参数资料
型号: PT6511R
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14
封装: SIP-14
文件页数: 10/11页
文件大小: 222K
代理商: PT6511R
Application Notes
For technical support and further information, visit http://power.ti.com
PT6510 Series
Using the Standby Function of the PT6510
Series of Integrated Switching Regulators
The PT6510 series of power modules incorporate a
Standby function. This may be used in applications that
require power-up/shutdown sequencing, and wherever
there is a requirement for the output status of the mod-
ule to be controlled by external circuitry.
The standby function is provided by the STBY* control,
pin 3. If pin 3 is left open-circuit 1 the regulator operates
normally, and provides a regulated output whenever a
valid supply voltage is present at applied to Vin (pins 4-6)
with respect to GND (pins 7–10). Applying a ground
signal to pin 3 disables the regulator’s output and reduces
the input current to about 1 mA 4. The standby control
may also be used to hold off the regulator output during
the period that input power is applied.
Pin 3 is ideally controlled with an open-drain discrete
transistor 1 (See Figure 3-1). It may also be driven directly
from a dedicated TTL 3 compatible gate. Table 3-1 gives
the circuit parameters for the control of this input.
Table 3-1 Standby Control Requirements (2)
Parameter
Min
Typ
Max
Input Low (VIL)
–0.1 V
0.4 V
Input High (VIH)
2 V
Vin
Input Low Current (IIL)
–0.4 mA
Notes:
1 The standby control input is ideally controlled using an
open-drain discrete transistor. An external pull-up resistor
is not necessary. The open-circuit voltage of the STBY*
pin is the input voltage, Vin.
2. To ensure the regulator output is disabled, the control pin
must be pulled to less than 0.4 Vdc with a low-level
0.5-mA sink to ground.
3. The STBY* input is also compatible with a differential
output from standard TTL logic, providing the IC
shares the same supply voltage as the module.
4. When the regulator output is disabled the current drawn
from the input source is typically reduced to about 1 mA.
Figure 3-1
Turn-On Time:
In the circuit of Figure 3-1, turning Q1 on
applies a low voltage to the STBY control (pin 3) and
disables the regulator ouput. Correspondingly, turning
Q1 off removes the low-voltage signal and enables the
output. Once enabled, the output will typically experience
a 10–15 ms delay followed by a predictable ramp-up of
voltage. The regulator should provide a fully regulated
output voltage within 40 ms. The waveform of Figure 3-2
shows the output voltage and input current waveforms of
a PT6511 (3.3 V) following the turn-off of Q1. The turn
off of Q1 corresponds to the rise in Vstby. The waveforms
were measured with a 5 Vdc input voltage, and 4.5 A
resistive load.
Figure 3-2
Vstby (2 V/Div)
Vo (1 V/Div)
HORIZ SCALE: 2 ms/Div
Inhibit
V
in
V
o
COM
PT6511
11–13
14
7–10
4,5,6
Vin
Vo
GND
Vo Adj
STBY
3
Vo (Sns)
1
Q1
BSS138
V
in
C
IN
C
OUT
相关PDF资料
PDF描述
PT6515A 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14
PT6512G 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14
PT6513B 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14
PT6511H 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14
PT6515H 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14
相关代理商/技术参数
参数描述
PT6512 制造商:TI 制造商全称:Texas Instruments 功能描述:8-A 5-V/3.3-V Input Adjustable ISR with Short-Circuit protection
PT65121 功能描述:旋钮开关 CODE 21 DECIMAL 4P RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver
PT65-121 制造商:APEM 功能描述:SWITCH DECIMAL 4 POS 制造商:APEM 功能描述:SWITCH, DECIMAL, 4 POS 制造商:APEM 功能描述:SWITCHES, ROTARY DIP, 4, SCREWDRIVER SLOT; No. of Switch Positions:4; Actuator Style:Screwdriver Slot; Pitch Spacing:2.54mm; Contact Current DC Max:400mA; Switch Mounting:Through Hole; Series:PT65 ;RoHS Compliant: Yes
PT65-121 制造商:APEM 功能描述:SWITCH DECIMAL 4 POS
PT65121L254 功能描述:编码式波段开关 4POS R/A .1in Rotary Switch RoHS:否 制造商:C&K Components 位置数量:10 输出代码:Binary Coded Decimal 执行器:Screwdriver 触点额定值: 端接类型:Solder Pin 封装:Tube