参数资料
型号: PCA9625D/S911,518
厂商: NXP Semiconductors
文件页数: 12/33页
文件大小: 0K
描述: IC LED DRIVER RGBA 32-SOIC
标准包装: 1,000
拓扑: 开路漏极,PWM
输出数: 16
内部驱动器:
类型 - 主要: 背光,LED 闪烁器
类型 - 次要: RGBA
频率: 1MHz
电源电压: 2.3 V ~ 5.5 V
输出电压: 24V
安装类型: 表面贴装
封装/外壳: 32-SOIC(0.295",7.50mm 宽)
供应商设备封装: 32-SO
包装: 管件
工作温度: -40°C ~ 85°C
其它名称: 935285147518
PCA9625D/S911-T
PCA9625D/S911-T-ND
NXP Semiconductors
PCA9625
16-bit Fm+ I 2 C-bus 100 mA 24 V LED driver
A 97 kHz ?xed frequency signal is used for each output. Duty cycle is controlled through
256 linear steps from 00h (0 % duty cycle = LED output off) to FFh
(99.6 % duty cycle = LED output at maximum brightness). Applicable to LED outputs
programmed with LDRx = 10 or 11 (LEDOUT0 to LEDOUT3 registers).
IDCx [ 7 : 0 ]
duty cycle = ---------------------------
256
7.3.4 GRPPWM, group duty cycle control
Table 8.        GRPPWM - Group brightness control register (address 12h) bit description
Legend: * default value
(1)
Address
12h
Register
GRPPWM
Bit
7:0
Symbol
GDC[7:0]
Access
R/W
Value
1111 1111
Description
GRPPWM register
When DMBLNK bit (MODE2 register) is programmed with logic 0, a 190 Hz ?xed
frequency signal is superimposed with the 97 kHz individual brightness control signal.
GRPPWM is then used as a global brightness control allowing the LED outputs to be
dimmed with the same value. The value in GRPFREQ is then a ‘Don’t care’.
General brightness for the 16 outputs is controlled through 256 linear steps from 00h
(0 % duty cycle = LED output off) to FFh (99.6 % duty cycle = maximum brightness).
Applicable to LED outputs programmed with LDRx = 11 (LEDOUT0 to LEDOUT3
registers).
When DMBLNK bit is programmed with logic 1, GRPPWM and GRPFREQ registers
de?ne a global blinking pattern, where GRPFREQ contains the blinking period (from
24 Hz to 10.73 s) and GRPPWM the duty cycle (ON/OFF ratio in %).
GDC [ 7 : 0 ]
duty cycle = ---------------------------
256
7.3.5 GRPFREQ, group frequency
Table 9. GRPFREQ - Group Frequency register (address 13h) bit description
Legend: * default value.
(2)
Address
13h
Register
GRPFREQ
Bit
7:0
Symbol
GFRQ[7:0]
Access
R/W
Value
0000 0000*
Description
GRPFREQ register
GRPFREQ is used to program the global blinking period when DMBLNK bit (MODE2
register) is equal to 1. Value in this register is a ‘Don’t care’ when DMBLNK = 0.
Applicable to LED outputs programmed with LDRx = 11 (LEDOUT0 to LEDOUT3
registers).
Blinking period is controlled through 256 linear steps from 00h (41 ms, frequency 24 Hz)
to FFh (10.73 s).
global blinking period = ---------------------------------------- ( s )
PCA9625_2
GFRQ [ 7 : 0 ] + 1
24
(3)
? NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 02 — 15 January 2008
12 of 33
相关PDF资料
PDF描述
PCA9626BS,518 IC LED DRIVER RGBA 48HVQFN
PCA9632DP2,118 IC LED DRIVER RGBA 10-TSSOP
PCA9633BS,118 IC LED DRIVER RGBA 16-HVQFN
PCA9634D,118 IC LED DRIVER RGBA 20-SOIC
PCA9635PW/S911,118 IC LED DRIVER RGBA 28-TSSOP
相关代理商/技术参数
参数描述
PCA9625D-T 功能描述:LED照明驱动器 16BT I2C FMTP LED HVCON RST OE RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9626B 功能描述:LED照明驱动器 24bit Fm+ I2C-bus 100mA 40V LED driver RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9626B,118 功能描述:LED照明驱动器 24bit Fm+ I2C-bus 100mA 40V LED driver RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N
PCA9626B118 制造商:NXP Semiconductors 功能描述:IC LED DRVR LQFP
PCA9626BS,518 功能描述:LED照明驱动器 24-bit Fm+ I2C-bus 100mA 40 V LEDdriver RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N