参数资料
型号: SC16C650BIB48,151
厂商: NXP Semiconductors
文件页数: 48/48页
文件大小: 0K
描述: IC UART SINGLE W/FIFO 48-LQFP
产品培训模块: Stand-Alone UARTs
标准包装: 250
通道数: 1,UART
FIFO's: 32 字节
电源电压: 2.5V,3.3V,5V
带自动流量控制功能:
带IrDA 编码器/解码器:
带故障启动位检测功能:
带调制解调器控制功能:
带CMOS:
安装类型: 表面贴装
封装/外壳: 48-LQFP
供应商设备封装: 48-LQFP(7x7)
包装: 管件
SC16C650B_4
NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 04 — 14 September 2009
9 of 48
NXP Semiconductors
SC16C650B
UART with 32-byte FIFOs and IrDA encoder/decoder
6.1 Internal registers
The SC16C650B provides 17 internal registers for monitoring and control. These registers
are shown in Table 3. Twelve registers are similar to those already available in the
standard 16C550. These registers function as data holding registers (THR/RHR), interrupt
status and control registers (IER/ISR), a FIFO control register (FCR), line status and
control registers (LCR/LSR), modem status and control registers (MCR/MSR),
programmable data rate (clock) control registers (DLL/DLM), and a user accessible
ScratchPad Register (SPR). Beyond the general 16C550 features and capabilities, the
SC16C650B offers an enhanced feature register set (EFR, Xon1/Xoff1, Xon2/Xoff2) that
provides on-board hardware/software ow control. Register functions are more fully
described in the following paragraphs.
[1]
These registers are accessible only when LCR[7] is a logic 0.
[2]
These registers are accessible only when LCR[7] is a logic 1.
[3]
Enhanced Feature Register, Xon1, Xon2 and Xoff1, Xoff2 are accessible only when the LCR is set to BFh.
6.2 FIFO operation
The 32-byte transmit and receive data FIFOs are enabled by the FIFO Control Register
bit 0 (FCR[0]). With 16C550 devices, the user can set the receive trigger level, but not the
transmit trigger level. The SC16C650B provides independent trigger levels for both
receiver and transmitter. To remain compatible with SC16C550, the transmit interrupt
trigger level is set to 16 following a reset. It should be noted that the user can set the
transmit trigger levels by writing to the FCR register, but activation will not take place until
EFR[4] is set to a logic 1. The receiver FIFO section includes a time-out function to ensure
Table 3.
Internal registers decoding
A2
A1
A0
Read mode
Write mode
General register set (THR/RHR, IER/ISR, MCR/MSR, FCR, LCR/LSR, SPR)[1]
0
Receive Holding Register
Transmit Holding Register
0
1
Interrupt Enable Register
0
1
0
Interrupt Status Register
FIFO Control Register
0
1
Line Control Register
1
0
Modem Control Register
1
0
1
Line Status Register
n/a
1
0
Modem Status Register
n/a
1
Scratchpad Register
Baud rate register set (DLL/DLM)[2]
0
LSB of Divisor Latch
0
1
MSB of Divisor Latch
Enhanced register set (EFR, Xon1, Xoff1, Xon2, Xoff2)[3]
0
1
0
Enhanced Feature Register
1
0
Xon1 word
1
0
1
Xon2 word
1
0
Xoff1 word
1
Xoff2 word
相关PDF资料
PDF描述
SC16C652BIB48,157 IC ENCODER/DECODER IRDA 48LQFP
SC16C654BIBS,557 IC QUAD UART 64BYTE 48HVQFN
SC16C750BIB64,151 IC UART SINGLE W/FIFO 64-LQFP
SC16C752BIBS,157 IC DUAL UART 64BYTE 32HVQFN
SC16C752IB48,128 IC DUAL UART 64BYTE 48LQFP
相关代理商/技术参数
参数描述
SC16C650BIB48-F 功能描述:UART 接口集成电路 16CB 2.5V-5V 1CH UART 32B FIFO RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
SC16C650BIBS 功能描述:UART 接口集成电路 16CB 2.5V-5V 1CH UART 32B FIFO RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
SC16C650BIBS,128 功能描述:UART 接口集成电路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
SC16C650BIBS,151 功能描述:UART 接口集成电路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel
SC16C650BIBS,157 功能描述:UART 接口集成电路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel