- 您现在的位置：买卖IC网 > PDF目录69314 > R5F64114NFB 32-BIT, FLASH, 50 MHz, MICROCONTROLLER, PQFP100 PDF资料下载
参数资料
| 型号： | R5F64114NFB |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 32-BIT, FLASH, 50 MHz, MICROCONTROLLER, PQFP100 |
| 封装： | 14 X 14 MM, 0.50 MM PITCH, PLASTIC, LQFP-100 |
| 文件页数： | 70/84页 |
| 文件大小： | 1206K |
| 代理商： | R5F64114NFB |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页当前第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页
ATmega48PA/88PA/168PA [DATASHEET]
9223F–AVR–04/14
86
15.6.1 Compare Output Mode and Waveform Generation
The waveform generator uses the COM0x1:0 bits differently in normal, CTC, and PWM modes. For all modes, setting the
COM0x1:0 = 0 tells the waveform generator that no action on the OC0x register is to be performed on the next compare
match. For compare output actions in the non-PWM modes refer to Table 15-2 on page 91. For fast PWM mode, refer to
Table 15-3 on page 92, and for phase correct PWM refer to Table 15-4 on page 92.
A change of the COM0x1:0 bits state will have effect at the first compare match after the bits are written. For non-PWM
modes, the action can be forced to have immediate effect by using the FOC0x strobe bits.
15.7
Modes of Operation
The mode of operation, i.e., the behavior of the Timer/Counter and the output compare pins, is defined by the combination of
the waveform generation mode (WGM02:0) and compare output mode (COM0x1:0) bits. The compare output mode bits do
not affect the counting sequence, while the waveform generation mode bits do. The COM0x1:0 bits control whether the
PWM output generated should be inverted or not (inverted or non-inverted PWM). For non-PWM modes the COM0x1:0 bits
control whether the output should be set, cleared, or toggled at a compare match
For detailed timing information refer to Section 15.8 “Timer/Counter Timing Diagrams” on page 90.
15.7.1 Normal Mode
The simplest mode of operation is the normal mode (WGM02:0 = 0). In this mode the counting direction is always up
(incrementing), and no counter clear is performed. The counter simply overruns when it passes its maximum 8-bit value
(TOP = 0xFF) and then restarts from the bottom (0x00). In normal operation the Timer/Counter overflow flag (TOV0) will be
set in the same timer clock cycle as the TCNT0 becomes zero. The TOV0 flag in this case behaves like a ninth bit, except
that it is only set, not cleared. However, combined with the timer overflow interrupt that automatically clears the TOV0 flag,
the timer resolution can be increased by software. There are no special cases to consider in the normal mode, a new counter
value can be written anytime.
The output compare unit can be used to generate interrupts at some given time. Using the output compare to generate
waveforms in normal mode is not recommended, since this will occupy too much of the CPU time.
15.7.2 Clear Timer on Compare Match (CTC) Mode
In clear timer on compare or CTC mode (WGM02:0 = 2), the OCR0A register is used to manipulate the counter resolution. In
CTC mode the counter is cleared to zero when the counter value (TCNT0) matches the OCR0A. The OCR0A defines the top
value for the counter, hence also its resolution. This mode allows greater control of the compare match output frequency. It
also simplifies the operation of counting external events.
The timing diagram for the CTC mode is shown in Figure 15-5. The counter value (TCNT0) increases until a compare match
occurs between TCNT0 and OCR0A, and then counter (TCNT0) is cleared.
Figure 15-5. CTC Mode, Timing Diagram
12
TCNTn
(COMnA1:0 = 1)
OCn
(Toggle)
Period
3
OCnx Interrupt Flag Set
4
相关PDF资料 |
PDF描述 |
|---|---|
| R5F64112DFB | 32-BIT, FLASH, 50 MHz, MICROCONTROLLER, PQFP100 |
| R5F64165PFD | 64-BIT, FLASH, MICROCONTROLLER, PQFP144 |
| R5F64168HNFB | 64-BIT, FLASH, MICROCONTROLLER, PQFP100 |
| R5F64168HDFB | 64-BIT, FLASH, MICROCONTROLLER, PQFP100 |
| R5F64168HPFB | 64-BIT, FLASH, MICROCONTROLLER, PQFP100 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| R5F64115DFB | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:RENESAS MCU |
| R5F64115DFB#U0 | 功能描述:MCU 384KB ROM 40KB RAM 100-LQFP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:M16C/R32C/100/111 产品培训模块:CAN Basics Part-1 CAN Basics Part-2 Electromagnetic Noise Reduction Techniques Part 1 M16C Product Overview Part 1 M16C Product Overview Part 2 标准包装:1 系列:M16C™ M32C/80/87 核心处理器:M32C/80 芯体尺寸:16/32-位 速度:32MHz 连通性:EBI/EMI，I²C，IEBus，IrDA，SIO，UART/USART 外围设备:DMA，POR，PWM，WDT 输入/输出数:121 程序存储器容量:384KB（384K x 8） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:24K x 8 电压 - 电源 (Vcc/Vdd):3 V ~ 5.5 V 数据转换器:A/D 34x10b，D/A 2x8b 振荡器型:内部 工作温度:-20°C ~ 85°C 封装/外壳:144-LQFP 包装:托盘 产品目录页面:749 (CN2011-ZH PDF) 配用:R0K330879S001BE-ND - KIT DEV RSK M32C/87 |
| R5F64115NFB | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:RENESAS MCU |
| R5F64116DFB | 制造商:RENESAS 制造商全称:Renesas Technology Corp 功能描述:RENESAS MCU |
| R5F64116DFB#U0 | 制造商:Renesas Electronics Corporation 功能描述:MCU 16-Bit R8C CISC 512KB Flash 3.3V/5V 100-Pin LQFP Tray 制造商:Renesas Electronics Corporation 功能描述:MCU 3/5V 512K I-TEMP PB-FREE 100-LQFP - Trays 制造商:Renesas Electronics Corporation 功能描述:MCU 16BIT 512KB FLASH 100LFQFP |
发布紧急采购，3分钟左右您将得到回复。