- 您现在的位置：买卖IC网 > PDF目录18865 > PTFL04BC471Q2N34B0 (Murata Electronics North America)THERMISTOR PDF资料下载
参数资料
| 型号： | PTFL04BC471Q2N34B0 |
| 厂商： | Murata Electronics North America |
| 文件页数： | 88/105页 |
| 文件大小： | 0K |
| 描述： | THERMISTOR |
| 标准包装： | 100 |
| 系列： | Posistor® |
| 在 25°C 时的电阻（欧姆）： | 470 |
| 工作温度： | -10°C ~ 120°C |
| 安装类型： | 通孔 |
| 封装/外壳： | 圆盘形，5.0mm 直径 x 4.0mm W |
| 供应商设备封装： | * |
| 包装： | 散装 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页当前第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页
! Note ? Please read rating and ! CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
? This catalog has only typical speci?cations. Therefore, please approve our product speci?cations or transact the approval sheet for product speci?cations before ordering.
Temperature Sensor Lead Type Speci?cations and Test Methods
R90E.pdf
Mar.4,2014
No.
1
Item
Resistance Value
Rating Value
Satisfies specification
Method of Examination
Resistance value is measured by applying voltage under 1.5Vdc
(by a direct current of less than 10mA) in a silicone oil vessel.
We apply AC voltage 120% that of the maximum voltage to
POSISTOR r by raising voltage gradually for 180±5 seconds at
2
Withstanding Voltage
No problem
25°C. (A protective resistor is to be connected in series, and the
inrush current through POSISTOR r must be limited below max.
rated value.)
3
Tensile Strength of
Lead Wire Terminal
No damage
The load is gradually applied to each terminal of POSISTOR r
until 9.80N in the axial-direction with fixing POSISTOR r 's body
itself and this load is kept for 10 seconds.
POSISTOR r is held so that it is perpendicular to the lead wire
with the following load hanging in the axial direction of the lead
wire. The lead wire is slowly bent to 90° and returned; then it is
4
Bending Strength of
Lead Wire Terminal
Lead wire does not come off.
slowly bent in the opposite direction and returned to original state.
(Above mentioned procedure is done slowly with one cycle.)
Series
Force
PTFL
2.45N
PTFM
4.90N
The lead wire of POSISTOR r is soaked in a Isopropyl Alcohol
Solder is applied around the lead wire covering
(JIS K 8839) or ethanol (JIS K 8101) solution (about 25wt%) of
5
Solderability
3/4 or more of the circumference without gap in
the axial-direction.
colophony (JIS K 5902) for 5-10 sec. And, each lead wire is
soaked in molten solder (JIS Z 3282 H60A) at 235±5°C from the
bottom to a point of 2.0-2.5mm for 2±0.5 seconds.
The lead wire of POSISTOR r is soaked in molten solder (JIS Z
6
Terminal Durability of
Soldering
Δ R/R25 VT 15%
3282 H60A) at 350±10°C from the bottom to a point of 2.0-2.5
mm for 3.5±0.5 seconds. And, after the device is left at room
temperature (25°C) for 24±4 hours, the resistance is measured.
POSISTOR r is set in an environmental chamber at 40±2°C
7
Damp Heat
Δ R/R25 VT 20%
and 90-95% humidity for 500±4 hours.
And after the device is left at room temperature (25°C) for one
hour, the resistance measurement is performed.
Δ R/R25 VT 20%
PTH
POSISTOR r is set in an environmental chamber at 85±3°C with
maximum voltage applied for 1.5 hours and then is left without
voltage applied for 0.5 hours.
This cycle is repeated for 1000±10 hours, and after the device is
8
High Temperature Load
Rs
left at room temperature (25°C) for one hour, the resistance
measurement is performed.
(A protective resistor is to be connected in series and the inrush
14
86
S.W
Test circuit
current through POSISTOR r must be limited below max. rated
value.)
相关PDF资料 |
PDF描述 |
|---|---|
| PTFL04BC222Q2N34B0 | THERMISTOR |
| PTFL04BB471Q2N34B0 | THERMISTOR |
| PTFL04BB222Q2N51B0 | THERMISTOR |
| PTFL04BB222Q2N34B0 | THERMISTOR |
| PTFL04BD222Q2N51A0 | THERMISTOR |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PTFL04BD222Q2N34B0 | 功能描述:热敏电阻 - PTC 2200ohm PTC Thermistor RoHS:否 制造商:Vishay 电阻:1.5 kOhms 容差:1 % 端接类型:Radial 系列:TFPTL 工作温度范围:- 55 C to + 70 C |
| PTFL04BD222Q2N51A0 | 功能描述:热敏电阻 - PTC 2200ohm PTC Thermistor RoHS:否 制造商:Vishay 电阻:1.5 kOhms 容差:1 % 端接类型:Radial 系列:TFPTL 工作温度范围:- 55 C to + 70 C |
| PTFL04BD471Q2N34B0 | 功能描述:热敏电阻 - PTC 470ohm PTC Thermistor RoHS:否 制造商:Vishay 电阻:1.5 kOhms 容差:1 % 端接类型:Radial 系列:TFPTL 工作温度范围:- 55 C to + 70 C |
| PTFL04BE222Q2N34B0 | 功能描述:热敏电阻 - PTC 2200ohm PTC Thermistor RoHS:否 制造商:Vishay 电阻:1.5 kOhms 容差:1 % 端接类型:Radial 系列:TFPTL 工作温度范围:- 55 C to + 70 C |
| PTFL04BE471Q2N34B0 | 功能描述:热敏电阻 - PTC 470ohm PTC Thermistor RoHS:否 制造商:Vishay 电阻:1.5 kOhms 容差:1 % 端接类型:Radial 系列:TFPTL 工作温度范围:- 55 C to + 70 C |
发布紧急采购，3分钟左右您将得到回复。