PCA9550
2-bit I 2 C-bus LED driver with programmable blink rates
6.4 Pins used as GPIOs
LED pins not used to control LEDs can be used as General Purpose Input/Outputs
(GPIOs).
For use as input, set LEDn to high-impedance (01) and then read the pin state via the
Input register.
For use as output, connect external pull-up resistor to the pin and size it according to the
DC recommended operating characteristics. LEDn output pin is HIGH when the output is
programmed as high-impedance, and LOW when the output is programmed LOW through
the LED selector register (LS0). The output can be pulse-width controlled when PWM0 or
PWM1 are used.
6.5 Power-on reset
When power is applied to V DD , an internal Power-On Reset (POR) holds the PCA9550 in
a reset condition until V DD has reached V POR . At that point, the reset condition is released
and the PCA9550 registers are initialized to their default states, all the outputs in the
OFF state. Thereafter, V DD must be lowered below 0.2 V to reset the device.
6.6 External RESET
A reset can be accomplished by holding the RESET pin LOW for a minimum of t w(rst) . The
PCA9550 registers and I 2 C-bus state machine will be held in their default states until the
RESET input is once again HIGH.
This input requires a pull-up resistor to V DD if no active connection is used.
PCA9550_5
? NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 05 — 13 October 2008
7 of 26
相关PDF资料 |
PDF描述 |
|---|---|
| PCA9551BS,118 | IC LED DRIVER BLINKER 16-HVQFN |
| PCA9552D,118 | IC LED DRIVER BLINKER 24-SOIC |
| PCA9553DP/01,118 | IC LED DRIVER LINEAR 8-TSSOP |
| PCA9624PW,118 | IC LED DRIVER RGBA 24-TSSOP |
| PCA9625D/S911,518 | IC LED DRIVER RGBA 32-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9550DP-T | 功能描述:LED照明驱动器 2-BIT I2C FM OD LED BLK RST RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9550TK | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:2-bit I2C-bus LED driver with programmable blink rates |
| PCA9551 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:8-bit I2C-bus LED driver with programmable blink rates |
| PCA9551BS | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:8-bit I2C-bus LED driver with programmable blink rates |
| PCA9551BS,118 | 功能描述:LED照明驱动器 8-BIT I2C FM OD LED RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
发布紧急采购，3分钟左右您将得到回复。