参数资料
| 型号： | PG164101 |
| 厂商： | Microchip Technology |
| 文件页数： | 19/42页 |
| 文件大小： | 0K |
| 描述： | PROGRAMMER BASELINE FLASH MCU |
| 标准包装： | 1 |
| 系列： | BFMP |
| 类型： | 基准闪存 PIC 微型 |
| 适用于相关产品： | PIC10F2XX |
| 所含物品： | 带软线的双端口可切换电源、带软线的改造手柄、工作台、海绵擦和取盒垫 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
Installation and Operation
2.4.6
The PCB as a SOIC-8, MSOP-8, or TSSOP-8 to DIP-8 Socket
Converter
There may be occasions when it is desireable to convert the footprint of the device to
that of a DIP package. This allows the device to be installed into an exsisting DIP
socket. Two 1x4 row pins need to be installed into the PCB’s DIP footprint when the
device is installed into the appropriate package footprint.
This allows the PCB to convert the SOIC-8, MSOP-8 or TSSOP-8 footprints to a
300-mil DIP-8 footprint.
2.4.7
2.4.7.1
Evaluating a Voltage Supervisor or Voltage Detector Device
VOLTAGE SUPERVISORS
The following voltage supervisor is supported by this evaluation board.
TABLE 2-3:
8-PIN VOLTAGE SUPERVISOR
Device
TC1232
SOIC
Yes
DIP
Yes
MSOP
—
TSSOP
—
Comment
2.4.7.2
TESTING THE VOLTAGE SUPERVISORS TRIP POINT OPERATION
When evaluating a voltage supervisor/voltage detector device, a minimum set of test
equipment should be available. Table 2-4 shows the recommended test equipment.
TABLE 2-4:
TEST EQUIPMENT
Hardware
Variable Power
Supply
Arbitrary Waveform
Generator
Digital Multi-Meter
(D.M.M.)
Oscilloscope
Test Light (LED)
Connect to:
V DD , V SS
V DD , V SS
V OUT (1)
V OUT (1)
V OUT (1)
Comment
This allows the voltage to the SOT23 Evaluation Board
to be varied so the device output can be monitored.
This is similar to a variable power supply, but allows pro-
grammability into the input signal that the device will be
subjected to. This also allows a particular waveform to
be repeated (such as a 60 Hz sine wave that varies from
1V to 5V).
Used to indicate the output state (low or high) of the
voltage supervisor/voltage detector.
Allows the device conditions and response to be evalu-
ated due to the ability to capture this information. This is
useful for faster signals and cases where small spikes
need to be detected.
Used to visually indicate the output state (low or high) of
the voltage supervisor/voltage detector. Ensure that the
current requirements of this LED can be supplied by the
device’s output pin.
Note 1:
? 2005 Microchip Technology Inc.
The pad connection to connect to the V OUT or RST pin will be dependent on the
device and the footprint option used.
DS51544A-page 15
相关PDF资料 |
PDF描述 |
|---|---|
| PGD050S030CSF01 | SUPPRESSOR ESD ARRAY 50PIN DSUB |
| PGFI-22011 | CORD GFCI LOCKPLUGS 20A 240VAC |
| PGFI-23111 | CORD GFCI 30A 240VAC 2' YEL |
| PGFI-831AN | CABLE GFCI AUTO 30A 208VAC 2' |
| PGFI-A040KYTT25 | CORD GFCI 120VAC 25' YEL TRITAP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PG164120 | 功能描述:程序设计器 - 基于处理器 PICkit2 Microcon- troller Programmer RoHS:否 制造商:Olimex Ltd. 产品:Programmers 工具用于评估:XMEGA, MegaAVR, tinyAVR 核心:AVR 接口类型:USB 工作电源电压:1.8 V to 5.5 V |
| PG164120 | 制造商:Microchip Technology Inc 功能描述:DEVELOPMENT PROGRAMMER ((NW)) |
| PG164120 | 制造商:Microchip Technology Inc 功能描述:MICROCONTROLLER PROGRAMMER ((NW)) |
| PG164130 | 功能描述:电路内置调试器 PICkit 3 In-Circuit Debugger RoHS:否 制造商:Microchip Technology 产品:In-Circuit Debugger Kits 工具用于评估:PIC MCUs, dsPIC DSCs 用于:07-00024, AC164113 核心:dsPIC, PIC 接口类型:USB 工作电源电压:3 V to 5 V |
| PG164130 | 制造商:Microchip Technology Inc 功能描述:PICkit 3 In-Circuit Debugger Only |
发布紧急采购，3分钟左右您将得到回复。