- 您现在的位置：买卖IC网 > PDF目录299876 > S-8340A25AFT-T2 0.1 A SWITCHING CONTROLLER, 690 kHz SWITCHING FREQ-MAX, PDSO8 PDF资料下载
参数资料
| 型号： | S-8340A25AFT-T2 |
| 元件分类： | 稳压器 |
| 英文描述： | 0.1 A SWITCHING CONTROLLER, 690 kHz SWITCHING FREQ-MAX, PDSO8 |
| 封装： | TSSOP-8 |
| 文件页数： | 9/53页 |
| 文件大小： | 855K |
| 代理商： | S-8340A25AFT-T2 |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页
STEP-UP, 600 kHz, PWM CONTROL OR PWM/PFM SWITCHABLE SWITCHING REGULATOR CONTROLLER
Rev.2.2_00
S-8340/8341 Series
Seiko Instruments Inc.
17
The soft-start circuit of the S-8340/8341 Series increases the duty ratio gradually as shown in Figure 10.
The soft-start time (tSS) can be set with an external capacitor (CSS).
Figure 10 Image of EXT Pin Waveform
If fOSC
= 600 kHz and CSS = 4700 pF, the time until the duty ratio of 50% is reached is 9.7 ms (typ.).
If VIN
≥ 2 V, the approximate time until a specific duty ratio is reached is calculated from the following formula :
If fOSC
= 600 kHz, tSS [ms] = CSS [pF] ×
If fOSC
= 300 kHz, tSS [ms] = CSS [pF] ×
Even if the IC reaches a certain duty at a duty ratio of 0 to 43%, there may be a delay of the output voltage (VOUT) in
reaching the specified voltage (VOUT(S)). This delay occurs due to the delay of the error amplifier reference voltage
in reaching the specified voltage (1.0 V). Note that the maximum delay time may be the value calculated when a
duty ratio is 43%.
3. ON/OFF Pin (Shutdown Pin)
The ON/OFF pin stops or starts the step-up operation.
When the ON/OFF pin is set to "L", all the internal circuits stop operating, reducing power consumption. The EXT
pin voltage becomes equal to the VSS voltage, thereby turning off the switching transistor.
The ON/OFF pin is configured as shown in Figure 11 and is not either pulled up or pulled down. So, do not use it
in a floating state. Applying 0.3 to 0.8 V to the ON/OFF pin increases current consumption. So do not apply such
voltage. When the ON/OFF pin is not used, connect it to the VDD pin. The ON/OFF pin does not have hysterisis.
ON/OFF Pin
CR Oscillation Circuit
Output Voltage
“H”
Operating
Set value
“L”
Stopped
VIN
*1
*1. Voltage obtained by extracting the voltage drop due to DC
resistance of the inductor and the diode forward voltage from VIN.
ON/OFF
VDD
VSS
Figure 11 ON/OFF Pin Structure
6.564
× Duty [%] + 698
229000
8.336
× Duty [%] + 682.45
535000
相关PDF资料 |
PDF描述 |
|---|---|
| S-8351A28MC-J2NT2G | SWITCHING REGULATOR, 110 kHz SWITCHING FREQ-MAX, PDSO5 |
| S-93C56ADFJ | 128 X 16 MICROWIRE BUS SERIAL EEPROM, PDSO8 |
| S-93C56BD0I-I8T1G | 128 X 16 MICROWIRE BUS SERIAL EEPROM, PDSO8 |
| S-I6117#01 | 6A, 250VAC, FEMALE AND MALE, MAINS POWER CONNECTOR |
| S-T111B23MC-OGI-TF | 2.3 V FIXED POSITIVE LDO REGULATOR, PDSO5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| S-8340A25AFT-T2-G | 功能描述:DC/DC 开关控制器 2.5V Step-Up 2.0% RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| S-8340A30AFT-T2 | 功能描述:DC/DC 开关控制器 3.0V Step-Up 2.0% RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| S-8340A30AFT-T2-G | 功能描述:DC/DC 开关控制器 3.0V Step-Up 2.0% RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| S-8340A33AFT-T2 | 功能描述:DC/DC 开关控制器 3.3V Step-Up 2.0% RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
| S-8340A33AFT-T2-G | 功能描述:DC/DC 开关控制器 3.3V Step-Up 2.0% RoHS:否 制造商:Texas Instruments 输入电压:6 V to 100 V 开关频率: 输出电压:1.215 V to 80 V 输出电流:3.5 A 输出端数量:1 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:CPAK |
发布紧急采购，3分钟左右您将得到回复。