- 您现在的位置：买卖IC网 > PDF目录11825 > SC16C852VIBS,551 (NXP Semiconductors)IC UART DUAL W/FIFO 48-HVQFN PDF资料下载
参数资料
| 型号： | SC16C852VIBS,551 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 10/55页 |
| 文件大小： | 0K |
| 描述： | IC UART DUAL W/FIFO 48-HVQFN |
| 产品培训模块： | Stand-Alone UARTs |
| 标准包装： | 490 |
| 特点： | 可编程 |
| 通道数： | 2，DUART |
| FIFO's： | 128 字节 |
| 规程： | RS485 |
| 电源电压： | 2.5V |
| 带自动流量控制功能： | 是 |
| 带IrDA 编码器/解码器： | 是 |
| 带故障启动位检测功能： | 是 |
| 带调制解调器控制功能： | 是 |
| 带CMOS： | 是 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 供应商设备封装： | 48-HVQFN EP（6x6） |
| 包装： | 托盘 |
| 其它名称： | 568-4210 935283102551 SC16C852VIBS-S |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页
SC16C852V
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2011. All rights reserved.
Product data sheet
Rev. 5 — 21 January 2011
18 of 55
NXP Semiconductors
SC16C852V
Dual UART with 128-byte FIFOs, IrDA, and XScale VLIO bus interface
6.12 Sleep mode
Sleep mode is an enhanced feature of the SC16C852V UART. It is enabled when EFR[4],
the enhanced functions bit, is set and when IER[4] of both channels are set.
6.12.1 Conditions to enter Sleep mode
Sleep mode is entered when:
Modem input pins are not toggling.
The serial data input line, RXA/RXB, is idle for 4 character time (logic HIGH) and
AFCR1[4] is 0. When AFCR1[4] is 1, the device will go to sleep regardless of the state
of the RXA/RXB pin (see Section 7.21 for the description of AFCR1 bit 4).
The TX FIFO and TX shift register are empty.
There are no interrupts pending.
The RX FIFO is empty.
In Sleep mode, the UART clock and baud rate clock are stopped. Since most registers are
clocked using these clocks, the power consumption is greatly reduced.
Remark: Writing to the divisor latches, DLL and DLM, to set the baud clock, must not be
done during Sleep mode. Therefore, it is advisable to disable Sleep mode using IER[4]
before writing to DLL or DLM.
6.12.2 Conditions to resume normal operation
SC16C852V resumes normal operation by any of the following:
Receives a start bit on RXA or RXB pin.
Data is loaded into transmit FIFO.
A change of state on any of the modem input pins.
If the device is awakened by one of the conditions described above, it will return to the
Sleep mode automatically after all the conditions described in Section 6.12.1 are met. The
device will stay in Sleep mode until it is disabled by setting any channel’s IER bit 4 to a
logic 0.
When the SC16C852V is in Sleep mode and the host interface bus (AD7 to AD0, IOW,
IOR, CS) remains in steady state, either HIGH or LOW, the sleep current will be in the
microampere range as specified in Table 38 “Static characteristics”. If any of these signals
is toggling or floating then the sleep current will be higher.
6.13 Low power feature
A Low Power feature is provided by the SC16C852V to prevent the switching of the host
data bus from influencing the sleep current. When the pin LOWPWR is activated (logic
HIGH), the device immediately and unconditionally goes into Low Power mode. All clocks
are stopped and most host interface pins are isolated to reduce power consumption. The
device only returns to normal mode when the LOWPWR pin is de-asserted. The pin can
be left unconnected because it has an internal pull-down resistor.
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B7R-IX-F4 | CONVERTER MOD DC/DC 7.5V 75W |
| SC16C650BIBS,151 | IC UART SINGLE W/FIFO 32-HVQFN |
| SC16C650BIA44,518 | IC UART SINGLE W/FIFO 44-PLCC |
| ATMEGA325PV-10AUR | MCU AVR 32K FLASH 10MHZ 64TQFP |
| SC16IS762IBS-T | IC UART DUAL I2C/SPI 32-HVQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SC16C852VIBS-G | 功能描述:UART 接口集成电路 1.8V 2CH UART 128B FIFO 5MBPS RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| SC16C852VIBS-S | 功能描述:UART 接口集成电路 1.8V 2CH UART 128B FIFO 5MBPS RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| SC16C852VIET | 功能描述:UART 接口集成电路 1.8V 2CH UART 128B FIFO 5MBPS RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| SC16C852VIET,115 | 功能描述:UART 接口集成电路 1.8V 2CH UART 128B RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| SC16C852VIET,118 | 功能描述:UART 接口集成电路 UART 2-CH 128Byte FIFO 1.8V 36-Pin RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。