- 您现在的位置：买卖IC网 > PDF目录98066 > PTN78060WAH (TEXAS INSTRUMENTS INC) 5.5 A SWITCHING REGULATOR, 660 kHz SWITCHING FREQ-MAX, DMA10 PDF资料下载
参数资料
| 型号： | PTN78060WAH |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 5.5 A SWITCHING REGULATOR, 660 kHz SWITCHING FREQ-MAX, DMA10 |
| 文件页数： | 13/24页 |
| 文件大小： | 1871K |
| 代理商： | PTN78060WAH |
www.ti.com
π Filters
GND
C5
7
4
5
6
2
3
GND
Inhibit
1
Sense
Adjust
VI
VO
C1
1 F
m
50 V
Ceramic
C2*
2.2 mF
50 V
Ceramic
(Required)
L1
1 - 5 mH
L2
1 - 5 mH
VI
VO
PTN78060W
RSET
C3
#
100 mF
(Optional)
C4
1 mF
Ceramic
Recommended whenever I is greater than 2 A.
O
# See
section for suggested value and type.
Application Information
* See specifications for required value and type. For PTN78060H, C2 is equal to 3 x 4.7 F.
m
10
15
20
25
30
35
40
45
0
0.5
1
1.5
2
2.5
3
1 MHz
600 kHz
Attenuation
dB
Load Current A
PTN78060W, PTN78060H
SLTS229A – NOVEMBER 2004 – REVISED APRIL 2005
If a further reduction in ripple/noise level is required for an application, higher order filters must be used. A
π (pi)
filter, employing a ferrite bead (Fair-Rite part number 2673000701 or equivalent) in series with the input or output
terminals of the regulator reduces the ripple/noise by at least 20 db (see Figure 33 and Figure 34). In order for
the inductor to be effective ceramic capacitors are also required. (Note: see Capacitor Recommendations for
additional information on vendors and component suggestions.)
These inductors plus ceramic capacitors form an excellent filter because of the rejection at the switching
frequency (650 kHz - 1 MHz). The placement of this filter is critical. It must be located as close as possible to the
input or output pins to be effective. The ferrite bead is small (12,5 mm
× 3 mm), easy to use, low cost, and has
low dc resistance. Fair-Rite also manufactures a surface-mount bead (part number 2773021447). It is rated to 5
A, and can be used on the output bus. As an alternative, suitably rated 1-H to 5-H wound inductors can be
used in place of the ferrite inductor bead.
Figure 33. Adding
π Filters (I
O ≤ 3 A)
Figure 34.
π-Filter Attenuation vs. Load Current
20
相关PDF资料 |
PDF描述 |
|---|---|
| PTQB425080P2AD | 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE |
| PTQB425080N3AD | 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE |
| PTR08060WVD | 6 A SWITCHING REGULATOR, 300 kHz SWITCHING FREQ-MAX, PSIP5 |
| PTR08100WVD | 10 A SWITCHING REGULATOR, 300 kHz SWITCHING FREQ-MAX, PSIP5 |
| PTV03020WAH | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PTN78060WAH | 制造商:Texas Instruments 功能描述:IC SWITCHING REG 3A ADJ 8060 制造商:Texas Instruments 功能描述:IC, SWITCHING REG 3A ADJ, 8060 制造商:Texas Instruments 功能描述:IC, SWITCHING REG 3A ADJ, 8060; Primary Input Voltage:36V; No. of Outputs:1; Output Voltage:12.6V; Output Current:3A; Voltage Regulator Case Style:SIP Module; No. of Pins:7; Operating Temperature Min:-40C; Operating Temperature ;RoHS Compliant: Yes |
| PTN78060WAS | 功能描述:DC/DC转换器 3-A Wide-Input Adj Swtch Reg Mod RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PTN78060WAST | 功能描述:DC/DC转换器 3-A Wide-Input Adj Swtch Reg Mod RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PTN78060WAZ | 功能描述:DC/DC转换器 3-A Wide-Input Adj Swtch Reg Mod RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PTN78060WAZT | 功能描述:DC/DC转换器 3-A Wide-Input Adj Swtch Reg Mod RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
发布紧急采购，3分钟左右您将得到回复。