- 您现在的位置：买卖IC网 > PDF目录3777 > PCA9575PW2,118 (NXP Semiconductors)IC I2C/SMBUS 16BIT GPIO 28TSSOP PDF资料下载
参数资料
| 型号： | PCA9575PW2,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 11/38页 |
| 文件大小： | 0K |
| 描述： | IC I2C/SMBUS 16BIT GPIO 28TSSOP |
| 产品培训模块： | I²C Bus Fundamentals |
| 特色产品： | NXP - I2C Interface |
| 标准包装： | 1 |
| 接口： | I²C，SM 总线 |
| 输入/输出数： | 16 |
| 中断输出： | 是 |
| 频率 - 时钟： | 400kHz |
| 电源电压： | 1.1 V ~ 3.6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 28-TSSOP |
| 包装： | 标准包装 |
| 包括： | POR |
| 其它名称： | 568-6647-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
PCA9575_3
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 03 — 9 November 2009
19 of 38
NXP Semiconductors
PCA9575
16-bit I2C-bus and SMBus, level translating, low voltage GPIO
7.9 Software reset
The Software Reset Call allows all the devices in the I2C-bus to be reset to the power-up
state value through a specic formatted I2C-bus command. To be performed correctly, it
implies that the I2C-bus is functional and that there is no device hanging the bus.
The Software Reset sequence is dened as following:
1. A START command is sent by the I2C-bus master.
2. The reserved General Call I2C-bus address ‘0000 000’ with the R/W bit set to 0 (write)
is sent by the I2C-bus master.
3. The PCA9575 device(s) acknowledge(s) after seeing the General Call address
‘0000 0000’ (00h) only. If the R/W bit is set to logic 1 (read), no acknowledge is
returned to the I2C-bus master.
4. Once the General Call address has been sent and acknowledged, the master sends
1 byte. The value of the byte must be equal to 06h (1000 0011).The PCA9575
acknowledges this value only. If the byte is not equal to 06h, the PCA9575 does not
acknowledge it. If more than 1 byte of data is sent, the PCA9575 does not
acknowledge anymore.
5. Once the right byte has been sent and correctly acknowledged, the master sends a
STOP command to end the Software Reset sequence: the PCA9575 then resets to
the default value (power-up value) and is ready to be addressed again within the
specied bus free time. If the master sends a Repeated START instead, no reset is
performed. The I2C-bus master must interpret a non-acknowledge from the PCA9575
(at any time) as a ‘Software Reset Abort’. The PCA9575 does not initiate a software
reset.
7.10 Interrupt output (INT)
The open-drain active LOW interrupt is activated when one of the port pins changes state
and the port pin is congured as an input and the interrupt on it is not masked. The
interrupt is deactivated when the port pin input returns to its previous state or the Input
Port register is read. It is highly recommended to program the MSK register, and the CFG
registers during the initialization sequence after power-up, since any change to them
during Normal mode operation may cause undesirable interrupt events to happen.
Remark: Changing an I/O from an output to an input may cause a false interrupt to occur
if the state of the pin does not match the contents of the Input Port register. Only a Read of
the Input Port register that contains the bit(s) image of the input(s) that generated the
interrupt clears the interrupt condition.
7.11 Standby
The PCA9575 goes into standby when the I2C-bus is idle. Standby supply current is lower
than 2.0
A (typical).
相关PDF资料 |
PDF描述 |
|---|---|
| ATTINY44A-SSUR | MCU AVR 4KB FLASH 20MHZ 14SOIC |
| PCA8575D,112 | IC I/O EXPANDER I2C 16B 24SOIC |
| PCA9535CPW,118 | IC I/O EXPANDER I2C 16B 24TSSOP |
| PCA9501PW,112 | IC I/O EXPANDER I2C 8B 20TSSOP |
| PCA9501PW,118 | IC I/O EXPANDER I2C 8B 20TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9600D | 功能描述:缓冲器和线路驱动器 FM+ BUS BUFFER RoHS:否 制造商:Micrel 输入线路数量:1 输出线路数量:2 极性:Non-Inverting 电源电压-最大:+/- 5.5 V 电源电压-最小:+/- 2.37 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Reel |
| PCA9600D,112 | 功能描述:缓冲器和线路驱动器 FM+ BUS BUFFER RoHS:否 制造商:Micrel 输入线路数量:1 输出线路数量:2 极性:Non-Inverting 电源电压-最大:+/- 5.5 V 电源电压-最小:+/- 2.37 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Reel |
| PCA9600D,118 | 功能描述:缓冲器和线路驱动器 FM+ BUS BUFFER RoHS:否 制造商:Micrel 输入线路数量:1 输出线路数量:2 极性:Non-Inverting 电源电压-最大:+/- 5.5 V 电源电压-最小:+/- 2.37 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Reel |
| PCA9600D118 | 制造商:Rochester Electronics LLC 功能描述: 制造商:NXP 功能描述: 制造商:NXP Semiconductors 功能描述: |
| PCA9600DP | 制造商:NXP Semiconductors 功能描述:IC BUS BUFFER BI-DIR DUAL 制造商:NXP Semiconductors 功能描述:IC, BUS BUFFER, BI-DIR, DUAL, 8TSSOP 制造商:NXP Semiconductors 功能描述:IC, BUS BUFFER, BI-DIR, DUAL, 8TSSOP; Logic Device Type:Bidirectional; Supply Voltage Min:2.5V; Supply Voltage Max:15V; Logic Case Style:TSSOP; No. of Pins:8; Operating Temperature Min:-40C; Operating Temperature Max:85C; MSL:MSL 1;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。