- 您现在的位置：买卖IC网 > PDF目录69332 > SAF-C164SL-8RM (INFINEON TECHNOLOGIES AG) 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP80 PDF资料下载
参数资料
| 型号： | SAF-C164SL-8RM |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP80 |
| 封装： | 0.65 MM PITCH, METRIC, PLASTIC, QFP-80 |
| 文件页数： | 5/79页 |
| 文件大小： | 1314K |
| 代理商： | SAF-C164SL-8RM |
第1页第2页第3页第4页当前第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页
C164CI/SI
C164CL/SL
Data Sheet
9
V2.0, 2001-05
XTAL2
XTAL1
54
55
O
I
XTAL2:
Output of the oscillator amplifier circuit.
XTAL1:
Input to the oscillator amplifier and input to
the internal clock generator
To clock the device from an external source, drive XTAL1,
while leaving XTAL2 unconnected. Minimum and maximum
high/low and rise/fall times specified in the AC
Characteristics must be observed.
RSTIN
69
I/O
Reset Input with Schmitt-Trigger characteristics. A low level
at this pin while the oscillator is running resets the C164CI.
An internal pullup resistor permits power-on reset using only
a capacitor connected to
VSS.
A spike filter suppresses input pulses <10 ns. Input pulses
>100 ns safely pass the filter. The minimum duration for a
safe recognition should be 100 ns + 2 CPU clock cycles.
In bidirectional reset mode (enabled by setting bit BDRSTEN
in register SYSCON) the RSTIN line is internally pulled low
for the duration of the internal reset sequence upon any reset
(HW, SW, WDT). See note below this table.
RST
OUT
70
O
Internal Reset Indication Output. This pin is set to a low level
when the part is executing either a hardware-, a software- or
a watchdog timer reset. RSTOUT remains low until the EINIT
(end of initialization) instruction is executed.
NMI
71
I
Non-Maskable Interrupt Input. A high to low transition at this
pin causes the CPU to vector to the NMI trap routine. When
the PWRDN (power down) instruction is executed, the NMI
pin must be low in order to force the C164CI to go into power
down mode. If NMI is high, when PWRDN is executed, the
part will continue to run in normal mode.
If not used, pin NMI should be pulled high externally.
Table 2
Pin Definitions and Functions (cont’d)
Symbol Pin
No.
Input
Outp.
Function
相关PDF资料 |
PDF描述 |
|---|---|
| SAF-C164SL-6R25M | 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP80 |
| SAK-C164SL-8RM | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP80 |
| SAK-C164CI-8EM | 16-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PQFP80 |
| SAF-C164CI-8R25M | 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP80 |
| SAF-C164CI-L25M | 16-BIT, 25 MHz, MICROCONTROLLER, PQFP80 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SAFC164SM | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontrol ler |
| SAF-C164SM | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontrol ler |
| SAF-C164SM-4R25F | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontrol ler |
| SAF-C164SM-4RF | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontrol ler |
| SAF-C164SV-2R25F | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:16-Bit Single-Chip Microcontroller |
发布紧急采购，3分钟左右您将得到回复。