参数资料
| 型号： | S116S02F |
| 厂商： | Sharp Microelectronics |
| 文件页数： | 9/13页 |
| 文件大小： | 0K |
| 描述： | RELAY SSR 120VAC 16A ZC 4-SIP |
| 产品目录绘图： | S Series 4-SIP Circuit |
| 标准包装： | 200 |
| 系列： | S116 |
| 电路： | SPST-NO（1 Form A） |
| 输出类型： | AC，过零 |
| 负载电流： | 16A |
| 输入电压： | 1.2VDC |
| 电压 - 负载： | 0 ~ 120 V |
| 安装类型： | 通孔 |
| 端接类型： | PC 引脚 |
| 封装/外壳： | 4-SIP |
| 供应商设备封装： | 4-SIP |
| 包装： | 管件 |
| 继电器类型： | 继电器 |
| 其它名称： | 425-2399-5 |
S116S02 Series
S216S02 Series
(a) Make sure there are no warps or bumps on the heat sink, insulation sheet and device surface.
(b) Make sure there are no metal dusts or burrs attached onto the heat sink, insulation sheet and device sur-
face.
(c) Make sure silicone grease is evenly spread out on the heat sink, insulation sheet and device surface.
Silicone grease to be used is as follows;
1) There is no aged deterioration within the operating temperature ranges.
2) Base oil of grease is hardly separated and is hardly permeated in the device.
3) Even if base oil is separated and permeated in the device, it should not degrade the function of a device.
Recommended grease : G-746 (Shin-Etsu Chemical Co., Ltd.)
: G-747 (Shin-Etsu Chemical Co., Ltd.)
: SC102 (Dow Corning Toray Silicone Co., Ltd.)
In case the optional heat sink is screwed up, please solder after screwed.
In case of the lead frame bending, please keep the following minimum distance and avoid any mechanical
stress between the base of terminals and the molding resin.
4.4mm MIN.
Some of AC electromagnetic counters or solenoids have built-in rectifier such as the diode.
In this case, please use the device carefully since the load current waveform becomes similar with rectangu-
lar waveform and this results may not make a device turn off.
● Degradation
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
● Standard Circuit
S116S02
S216S02
R 1
+ V CC
V 1
D 1
3
4
SSR
1
2
Z S
Load
AC Line
Tr1
Z S : Surge absorption circuit (Snubber circuit)
? For additional design assistance, please review our corresponding Optoelectronic Application Notes.
Sheet No.: D4-A02701EN
9
相关PDF资料 |
PDF描述 |
|---|---|
| PVU414SPBF | IC RELAY PHOTOVO 400V 140MA 6SMD |
| 0395337002 | 5.08MM EURO PLUG STR GRN 2POS |
| 0395324003 | 5.08MM EURO HEADER RA BLK 3POS |
| S216S02F | RELAY SSR 240VAC 16A ZC 4-SIP |
| 0395314003 | 5.08MM EURO HEADER STR BLK 3POS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| S116W | 制造商:Pass & Seymour/Legrand 功能描述:1G 16 CU. IN. SWG BRKT OLD WORK |
| S117 | 制造商:DFX 功能描述:STRIPLIGHT LED 700MM COLD PEARL |
| S117/B/50 | 制造商:Aavid Thermalloy 功能描述:Heat sink,2.3deg C/W 97x50x25mm 33.5g |
| S117/B/75 | 制造商:Aavid Thermalloy 功能描述:Heat sink,1.8deg C/W 97x75x25mm 33.5g |
| S-1170 | 制造商:SII 制造商全称:Seiko Instruments Inc 功能描述:HIGH RIPPLE-REJECTION AND LOW DROPOUT HIGH OUTPUT CURRENT CMOS VOLTAGE REGULATOR |
发布紧急采购，3分钟左右您将得到回复。