参数资料
型号: PCA9552PW,118
厂商: NXP Semiconductors
文件页数: 1/28页
文件大小: 0K
描述: IC LED DRIVER BLINKER 24-TSSOP
标准包装: 2,500
拓扑: 开路漏极,PWM
输出数: 16
内部驱动器:
类型 - 主要: LED 闪烁器
频率: 400kHz
电源电压: 2.3 V ~ 5.5 V
安装类型: 表面贴装
封装/外壳: 24-TSSOP(0.173",4.40mm 宽)
供应商设备封装: 24-TSSOP
包装: 带卷 (TR)
工作温度: -40°C ~ 85°C
其它名称: 935272394118
PCA9552PW-T
PCA9552PW-T-ND
PCA9552
16-bit I 2 C-bus LED driver with programmable blink rates
Rev. 05 — 9 March 2006
Product data sheet
1. General description
The PCA9552 LED blinker blinks LEDs in I 2 C-bus and SMBus applications where it is
necessary to limit bus traf?c or free up the I 2 C-bus master's (MCU, MPU, DSP, chip set,
etc.) timer. The uniqueness of this device is the internal oscillator with two programmable
blink rates. To blink LEDs using normal I/O expanders like the PCF8574 or PCA9554, the
bus master must send repeated commands to turn the LED on and off. This greatly
increases the amount of traf?c on the I 2 C-bus and uses up one of the master's timers. The
PCA9552 LED blinker instead requires only the initial setup command to program
BLINK RATE 1 and BLINK RATE 2 (that is, the frequency and duty cycle) for each
individual output. From then on, only one command from the bus master is required to
turn each individual open-drain output on, off, or to cycle at BLINK RATE 1 or
BLINK RATE 2. Maximum output sink current is 25 mA per bit and 200 mA per package.
Any bits not used for controlling the LEDs can be used for General Purpose Parallel
Input/Output (GPIO) expansion.
The active LOW hardware reset pin (RESET) and Power-On Reset (POR) initializes the
registers to their default state, all zeroes, causing the bits to be set HIGH (LED off).
Three hardware address pins on the PCA9552 allow eight devices to operate on the same
bus.
2. Features
s 16 LED drivers (on, off, ?ashing at a programmable rate)
s 2 selectable, fully programmable blink rates (frequency and duty cycle) between
0.172 Hz and 44 Hz (5.82 seconds and 0.023 seconds)
s Input/outputs not used as LED drivers can be used as regular GPIOs
s Internal oscillator requires no external components
s I 2 C-bus interface logic compatible with SMBus
s Internal power-on reset
s Noise ?lter on SCL/SDA inputs
s Active LOW reset input
s 16 open-drain outputs directly drive LEDs to 25 mA
s Edge rate control on outputs
s No glitch on power-up
s Supports hot insertion
s Low standby current
s Operating power supply voltage range of 2.3 V to 5.5 V
s 0 Hz to 400 kHz clock frequency
相关PDF资料
PDF描述
PCA9532PW,118 IC LED DRIVER RGB 24-TSSOP
CDBA180-G DIODE SCHOTTKY 1A 80V DO-214AC
P51-500-S-I-P-4.5OVP-000-000 SENSOR 500PSI 7/16-20 UNF 4.5V
P51-300-S-W-I12-4.5V-000-000 SENSOR 300PSI 1/8-27NPT .5-4.5V
P51-1500-S-E-M12-4.5V-000-000 SENSOR 1500PSI 3/8-24 UNF 4.5V
相关代理商/技术参数
参数描述
PCA9553 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:4-bit I2C LED driver with programmable blink rates
PCA9553D 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:4-bit I2C LED driver with programmable blink rates
PCA9553D/01 功能描述:LED照明驱动器 LED DRVR 4BIT I2C RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9553D/01,112 功能描述:LED照明驱动器 LED DRVR 4BIT I2C RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9553D/01,118 功能描述:LED照明驱动器 4-BIT I2C FM OD LED BLK RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N