参数资料
型号: PSC159-2
厂商: Power-One
文件页数: 10/17页
文件大小: 0K
描述: SWITCHING REGULATOR 135W 15V
标准包装: 1
系列: *

PSC, PSL Series Data Sheet
?
Output Protection and Short Circuit Behaviour
A voltage suppressor diode, which in worst case conditions
fails into a short circuit (or a thyristor crowbar, option C),
protects the output against an internally generated over-
voltage. Such an overvoltage could occur due to a failure of
either the control circuit or the switching transistor. The
V o / V o nom
05033a
Positive Switching Regulators
output protection is not designed to withstand externally
applied overvoltages.
A constant current limitation circuit holds the output current
almost constant, when an overload or a short circuit is applied
to the output. It acts self-protecting and recovers automatically
after removal of the overload or short circuit condition.
Parallel and Series Connection
Outputs of equal nominal voltages can be parallel-connected.
1.0
0.8
0.6
0.4
0.2
I o nom
I o L
However, the use of a single regulator with higher output
power, is always the better solution.
In parallel-connected operation, one or several outputs may
operate continuously at their current limit knee-point which will
cause an increase of the heat generation. Consequently, the
max. ambient temperature should be reduced by 10 K.
0
0.2
0.4
0.6
0.8
1.0
1.2 I o / I o nom
Outputs can be series-connected with any other regulator. In
series-connection the maximum output current is limited by
Fig. 6
Overload, short-circuit behaviour V o versus I o .
Auxiliary Functions
the lowest current limitation, but electrically separated source
voltages are needed for each regulator.
I inh [mA]
i Inhibit (Remote On / Off)
5
06034a
4
The inhibit input allows the switching regulator output to be
disabled via a control signal. In systems with several
3
converters, this feature can be used, for example, to control
the activation sequence of the converters by a logic signal
(TTL, C-MOS, etc.). An output voltage overshoot will not
2
1
Output on
Output off
occur, when switching on or off.
Note: With open i-input, the output is enabled.
0
–40
–20
0
20
40
V
V inh
Fig. 7
Typical inhibit current I inh versus inhibit voltage V inh
Table 5: Inhibit characteristics
Characteristics
Conditions
min typ max Unit
06009a
V o = off
V inh Inhibit input voltage V o = on V i min – V i max
T C min – T C max
–50
+2.4
+0.8
+50
V
Vi+
Vo+
i
I inh
t r
t f
Switch-on time
Switch-off time
V i = V i nom
R L = V o nom / I o nom
130
25
ms
Gi–
Go–
V inh
I i inh Input current when inhibited V i = V i nom
25
mA
Fig. 8
Definition of I inh and V inh
BCD20027-G Rev AA, 18-May-2011
Page 10 of 17
www.power-one.com
相关PDF资料
PDF描述
HR25-9TR-12SC CONN RECEPT 12POS FMALE CRIMP
HR25-9P-20SC CONN PLUG 20POS FEMALE CRIMP
HR25-9P-16SC CONN PLUG 16POS FEMALE CRIMP
HR25-9P-12SC CONN PLUG 12POS FEMALE CRIMP
OSTHW205052 TERMINAL BLOCK PLUG 5.08MM 20POS
相关代理商/技术参数
参数描述
PSC159-2IR 制造商:Power-One 功能描述:
PSC-15A-050 功能描述:插入式交流适配器 U 552-PSC-15A-050S 15W 5VDC WALL ADAPT RoHS:否 制造商:Phihong 地区:Universal 安装风格:Wall, Interchangeable Plug 输入电压范围:90 VAC to 264 VAC 输出端数量:1 输出功率额定值:5 W 输出电压(通道 1):5 V 输出电流(通道 1):1 A 直流输出连接器:USB Type A 随附/必需的交流插头:Required 商用/医用:Commercial 效率:Level V
PSC15A-050 功能描述:5V 15W AC/DC External Wall Mount Adapter Fixed Blade Input 制造商:phihong usa 系列:PSC15A 零件状态:有效 使用地区:适用于北美地区 形式:壁式安装 输入类型:固定插片 电压 - 输入:90 ~ 264 VAC 电压 - 输出:5V 电流 - 输出(最大值):3A 功率(W):15W 空载功耗:100mW(最大) 极化:正极中心 应用:ITE(商业) 效率:VI 级 工作温度:0°C ~ 40°C 输出连接器:圆管插头,2.1mm 内径 x 5.5mm 外径 x 10.0mm 大小/尺寸:2.81" 长 x 1.97" 宽 x 1.23" 高(71.5mm x 50.0mm x 31.2mm) 认可:cULus 功率(W) - 最大值:15W 输入连接器:NEMA 1-15P 电线长度:59"(1.50m) 重量:0.32 磅(145.15g) 标准包装:1
PSC-15A-050S 功能描述:插入式交流适配器 15W 5VDC WALL ADAPT RoHS:否 制造商:Phihong 地区:Universal 安装风格:Wall, Interchangeable Plug 输入电压范围:90 VAC to 264 VAC 输出端数量:1 输出功率额定值:5 W 输出电压(通道 1):5 V 输出电流(通道 1):1 A 直流输出连接器:USB Type A 随附/必需的交流插头:Required 商用/医用:Commercial 效率:Level V
PSC15A-050S 制造商:PHIHONG 制造商全称:PHIHONG 功能描述:15 Watt - Low Cost Linear Eliminator