参数资料
| 型号： | PG164101 |
| 厂商： | Microchip Technology |
| 文件页数： | 14/42页 |
| 文件大小： | 0K |
| 描述： | PROGRAMMER BASELINE FLASH MCU |
| 标准包装： | 1 |
| 系列： | BFMP |
| 类型： | 基准闪存 PIC 微型 |
| 适用于相关产品： | PIC10F2XX |
| 所含物品： | 带软线的双端口可切换电源、带软线的改造手柄、工作台、海绵擦和取盒垫 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
8-Pin SOIC/MSOP/TSSOP/DIP Evaluation Board User’s Guide
2.3.1
The Hardware
This is a small four-layer board (1.5" x 2" (38.1 mm x 50.8 mm)). There are ten
connection points/pads that can use either through-hole or surface-mount connector
posts.
The pad labeled VDD is connected to the PCB power plane, while the pad labeled VSS
is connected to the PCB ground plane. All the passive components that are connected
to VDD or VSS are connected to either the power plane or ground plane.
The eight remaining PCB pads correspond to the device pins (i.e.; pad 1 connects to
pin 1).
Each pad has four passive components associated with them: a pull-up resistor, a
pull-down resistor, an in-line resistor and a filtering/load capacitor. The pull-up resistor
is always R2X, the pull-down resistor is R3X, the in-line resistor is R1X and the
filtering/load capacitor is C1X. The “X” is an alpha character that corresponds to a
particular pad (A to H). As an example, Pad 5’s pull-up resistor is R2E.
The green area of Figure 2-2 shows the silk-screen on the bottom layer of the PCB.
This is where the details of the implemented circuit can be written.
Capacitor C1 is the power supply filtering capacitor.
Capacitors C2 and C3 are bypass capacitors that may be required to be installed,
depending on the device selected and the system requirements (such as the noise
present on the power supply). Table 2-1 describes the components.
A 6-pin header interface is available that supports the PICmicro MCU Baseline Flash
Microcontroller Programmer (BFMP) interface. For additional information, refer to
DS51544A-page 10
FIGURE 2-2:
8-Pin SOIC/MSOP/TSSOP/DIP Evaluation Board Layout.
? 2005 Microchip Technology Inc.
相关PDF资料 |
PDF描述 |
|---|---|
| PGD050S030CSF01 | SUPPRESSOR ESD ARRAY 50PIN DSUB |
| PGFI-22011 | CORD GFCI LOCKPLUGS 20A 240VAC |
| PGFI-23111 | CORD GFCI 30A 240VAC 2' YEL |
| PGFI-831AN | CABLE GFCI AUTO 30A 208VAC 2' |
| PGFI-A040KYTT25 | CORD GFCI 120VAC 25' YEL TRITAP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PG164120 | 功能描述:程序设计器 - 基于处理器 PICkit2 Microcon- troller Programmer RoHS:否 制造商:Olimex Ltd. 产品:Programmers 工具用于评估:XMEGA, MegaAVR, tinyAVR 核心:AVR 接口类型:USB 工作电源电压:1.8 V to 5.5 V |
| PG164120 | 制造商:Microchip Technology Inc 功能描述:DEVELOPMENT PROGRAMMER ((NW)) |
| PG164120 | 制造商:Microchip Technology Inc 功能描述:MICROCONTROLLER PROGRAMMER ((NW)) |
| PG164130 | 功能描述:电路内置调试器 PICkit 3 In-Circuit Debugger RoHS:否 制造商:Microchip Technology 产品:In-Circuit Debugger Kits 工具用于评估:PIC MCUs, dsPIC DSCs 用于:07-00024, AC164113 核心:dsPIC, PIC 接口类型:USB 工作电源电压:3 V to 5 V |
| PG164130 | 制造商:Microchip Technology Inc 功能描述:PICkit 3 In-Circuit Debugger Only |
发布紧急采购，3分钟左右您将得到回复。