参数资料
型号: RDER72E683K3M1C11A
厂商: Murata Electronics North America
文件页数: 16/57页
文件大小: 0K
描述: CAP CER 0.068UF 250V 10% RADIAL
标准包装: 2,000
系列: RDE
电容: 0.068µF
电压 - 额定: 250V
容差: ±10%
温度系数: X7R
安装类型: 通孔
工作温度: -55°C ~ 125°C
应用: 通用
封装/外壳: 径向
尺寸/尺寸: 0.197" L x 0.124" W(5.00mm x 3.15mm)
高度 - 座高(最大): 0.248"(6.30mm)
引线间隔: 0.197"(5.00mm)
包装: 带盒(TB)
引线型: 纽结
! Note ? Please read rating and ! CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
? This catalog has only typical speci?cations. Therefore, please approve our product speci?cations or transact the approval sheet for product speci?cations before ordering.
C49E.pdf
Mar.12,2014
1
Temperature Compensating Type Speci?cations and Test Methods
No. AEC-Q200 Test Item
Specifications
AEC-Q200 Test Method
1
Pre-and Post-Stress
Electrical Test
High Temperature
The measured and observed characteristics should satisfy the
Exposure (Storage) specifications in the following table.
Appearance No defects or abnormalities
2
Capacitance
Change
Q
Within ±3% or ±0.3pF (Whichever is larger)
30pF V C: Q U 350
10pF V C < 30pF: Q U 275+5C/2
10pF G C: Q U 200+10C
Sit the capacitor for 1,000±12h at 150±3°C. Let sit for 24±2h at
room temperature, then measure.
C: Nominal Capacitance (pF)
I.R.
Temperature
Cycling
More than 1,000M Ω or 50M Ω · μF (Whichever is smaller)
The measured and observed characteristics should satisfy the
specifications in the following table.
Appearance No defects or abnormalities
Perform the 1,000 cycles according to the four heat treatments
Capacitance
Change
Within ±5% or ±0.5pF (Whichever is larger)
listed in the following table. Let sit for 24±2h at *room condition,
then measure.
3
Q
30pF V C: Q U 350
10pF V C < 30pF: Q U 275+5C/2
10pF G C: Q U 200+10C
Step 1 2 3 4
Temp. (°C) -55+0/-3 Room Temp. 125+3/-0 Room Temp.
Time (min.) 15±3 1 15±3 1
C: Nominal Capacitance (pF)
I.R.
1,000M Ω or 50M Ω · μF min. (Whichever is smaller)
Moisture
Resistance
The measured and observed characteristics should satisfy the
specifications in the following table.
Apply the 24h heat (25 to 65°C) and humidity (80 to 98%)
treatment shown below, 10 consecutive times.
Appearance No defects or abnormalities
Let sit for 24±2h at *room condition, then measure.
Humidity
Humidity Humidity Humidity
Humidity
Capacitance
Change
Within ±5% or ±0.5pF (Whichever is larger)
(°C)
70
65
90-98%
80-98% 90-98%
80-98%
90-98%
60
-2 °C
4
Q
30pF V C: Q U 200
30pF G C: Q U 100+10C/3
C: Nominal Capacitance (pF)
55
50
45
40
35
30
25
20
15
10
+10
Initial measurement
5
0
I.R.
500M Ω or 25M Ω · μF min. (Whichever is smaller)
-5
-10
One cycle = 24 hours
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Hours
Biased Humidity
The measured and observed characteristics should satisfy the
specifications in the following table.
Appearance No defects or abnormalities
5
Capacitance
Change
Q
Within ±5% or ±0.5pF (Whichever is larger)
30pF V C: Q U 200
30pF G C: Q U 100+10C/3
Apply the rated voltage and DC1.3+0.2/-0V (add 6.8k Ω resistor)
at 85±3°C and 80 to 85% humidity for 1,000±12h.
Remove and let sit for 24±2h at *room condition, then measure.
The charge/discharge current is less than 50mA.
C: Nominal Capacitance (pF)
I.R.
Operational Life
500M Ω or 25M Ω · μF min. (Whichever is smaller)
The measured and observed characteristics should satisfy the
specifications in the following table.
Appearance No defects or abnormalities
Apply the voltage shown in the table for 1,000±12h at 125±3°C.
Capacitance
Change
Within ±3% or ±0.3pF (Whichever is larger)
Let sit for 24±2h at *room condition, then measure.
The charge/discharge current is less than 50mA.
6
Q
30pF V C: Q U 350
10pF V C < 30pF: Q U 275+5C/2
10pF G C: Q U 200+10C
Rated Voltage
DC50V, DC100V
DC250V
DC630V, DC1kV
Test Voltage
200% of the rated voltage
150% of the rated voltage
120% of the rated voltage
C: Nominal Capacitance (pF)
I.R.
1,000M Ω or 50M Ω · μF min. (Whichever is smaller)
* “room condition” Temperature: 15 to 35°C, Relative humidity: 45 to 75%, Atmosphere pressure: 86 to 106kPa
Continued on the following page.
14
相关PDF资料
PDF描述
DG333ADW-T1-E3 IC SWITCH QUAD SPDT 20SOIC
RDER72E104K3M1C11A CAP CER 0.1UF 250V 10% RADIAL
DEHR33D272KB3B CAP CER 2700PF 2KV 10% RADIAL
RPER71H154K2S1C03A CAP CER 0.15UF 50V 10% RADIAL
RPER71H154K2M1C03A CAP CER 0.15UF 50V 10% RADIAL
相关代理商/技术参数
参数描述
RDER72H102K1K1H03B 功能描述:CAP CER 1000PF 500V X7R RADIAL 制造商:murata electronics north america 系列:RDE 包装:剪切带(CT) 零件状态:在售 电容:1000pF 容差:±10% 电压 - 额定:500V 温度系数:X7R 工作温度:-55°C ~ 125°C 特性:- 等级:- 应用:通用 故障率:- 安装类型:通孔 封装/外壳:径向 大小/尺寸:0.177" 长 x 0.124" 宽(4.50mm x 3.15mm) 高度 - 安装(最大值):0.197"(5.00mm) 厚度(最大值):- 引线间距:0.197"(5.00mm) 引线形式:成型引线 标准包装:500
RDER72H102K2K1C11B 功能描述:多层陶瓷电容器MLCC - 含引线 1000pF 500volt X7R +/-10% RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型:
RDER72H103K1K1H03B 功能描述:CAP CER 10000PF 50V X7R RADIAL 制造商:murata electronics north america 系列:RDE 包装:散装 零件状态:在售 电容:10000pF 容差:±10% 电压 - 额定:500V 温度系数:X7R 工作温度:-55°C ~ 125°C 特性:- 等级:- 应用:通用 故障率:- 安装类型:通孔 封装/外壳:径向 大小/尺寸:0.177" 长 x 0.124" 宽(4.50mm x 3.15mm) 高度 - 安装(最大值):0.197"(5.00mm) 厚度(最大值):- 引线间距:0.197"(5.00mm) 引线形式:成型引线 标准包装:500
RDER72H103K2K1C11B 功能描述:CAP CER 10000PF 500V 10% RADIAL RoHS:是 类别:电容器 >> 陶瓷 系列:RDE 标准包装:4,000 系列:- 电容:1000pF 电压 - 额定:50V 容差:±10% 温度系数:X7R 安装类型:表面贴装,MLCC 工作温度:-55°C ~ 125°C 应用:自动 额定值:AEC-Q200 封装/外壳:0805(2012 公制) 尺寸/尺寸:0.079" L x 0.047" W(2.00mm x 1.20mm) 高度 - 座高(最大):- 厚度(最大):- 引线间隔:- 特点:- 包装:带卷 (TR) 引线型:-
RDER72H104K8K1C11B 功能描述:CAP CER 0.1UF 500V 10% RADIAL RoHS:是 类别:电容器 >> 陶瓷 系列:RDE 标准包装:4,000 系列:- 电容:1000pF 电压 - 额定:50V 容差:±10% 温度系数:X7R 安装类型:表面贴装,MLCC 工作温度:-55°C ~ 125°C 应用:自动 额定值:AEC-Q200 封装/外壳:0805(2012 公制) 尺寸/尺寸:0.079" L x 0.047" W(2.00mm x 1.20mm) 高度 - 座高(最大):- 厚度(最大):- 引线间隔:- 特点:- 包装:带卷 (TR) 引线型:-