参数资料
型号: PT534-6B
厂商: Everlight Electronics Co Ltd
文件页数: 9/9页
文件大小: 0K
描述: PHOTOTRANSISTOR 5MM BLACK RAD
标准包装: 500
电压 - 集电极发射极击穿(最大): 30V
电流 - 集电极 (Ic)(最大): 20mA
电流 - 暗 (Id)(最大): 100nA
波长: 980nm
安装类型: 通孔
方向: 顶视图
封装/外壳: 径向,5mm 直径(T 1 3/4)
其它名称: 1080-1160
DATASHEET
5mm Silicon Phototransistor
PT534-6B
?
?
?
After soldering the LEDs, the epoxy bulb should be protected from mechanical shock or vibration until the LEDs return to
room temperature.
A rapid-rate process is not recommended for cooling the LEDs down from the peak temperature.
Although the recommended soldering conditions are specified in the above table, dip or hand soldering at the lowest
possible temperature is desirable for the LEDs.
Wave soldering parameter must be set and maintain according to recommended temperature and dwell time in the solder
wave.
4.
Cleaning
?
?
When necessary, cleaning should occur only with isopropyl alcohol at room temperature for a duration of no more than
one minute. Dry at room temperature before use.
Do not clean the LEDs by the ultrasonic. When it is absolutely necessary, the influence of ultrasonic cleaning on the LEDs
depends on factors such as ultrasonic power and the assembled condition. Ultrasonic cleaning shall be pre-qualified to
ensure this will not cause damage to the LED
5.
Heat Management
?
?
Heat management of LEDs must be taken into consideration during the design stage of LED application. The current
should be de-rated appropriately by referring to the de-rating curve found in each product specification.
The temperature surrounding the LED in the application should be controlled. Please refer to the data sheet de-rating
curve.
6.
ESD (Electrostatic Discharge)
?
?
?
?
Electrostatic discharge (ESD) or surge current (EOS) can damage LEDs.
An ESD wrist strap, ESD shoe strap or antistatic gloves must be worn whenever handling LEDs.
All devices, equipment and machinery must be properly grounded.
Use ion blower to neutralize the static charge which might have built up on surface of the LEDs plastic lens as a result of
friction between LEDs during storage and handing.
7.
Other
?
?
?
Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above
specification.
When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these
specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does
not comply
with the absolute maximum ratings and the instructions included in these specification sheets.
These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t
reproduce or cause anyone to reproduce them without EVERLIGHT’s consent.
9
www.everlight.com
:3
Revision Copyright ?
LifecyclePhase:
No: Release
2010, Everlight All Rights Reserved. Release Date : May.28.2013. Issue DPT-0000049 Date:2013-06-04 10:05:52.0
Expired Period: Forever
相关PDF资料
PDF描述
PT5529B/L2-F PHOTOTRANSISTOR SIDE BLACK RAD
PT5529B/L2/H2-F PHOTOTRANSISTOR SIDE BLACK RAD
PT67-21B/C14/TR8 PHOTOTRANSISTOR TOP NPN BK SMD
PT67-21C/L41/TR8 PHOTOTRANSISTOR TOP NPN CLR SMD
PT908-7B-F PHOTOTRANSISTOR 1.5MM SIDE BLACK
相关代理商/技术参数
参数描述
PT5362-BKSP 制造商:Pass & Seymour/Legrand 功能描述:PT SPD RECP 20A/125V ALARM BK
PT539-1 功能描述:固定电感器 220NETICS - ADSL RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm
PT539-1L 制造商:Bourns / JW Miller 功能描述:Telecom Transformer 1:1 1500Vrms 3Ohm Prim. DCR 3Ohm Sec. DCR <0.5dB Through Hole 制造商:Bourns Inc 功能描述:RF TX 3OHM PRIM. DCR 5000UH PRIM. INDUCTANCE 3OHM SEC. DCR 5 - Bulk 制造商:Bourns Inc 功能描述:Telecom Transformer 1:1 1500Vrms 3Ohm Prim. DCR 3Ohm Sec. DCR <0.5dB Through Hole
PT53WX42F-SM 制造商:Panasonic Industrial Company 功能描述:PANASONIC SERVICE MANUAL
PT5401 制造商:TI 制造商全称:Texas Instruments 功能描述:6-A 5-V/3.3-V Input Adjustable SWIFT Power Module