- 您现在的位置：买卖IC网 > PDF目录98076 > SAK-C164CI-8EMCB (INFINEON TECHNOLOGIES AG) 16-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PQFP80 PDF资料下载
参数资料
| 型号： | SAK-C164CI-8EMCB |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 16-BIT, OTPROM, 20 MHz, MICROCONTROLLER, PQFP80 |
| 封装： | 0.65 MM PITCH, METRIC, PLASTIC, QFP-80 |
| 文件页数： | 28/80页 |
| 文件大小： | 1337K |
| 代理商： | SAK-C164CI-8EMCB |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页当前第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页
C164CI/SI
C164CL/SL
Data Sheet
29
V2.0, 2001-05
Oscillator Watchdog
The Oscillator Watchdog (OWD) monitors the clock signal generated by the on-chip
oscillator (either with a crystal or via external clock drive). For this operation the PLL
provides a clock signal which is used to supervise transitions on the oscillator clock. This
PLL clock is independent from the XTAL1 clock. When the expected oscillator clock
transitions are missing the OWD activates the PLL Unlock/OWD interrupt node and
supplies the CPU with the PLL clock signal. Under these circumstances the PLL will
oscillate with its basic frequency.
In direct drive mode the PLL base frequency is used directly (
fCPU = 2 … 5 MHz).
In prescaler mode the PLL base frequency is divided by 2 (
fCPU = 1 … 2.5 MHz).
Note: The CPU clock source is only switched back to the oscillator clock after a
hardware reset.
The oscillator watchdog can be disabled by setting bit OWDDIS in register SYSCON.
In this case (OWDDIS = ‘1’) the PLL remains idle and provides no clock signal, while the
CPU clock signal is derived directly from the oscillator clock or via prescaler or SDD. Also
no interrupt request will be generated in case of a missing oscillator clock.
Note: At the end of a reset bit OWDDIS reflects the inverted level of pin RD at that time.
Thus the oscillator watchdog may also be disabled via hardware by (externally)
pulling the RD line low upon a reset, similar to the standard reset configuration via
PORT0.
相关PDF资料 |
PDF描述 |
|---|---|
| SAK-C164SV-2RF | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64 |
| SAF-C164SV-2RF | 16-BIT, MROM, 20 MHz, MICROCONTROLLER, PQFP64 |
| SAF-C164SV-2R25F | 16-BIT, MROM, 25 MHz, MICROCONTROLLER, PQFP64 |
| SAK-C167CS-4R40M-BA | 16-BIT, MROM, 40 MHz, MICROCONTROLLER, PQFP144 |
| SAK-C167CS-4RC | 16-BIT, MROM, 33 MHz, MICROCONTROLLER, UUC146 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SAKC164CI8EMCBXT | 制造商:Infineon Technologies AG 功能描述:MCU 16-Bit C166 CISC/RISC 64KB EPROM 5V 80-Pin MQFP T/R |
| SAKC164CI8EMDB | 制造商:Infineon Technologies AG 功能描述: |
| SAKC164CI8EMDB/TR | 制造商:Infineon Technologies AG 功能描述: |
| SAKC164CI8EMDBX | 制造商:Infineon Technologies AG 功能描述:MCU 16-bit C166 CISC/RISC 64KB EPROM 5V 80-Pin MQFP |
| SAKC164CI8EMDBXT | 制造商:Infineon Technologies AG 功能描述:MCU 16-Bit C166 CISC/RISC 64KB EPROM 5V 80-Pin MQFP |
发布紧急采购，3分钟左右您将得到回复。