- 您现在的位置：买卖IC网 > PDF目录4509 > R1EX25002ATA00A#S0 (Renesas Electronics America)IC EEPROM 2K 5MHZ 8TSSOP PDF资料下载
参数资料
| 型号： | R1EX25002ATA00A#S0 |
| 厂商： | Renesas Electronics America |
| 文件页数： | 10/24页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 2K 5MHZ 8TSSOP |
| 标准包装： | 1 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 2K (256 x 8) |
| 速度： | 3MHz，5MHz |
| 接口： | SPI 串行 |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 标准包装 |
| 其它名称： | R1EX25002ATA00A#S0DKR |
R1EX25002Axx00A/R1EX25004Axx00A
Pin Function
Serial data output (Q)
This output signal is used to transfer data serially out of the device. Data is shifted out on the falling edge of serial
clock (C).
Serial data input (D)
This input signal is used to transfer data serially into the device. It receives instructions, addresses, and the data to be
written. Values are latched on the rising edge of serial clock (C).
Serial clock (C)
This input signal provides the timing of the serial interface. Instructions, addresses, or data present at serial data input
(D) are latched on the rising edge of serial clock (C). Data on serial data output (Q) changes after the falling edge of
serial clock (C).
Chip select ( S )
When this input signal is high, the device is deselected and serial data output (Q) is at high impedance. Unless an
internal write cycle is in progress, the device will be in the standby mode. Driving chip select ( S ) low enables the
device, placing it in the active power mode. After power-up, a falling edge on chip select ( S ) is required prior to the
start of any instruction.
Hold ( HOLD )
The hold ( HOLD ) signal is used to pause any serial communications with the device without deselecting the device.
During the hold condition, the serial data output (Q) is high impedance, and serial data input (D) and serial clock (C)
are don’t care. To start the hold condition, the device must be selected, with chip select ( S ) driven low.
Write protect ( W )
This input signal is used to protect the memory against write instructions. When write protect ( W ) is held low, write
instructions (WRSR, WRITE) are ignored. No action on this signal can interrupt a write cycle that has already started.
REJ03C0357-0002 Rev. 0.02 Jan.14 .2009
page 8 of 20
相关PDF资料 |
PDF描述 |
|---|---|
| EP4CGX15BF14C6N | IC CYCLONE IV FPGA 15K 169 FBGA |
| A3P400-1PQG208 | IC FPGA 1KB FLASH 400K 208-PQFP |
| M1A3P400-1PQG208 | IC FPGA 1KB FLASH 400K 208-PQFP |
| R1EX24008ATAS0A#S0 | IC EEPROM 8K 400KHZ 8TSSOP |
| M1A3P400-1PQ208 | IC FPGA 1KB FLASH 400K 208-PQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| R1EX25002ATA00G | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:Serial Peripheral Interface 2k EEPROM 4k EEPROM |
| R1EX25002ATA00I | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:Serial Peripheral Interface Electrically Erasable and Programmable Read Only Memory |
| R1EX25002ATA00I#S0 | 制造商:Renesas Electronics Corporation 功能描述:SERIAL EEPROM 2K, SPI, TSSOP8, 制造商:Renesas Electronics Corporation 功能描述:SERIAL EEPROM 2K, SPI, TSSOP8, I-GRADE - Tape and Reel 制造商:Renesas Electronics Corporation 功能描述:IC EEPROM 2KBIT 5MHZ 8TSSOP |
| R1EX25004ASA00A | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:Serial Peripheral Interface Electrically Erasable and Programmable Read Only Memory |
| R1EX25004ASA00A#S0 | 功能描述:IC EEPROM 4K 5MHZ 8SOP RoHS:是 类别:集成电路 (IC) >> 存储器 系列:- 标准包装:1 系列:- 格式 - 存储器:闪存 存储器类型:闪存 - NAND 存储容量:4G（256M x 16） 速度:- 接口:并联 电源电压:2.7 V ~ 3.6 V 工作温度:0°C ~ 70°C 封装/外壳:48-TFSOP（0.724"，18.40mm 宽） 供应商设备封装:48-TSOP I 包装:Digi-Reel® 其它名称:557-1461-6 |
发布紧急采购，3分钟左右您将得到回复。