- 您现在的位置：买卖IC网 > PDF目录10907 > SI2434-D-GT (Silicon Laboratories Inc)IC ISOMODEM GLOBAL DAA 24TSSOP PDF资料下载
参数资料
| 型号： | SI2434-D-GT |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 19/60页 |
| 文件大小： | 0K |
| 描述： | IC ISOMODEM GLOBAL DAA 24TSSOP |
| 标准包装： | 62 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页
Si2457/34/15/04
26
Rev. 1.3
+ESA Options
+ESA = A
+ESA = A,B
+ESA = A,B,C
+ESA = A,B,C,E
+ESA = A,B,C,E,F
+ESA = A,B,C,E,F,
G
Synchronous access mode control options
A
Specifies action taken if an underrun condition occurs during transparent sub-mode.
0
Modem transmits 8-bit SYN sequences on idle.
B
Specifies action taken if an underrun condition occurs after a flag during framed sub-
mode
0 Modem transmits 8-bit HDLC flags on idle.
C
Specifies action taken if an underrun or overrun condition occurs after a non-flag during
framed sub-mode.
0
Modem transmits abort on underrun in middle of frame.
1
Modem transmits flag on underrun in middle of frame and notifies host of underrun
or overrun.
D
Specifies V.34 half duplex operation.
This parameter should not be used.
E
Specifies CRC polynomial used while in framed sub-mode.
0 CRC generation checking disable.
1 16-bit CRC generation and checking is performed by the modem.
F
Specifies NRZI encoding and decoding.
0
NRZI encoding and decoding disabled.
G
Specifies SYN.
255
+FCLASS = X
Class 1 Mode Enable for V.29 fast connect.
X
Mode
0Off
1
Enables support for Class 1 mode for use in the V.29 fast connect mode.
+FRM = X
Class 1 Receive Carrier for V.29 fast connect.
X
Mode
2
Transmit V.21 (980 Hz) tone for longer than 100 ms, then send answer tone
(2100/2225 Hz) for 200 ms.
95
V.29 short synchronous.
96
V.29 full synchronous.
+FTM = X
Class 1 Transmit Carrier for V.29 fast connect.
X
Mode
2
Transmit V.21 (980 Hz) tone.
53
Same as &T4, but transmit V.29 7200 bps. Data pattern set by S40 register. AT +
FCLASS = 0 must be sent to restore the ISOmodem to normal operation after
test.
54
Same as &T4, but transmit V.29 9600 bps. Data pattern set by S40 register. AT +
FCLASS = 0 must be sent to restore the ISOmodem to normal operation after test.
95
V.29 short synchronous.
96
V.29 full synchronous.
Table 8. Basic AT Command Set (Command Defaults in Bold) (Continued)
Command
Action
相关PDF资料 |
PDF描述 |
|---|---|
| VI-260-CV | CONVERTER MOD DC/DC 5V 150W |
| VI-2N3-IX-F4 | CONVERTER MOD DC/DC 24V 75W |
| VI-25H-CV | CONVERTER MOD DC/DC 52V 150W |
| VI-25F-CV | CONVERTER MOD DC/DC 72V 150W |
| VI-25D-CV | CONVERTER MOD DC/DC 85V 150W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI2434-D-GTR | 制造商:Silicon Laboratories Inc 功能描述:Modem Chip Chipset 24-Pin TSSOP T/R 制造商:Silicon Laboratories Inc 功能描述:33.6 KBPS ISOMODEM SYSTEM-SIDE - LEAD-FREE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC ISOMODEM GLOBAL DAA 24TSSOP 制造商:Silicon Laboratories Inc 功能描述:33.6 kbps ISOmodem System-Side PBF |
| Si2434FS08-EVB | 功能描述:网络开发工具 16-pin Si2434 + Si3008 ISOmodem Evaluation Board RoHS:否 制造商:Rabbit Semiconductor 产品:Development Kits 类型:Ethernet to Wi-Fi Bridges 工具用于评估:RCM6600W 数据速率:20 Mbps, 40 Mbps 接口类型:802.11 b/g, Ethernet 工作电源电压:3.3 V |
| Si2434FS18-EVB | 功能描述:网络开发工具 16-pin Si2434 + Si3018 ISOmodem Evaluation Board RoHS:否 制造商:Rabbit Semiconductor 产品:Development Kits 类型:Ethernet to Wi-Fi Bridges 工具用于评估:RCM6600W 数据速率:20 Mbps, 40 Mbps 接口类型:802.11 b/g, Ethernet 工作电源电压:3.3 V |
| SI2434-FT | 功能描述:电信线路管理 IC CONTACT SILICON LABS FOR AVAILABILITY RoHS:否 制造商:STMicroelectronics 产品:PHY 接口类型:UART 电源电压-最大:18 V 电源电压-最小:8 V 电源电流:30 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 安装风格:SMD/SMT 封装 / 箱体:VFQFPN-48 封装:Tray |
| SI2434-FT/REV B | 制造商:Silicon Laboratories Inc 功能描述:LEAD FREE ISO MODEM - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。