参数资料
型号: PTN78060WAH
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 5.5 A SWITCHING REGULATOR, 660 kHz SWITCHING FREQ-MAX, DMA10
文件页数: 6/24页
文件大小: 1871K
代理商: PTN78060WAH
www.ti.com
Tantalum Capacitors
Capacitor Table
Designing for Load Transients
PTN78060W, PTN78060H
SLTS229A – NOVEMBER 2004 – REVISED APRIL 2005
Tantalum-type capacitors may be used at the output, and are recommended for applications where the ambient
operating temperature can be less than 0
°C. The AVX TPS, Sprague 593D/594/595, and Kemet
T495/T510/T520 capacitors series are suggested over many other tantalum types due to their rated surge, power
dissipation, and ripple current capability. As a caution, many general-purpose tantalum capacitors have
considerably higher ESR, reduced power dissipation, and lower ripple current capability. These capacitors are
also less reliable as they have lower power dissipation and surge current ratings. Tantalum capacitors that do not
have a stated ESR or surge current rating are not recommended for power applications. When specifying
Os-Con and polymer tantalum capacitors for the output, the minimum ESR limit is encountered well before the
maximum capacitance value is reached.
The capacitor tables, Table 5 and Table 6, identify the characteristics of capacitors from a number of vendors
with acceptable ESR and ripple current (rms) ratings. The recommended number of capacitors required at both
the input and output buses is identified for each capacitor type. This is not an extensive capacitor list. Capacitors
from other vendors are available with comparable specifications. Those listed are for guidance. The rms rating
and ESR (at 100 kHz) are critical parameters necessary to ensure both optimum regulator performance and long
capacitor life.
The transient response of the dc/dc converter has been characterized using a load transient with a di/dt of
1 A/s. The typical voltage deviation for this load transient is given in the data sheet specification table using the
required value of output capacitance. As the di/dt of a transient is increased, the response of a converter's
regulation circuit ultimately depends on its output capacitor decoupling network. This is an inherent limitation of
any dc/dc converter once the speed of the transient exceeds its bandwidth capability. If the target application
specifies a higher di/dt or lower voltage deviation, the requirement can only be met with additional output
capacitor decoupling. In these cases, special attention must be paid to the type, value, and ESR of the
capacitors selected.
If the transient performance requirements exceed those specified in the data sheet, the selection of output
capacitors becomes more important. Review the minimum ESR in the characteristic data sheet for details on the
capacitance maximum.
Table 5. Recommended Input/Output Capacitors (PTN78060W)
CAPACITOR CHARACTERISTICS
QUANTITY
85
° C
CAPACITOR VENDOR/
EQUIVALENT
VENDOR
WORKING
MAXIMUM
PHYSICAL
COMPONENT
VALUE
SERIES
INPUT
OUTPUT
NUMBER
VOLTAGE
RIPPLE
SIZE
SERIES
(F)
RESISTANCE
BUS
(V)
CURRENT
(mm)
(ESR) (
)
(IRMS) (mA)
Panasonic FC( Radial)
50
180
0.119
850
10
× 16
1
EEUFC1H181
FK (SMD)
50
330
0.12
900
12.50
× 13.5
1 (1)
1
EEVFK1H331Q
United Chemi-Con PXA (SMD)
16
180
0.016
4360
8
× 12
≤1
PXA16VC180MF60
1 (1)
(VO < 14 V)
LXZ
50
120
0.16
620
10
× 12,5
1
LXZ50VB121M10X12LL
1(1)
(VI < 32 V)
MVY(SMD)
50
100
0.300
500
10
× 10
1
MVY50VC101M10X10TP
(VO ≤ 5.5 V)
Nichicon UWG (SMD)
50
100
0.300
500
10
× 10
1
UWG1H101MNR1GS
F550 (Tantalum)
10
100
0.055
2000
7,7
× 4,3
N/R (2)
≤ 3(3)
F551A107MN (VO ≤ 5 V)
HD
50
120
0.072
979
10
× 12,5
1
UHD1H151MHR
Sanyo Os-Con SVP (SMD)
20
100
0.024
2500
8
× 12
1 (1)
≤ 2
20SVP100M (VI ≤ 16 V)
SP
16
100
0.032
2890
10
× 5
1 (1)
≤ 2
16SP100M (VI ≤ 14 V)
(1)
The voltage rating of the input capacitor must be selected for the desired operating input voltage range of the regulator. To operate the
regulator at a higher input voltage, select a capacitor with the next higher voltage rating.
(2)
Not recommended (N/R). The voltage rating does not meet the minimum operating limits in most applications.
(3)
The maximum voltage rating of the capacitor must be selected for the desired set-point voltage (VO ). To operate at a higher output
voltage select a capacitor with a higher voltage rating.
14
相关PDF资料
PDF描述
PTQB425080P2AD 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE
PTQB425080N3AD 1-OUTPUT 200 W DC-DC REG PWR SUPPLY MODULE
PTR08060WVD 6 A SWITCHING REGULATOR, 300 kHz SWITCHING FREQ-MAX, PSIP5
PTR08100WVD 10 A SWITCHING REGULATOR, 300 kHz SWITCHING FREQ-MAX, PSIP5
PTV03020WAH 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
PTN78060WAH 制造商:Texas Instruments 功能描述:IC SWITCHING REG 3A ADJ 8060 制造商:Texas Instruments 功能描述:IC, SWITCHING REG 3A ADJ, 8060 制造商:Texas Instruments 功能描述:IC, SWITCHING REG 3A ADJ, 8060; Primary Input Voltage:36V; No. of Outputs:1; Output Voltage:12.6V; Output Current:3A; Voltage Regulator Case Style:SIP Module; No. of Pins:7; Operating Temperature Min:-40C; Operating Temperature ;RoHS Compliant: Yes
PTN78060WAS 功能描述:DC/DC转换器 3-A Wide-Input Adj Swtch Reg Mod RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
PTN78060WAST 功能描述:DC/DC转换器 3-A Wide-Input Adj Swtch Reg Mod RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
PTN78060WAZ 功能描述:DC/DC转换器 3-A Wide-Input Adj Swtch Reg Mod RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
PTN78060WAZT 功能描述:DC/DC转换器 3-A Wide-Input Adj Swtch Reg Mod RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸: