- 您现在的位置：买卖IC网 > PDF目录69176 > PT6511R (TEXAS INSTRUMENTS INC) 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 PDF资料下载
参数资料
| 型号： | PT6511R |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
| 封装： | SIP-14 |
| 文件页数： | 11/11页 |
| 文件大小： | 222K |
| 代理商： | PT6511R |
Application Notes
For technical support or further information, visit http://power.ti.com
PT6510 Series
Adjusting the Output Voltage of the
PT6510 5V/3.3V Bus Converters
The output voltage of the PT6510 series switching regula-
tors may be adjusted higher or lower than the factory
trimmed pre-set voltage with the addition of a single
external resistor. Table 4-1 gives the allowable adjust-
ment range for each model in the series as Va (min) and
Va (max).
Adjust Up:
An increase in the output voltage is obtained
by adding a resistor R2, between Vo Adjust (pin 14) and
GND (pins 7-10).
Adjust Down:
Add a resistor (R1), between Vo Adjust
(pin 14) and Vout (pins 11-13).
Refer to Figure 4-1 and Table 4-2 for both the placement and
value of the required resistor, either (R1) or R2 as appropriate.
Notes:
1. Use only a single 1 % resistor in either the (R1) or R2
location. Place the resistor as close to the ISR as
possible.
2. Never connect capacitors from Vo Adjust to either
GND, Vout, or the Vo Sense pin. Any capacitance
added to the Vo Adjust pin will affect the stability of
the ISR.
3. If the remote sense feature is used, connecting the
resistor (R1) between Vo Adjust (pin 14) and Vo Sense
(pin 1) can benefit load regulation.
4. The minimum input voltage required by the part is
Vout + 1.2 or Vin(min) from Table 4-1, whichever is
higher.
Figure 4-1
The values of (R
1) [adjust down], and R2 [adjust up], can
also be calculated using the following formulae.
Ro (Va – 1.0)
(R1)
=
(Vo – Va)
– Rs k
Ro
– Rs
k
R2
=
Va - Vo
Where: Vo = Original output voltage
Va = Adjusted output voltage
Ro = The resistance value in Table 4-1
Rs = The series resistance from Table 4-1
Table 4-1
PT6510 ADJUSTMENT AND FORMULA PARAMETERS
Series Pt #
PT6515
PT6512
PT6516
PT6513
PT6511
PT6514
Vo (nom)
1.2
1.5
1.8
2.5
3.3
3.6
Va (min)
1.14
1.27
1.4
1.8
2.25
2.5
Va (max)
2.35
2.65
2.95
3.5
4.2
4.3
Ro (k
)
2.49
4.99
12.1
10
Rs (k
)
2
4.22
12.1
Vin(min)
3.1
4.5
C
in
+
C
out
+
(R1)
Adj Down
R2
Adjust Up
V
out
COM
Vin
COM
PT6510
11–13
14
7–10
4–6
V
in
V
out
GND
V
o(adj)
STBY
3
V
o(Sense)
1
L
O
A
D
相关PDF资料 |
PDF描述 |
|---|---|
| PT6515A | 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
| PT6512G | 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
| PT6513B | 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
| PT6511H | 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 |
| PT6515H | 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PT6512 | 制造商:TI 制造商全称:Texas Instruments 功能描述:8-A 5-V/3.3-V Input Adjustable ISR with Short-Circuit protection |
| PT65121 | 功能描述:旋钮开关 CODE 21 DECIMAL 4P RoHS:否 制造商:C&K Components 位置数量:5 卡片组数量: 每卡片组极数:2 电流额定值:250 mA 电压额定值:125 V 指数角: 触点类型: 触点形式:DPST 端接类型:Solder 安装类型:Panel 触点电镀:Silver |
| PT65-121 | 制造商:APEM 功能描述:SWITCH DECIMAL 4 POS 制造商:APEM 功能描述:SWITCH, DECIMAL, 4 POS 制造商:APEM 功能描述:SWITCHES, ROTARY DIP, 4, SCREWDRIVER SLOT; No. of Switch Positions:4; Actuator Style:Screwdriver Slot; Pitch Spacing:2.54mm; Contact Current DC Max:400mA; Switch Mounting:Through Hole; Series:PT65 ;RoHS Compliant: Yes |
| PT65-121 | 制造商:APEM 功能描述:SWITCH DECIMAL 4 POS |
| PT65121L254 | 功能描述:编码式波段开关 4POS R/A .1in Rotary Switch RoHS:否 制造商:C&K Components 位置数量:10 输出代码:Binary Coded Decimal 执行器:Screwdriver 触点额定值: 端接类型:Solder Pin 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。