
Multi Chip White LED Modules
SEPW Series
11
resistance to ground to prevent shock hazard.
Workbenches where the products are handled should be
grounded and be provided with conductive table and floor mats.
When using measuring equipment such as a curve tracer, the
equipment should be grounded.
When soldering the products, the head of soldering irons or the
solder bath must be grounded in other to prevent leak voltages
generated by them from being applied to the products.
The products should always be stored and transported in our
shipping containers or conductive containers, or be wrapped in
aluminum foil.
Exposure to any overvoltage exceeding the Absolute Maximum
Rating of the products may cause damage to, or possibly result in
destruction of, the products. Buyer shall take absolutely secured
countermeasures against static electricity and surge when
handling the products.
Typical anti-static and anti-surge reference circuits are shown
below. The circuits shown are for reference only, and the buyer
must make a sufficient experimental verification of the static and
surge levels when employing the product.
Copyright 2007-2008 Allegro MicroSystems, Inc. This datasheet is based on Sanken datasheet 92019.
Application and operation examples described in this document are quoted for the sole purpose of reference only, for the use of the products
herein, and Sanken can assume no responsibility for any infringement of industrial property rights, intellectual property rights, or any other rights
of Sanken or any third party which may result from its use.
When using the products herein, the applicability and suitability of such products for an intended purpose or object shall be reviewed at the
user’s responsibility.
Although Sanken undertakes to enhance the quality and reliability of its products, the occurrence of failure and defect of semiconductor prod-
ucts at a certain rate is inevitable. Users of Sanken products are requested to take, at their own risk, preventative measures including safety design
of the equipment or systems against any possible injury, death, fires or damages to the society due to device failure or malfunction.
Sanken products listed in this document are designed and intended for the use as components in general purpose electronic equipment or appa-
ratus (home appliances, office equipment, telecommunication equipment measuring equipment, etc.). Before placing an order, the user’s written
consent to the specifications is requested.
When considering the use of Sanken products in the applications where higher reliability is required (transportation equipment and its control
systems, traffic signal control systems or equipment, fire/crime alarm systems, various safety devices, etc.), please contact your nearest Sanken
sales representative to discuss and obtain written confirmation of your specifications.
The use of Sanken products without the written consent of Sanken in the applications where extremely high reliability is required (aerospace
equipment, nuclear power control systems, life support systems, etc.) is strictly prohibited.
Anti radioactive ray design is not considered for the products listed herein.
If there is any discrepancy between English and Japanese versions of this datasheet, the Japanese version should take precedence over the
English one.
Please accept in advance that the content of this datasheet is subject to change without notice for the purpose of such as improvement of the
product.
Power Supply
1X per LED
Resistor
Protective Circuit
Reference Circuit Using Capacitor
Reference Circuit Using Zener Diode
R
10 kΩ
ZD
VR 7 to 8 V
Bypass
Capacitor
0.1 μF
C
>0.01 μF
Allegro MicroSystems, Inc.
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
www.allegromicro.com