- 您现在的位置：买卖IC网 > Datasheet目录350 > PCA9633BS,118 (NXP Semiconductors)IC LED DRIVER RGBA 16-HVQFN Datasheet资料下载
参数资料
| 型号： | PCA9633BS,118 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 13/43页 |
| 文件大小： | 0K |
| 描述： | IC LED DRIVER RGBA 16-HVQFN |
| 产品培训模块： | LED Controllers I²C Bus Fundamentals |
| 标准包装： | 1 |
| 拓扑： | 开路漏极，PWM |
| 输出数： | 4 |
| 内部驱动器： | 两者兼有 |
| 类型 - 主要： | 背光，LED 闪烁器 |
| 类型 - 次要： | RGBA |
| 频率： | 25MHz |
| 电源电压： | 2.3 V ~ 5.5 V |
| 输出电压： | 5.5V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-VQFN 裸露焊盘 |
| 供应商设备封装： | 16-HVQFN |
| 包装： | 标准包装 |
| 工作温度： | -40°C ~ 85°C |
| 产品目录页面： | 844 (CN2011-ZH PDF) |
| 配用： | OM6276,598-ND - DEMO BOARD PWM LED 622-1004-ND - BOARD DEMO FOR PHILIPS PCA9633 |
| 其它名称： | 568-3234-6 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页
NXP Semiconductors
PCA9633
4-bit Fm+ I 2 C-bus LED driver
Table 9. MODE2 - Mode register 2 (address 01h) bit description …continued
Legend: * default value.
Bit
1 to 0
Symbol
OUTNE[1:0]
[3][4]
Access
R/W
Value
00
01*
Description
When OE = 1 (output drivers not enabled), LEDn = 0.
When OE = 1 (output drivers not enabled):
LEDn = 1 when OUTDRV = 1
LEDn = high-impedance when OUTDRV = 0 (same as OUTNE[1:0] = 10)
10
11
When OE = 1 (output drivers not enabled), LEDn = high-impedance.
reserved
[1]
[2]
[3]
[4]
See Section 7.7 “Using the PCA9633 with and without external drivers” for more details. Normal LEDs can be driven directly in either
mode. Some newer LEDs include integrated Zener diodes to limit voltage transients, reduce EMI and protect the LEDs, and these must
be driven only in the open-drain mode to prevent overheating the IC.
Change of the outputs at the STOP command allows synchronizing outputs of more than one PCA9633. Applicable to registers from
02h (PWM0) to 08h (LEDOUT) only.
See Section 7.4 “Activ e LOW output enable input” for more details.
OUTNE[1:0] is only for PCA9633 16-pin version.
7.3.3 PWM registers 0 to 3, PWMx — Individual brightness control registers
Table 10. PWM0 to PWM3 - PWM registers 0 to 3 (address 02h to 05h) bit description
Legend: * default value.
Address
Register Bit
Symbol
Access Value
Description
02h
03h
04h
05h
PWM0
PWM1
PWM2
PWM3
7:0
7:0
7:0
7:0
IDC0[7:0]
IDC1[7:0]
IDC2[7:0]
IDC3[7:0]
R/W
R/W
R/W
R/W
0000 0000*
0000 0000*
0000 0000*
0000 0000*
PWM0 Individual Duty Cycle
PWM1 Individual Duty Cycle
PWM2 Individual Duty Cycle
PWM3 Individual Duty Cycle
A 97 kHz ?xed frequency signal is used for each output. Duty cycle is controlled through
256 linear steps from 00h (0 % duty cycle = LED output off) to FFh
(99.6 % duty cycle = LED output at maximum brightness). Applicable to LED outputs
programmed with LDRx = 10 or 11 (LEDOUT register).
IDC [ 7 : 0 ]
duty cycle = ------------------------
256
7.3.4 Group duty cycle control, GRPPWM
Table 11. GRPPWM - Group duty cycle control register (address 06h) bit description
Legend: * default value.
(1)
Address
06h
Register
GRPPWM
Bit
7:0
Symbol
GDC[7:0]
Access
R/W
Value
1111 1111
Description
GRPPWM register
When DMBLNK bit (MODE2 register) is programmed with 0, a 190 Hz ?xed frequency
signal is superimposed with the 97 kHz individual brightness control signal. GRPPWM is
then used as a global brightness control allowing the LED outputs to be dimmed with the
same value. The value in GRPFREQ is then a ‘Don’t care’.
General brightness for the 4 outputs is controlled through 256 linear steps from 00h
(0 % duty cycle = LED output off) to FFh (99.6 % duty cycle = maximum brightness).
Applicable to LED outputs programmed with LDRx = 11 (LEDOUT register).
PCA9633_5
? NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 05 — 25 July 2008
13 of 43
相关PDF资料 |
PDF描述 |
|---|---|
| PCA9634D,118 | IC LED DRIVER RGBA 20-SOIC |
| PCA9635PW/S911,118 | IC LED DRIVER RGBA 28-TSSOP |
| PCA9685PW,118 | IC LED DRIVER RGBA 28-TSSOP |
| PCA9922PW,118 | IC LED DRIVER LINEAR 16-TSSOP |
| PCA9955TW,118 | IC LED DRVR CONST CURR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PCA9633BS-T | 功能描述:LED照明驱动器 4BIT I2C FM+ TP LED CON RST OE RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9633D16 | 功能描述:LED照明驱动器 LED DRVR 4BIT I2C RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9633D16,112 | 功能描述:LED照明驱动器 LED DRVR 4BIT I2C RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9633D16,118 | 功能描述:LED照明驱动器 4BIT I2C FM+ TP LED CON RST OE RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| PCA9633DEMO | 功能描述:开发板和工具包 - 8051 Brd Philips PCA9633 RoHS:否 制造商:Silicon Labs 产品:Development Kits 工具用于评估:C8051F960, Si7005 核心: 接口类型:USB 工作电源电压: |
发布紧急采购，3分钟左右您将得到回复。