- 您现在的位置：买卖IC网 > PDF目录2108 > SI4113-D-ZT1 (Silicon Laboratories Inc)IC SYNTHESIZER RF1/RF2 24TSSOP PDF资料下载
参数资料
| 型号： | SI4113-D-ZT1 |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 11/36页 |
| 文件大小： | 0K |
| 描述： | IC SYNTHESIZER RF1/RF2 24TSSOP |
| 标准包装： | 62 |
| 类型： | 频率合成器 |
| PLL： | 是 |
| 输入： | 时钟 |
| 输出： | 时钟 |
| 电路数： | 1 |
| 比率 - 输入:输出： | 1:2 |
| 差分 - 输入:输出： | 无/无 |
| 频率 - 最大： | 1.8GHz |
| 除法器/乘法器： | 是/无 |
| 电源电压： | 2.7 V ~ 3.6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 24-TSSOP |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
Si4133
Rev. 1.61
19
3.7. RF and IF Outputs
The RFOUT and IFOUT pins are driven by amplifiers
that buffer the RF VCOs and IF VCO respectively. The
RF output amplifier receives its input from the RF1 or
RF2 VCO, depending on which R- or N-Divider register
is written last. For example, programming the N-Divider
register for RF1 automatically selects the RF1 VCO
output.
Si4133. The RF output signal must be ac coupled to its
load through a capacitor. An external inductance
between the RFOUT pin and the ac coupling capacitor
is required as part of an output matching network to
maximize power delivered to the load. This 2 nH
inductance can be realized with a PC board trace. The
network is made to provide an adequate match to an
external 50
load for both the RF1 and RF2 frequency
bands. The matching network also filters the output
signal to reduce harmonic distortion.
The IFOUT pin must also be ac coupled to its load
through a capacitor. The IF output level is dependent
upon the load. Figure 18 on page 20 displays the output
level versus load resistance for a variety of output
frequencies. For resistive loads greater than 500
the
output level saturates and the bias currents in the IF
output amplifier are higher than required. The LPWR bit
in the Main Configuration register (Register 0) can be
set to 1 to reduce the bias currents and therefore reduce
the power dissipated by the IF amplifier. For loads less
than 500
LPWR should be set to 0 to maximize the
output level.
For IF frequencies greater than 500 MHz, a matching
network is required to drive a 50
load. See Figure 16.
Figure 16. IF Frequencies > 500 MHz
For frequencies less than 500 MHz, the IF output buffer
can directly drive a 200
resistive load or higher. For
resistive loads greater than 500
(f < 500 MHz) the
LPWR bit can be set to reduce the power consumed by
the IF output buffer. See Figure 17.
Figure 17. IF Frequencies < 500 MHz
3.8. Reference Frequency Amplifier
The Si4133 provides a reference frequency amplifier. If
the driving signal has CMOS levels it can be connected
directly to the XIN pin. Otherwise, the reference
frequency signal should be ac coupled to the XIN pin
through a 560 pF capacitor.
3.9. Powerdown Modes
Table 11 summarizes the powerdown functionality. The
Si4133 can be powered down by taking the PWDN pin low
or by setting bits in the Powerdown register (Register 2).
When the PWDN pin is low, the Si4133 is powered down
regardless of the Powerdown register settings. When the
PWDN pin is high, power management is in control of the
Powerdown register bits.
The IF and RF sections of the Si4133 circuitry can be
individually powered down by setting the Powerdown
register bits PDIB and PDRB low, respectively. The
reference frequency amplifier is also powered up if the
PDRB and PDIB bits are high. Also, setting the AUTOPDB
bit to 1 in the Main Configuration register (Register 0) is
equivalent to setting both bits in the Powerdown register to
1.
The serial interface remains available and can be written in
all powerdown modes.
Table 10. LMATCH Values
Frequency
LMATCH
500–600 MHz
40 nH
600–800 MHz
27 nH
800 MHz–1 GHz
18 nH
IFOUT
L
MATCH
560 pF
50
IFO UT
>500 pF
>200
相关PDF资料 |
PDF描述 |
|---|---|
| SI51210-A01AFM | IC CLK GEN FACTORY CONFIG 6TDFN |
| SI51211-A01AFM | IC CLK GEN FACTORY CONFIG 8TDFN |
| SI51214-A01AFM | IC CLK GEN FACTORY CONFIG 6TDFN |
| SI51219-A01AFT | IC CLK GEN FACTORY CONFIG 8TSSOP |
| SI5310-C-GM | IC CLOCK MULTIPLIER/REGEN 20-QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI4113-D-ZT1R | 制造商:Silicon Laboratories Inc 功能描述:DUAL-BAND RF SYNTHESIZER (RF1/RF2) RF ONLY, NIPD, LEAD FREE - Tape and Reel |
| SI4113-EVB | 功能描述:射频开发工具 Dual-Band RF Synth RF Only Eval TSSOP RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V |
| SI4113G | 制造商:SILABS 制造商全称:SILABS 功能描述:DUAL-BAND RF SYNTHESIZER WITH INTEGRATED VCOS FOR GSM AND GPRS WIRELESS COMMUNICATIONS |
| SI4113G-BM | 制造商:SILABS 制造商全称:SILABS 功能描述:DUAL-BAND RF SYNTHESIZER WITH INTEGRATED VCOS FOR GSM AND GPRS WIRELESS COMMUNICATIONS |
| SI4113G-BT | 制造商:SILABS 制造商全称:SILABS 功能描述:DUAL-BAND RF SYNTHESIZER WITH INTEGRATED VCOS FOR GSM AND GPRS WIRELESS COMMUNICATIONS |
发布紧急采购，3分钟左右您将得到回复。