参数资料
型号: SI8501-C-IM
厂商: Silicon Laboratories Inc
文件页数: 12/36页
文件大小: 0K
描述: SENSOR CURRENT 5A 5.5V UNI 12QFN
标准包装: 490
电流 - 感应: 5A
精确度: ±5%
灵敏度: 392mV/A
电流 - 电源: 4mA
传感器类型: 闭环
电源电压: 2.7 V ~ 5.5 V
输出: 可配置
频率: 50kHz ~ 1MHz
电极标记: 单向
工作温度: -40°C ~ 125°C
封装/外壳: 12-VFQFN
包装: 管件
产品目录页面: 627 (CN2011-ZH PDF)
其它名称: 336-1718-5
Si85xx
1.0%
0.5%
0.0%
-0.5%
-1.0%
-1.5%
-2.0%
-2.5%
-3.0%
-3.5%
Current Sense
Transformer
Si8502
0
25
50
75
100
125
Temperature (Celcius)
Figure 6. Differential Temperature
Calibration Error
Figure 7 shows the Si85xx thermal characteristics of the
on-chip sense resistance over the temperature range of
–40 to +125 °C. Series inductance is constant at 2 nH
(max) across this same temperature range.
2
1.8
1.6
1.4
1.2
1
0.8
0.6
0.4
0.2
0
Figure 8. Leading-Edge Noise Suppression
Waveforms (200 kHz, 9.3 A Load)
2.7. FAULT Output
The FAULT output (Si8517/8/9) guards against Si85xx
output signal errors caused by missing reset cycles.
FAULT is asserted when a measurement cycle exceeds
the internal watchdog timer times limit of t WD . FAULT
can be used to alert a local microcontroller or digital
power controller of a current sense failure or to initiate a
system shutdown. To detect faults, tie a 200 k ? resistor
from TRST/FAULT to VDD.
-20
0
20
40 60
Temperature (°C)
80
100
120
2.8. Safe Operating Limits
Figure 7. Series Resistance Thermal
Characteristics
2.6. Leading Edge Noise Suppression
High-amplitude spikes on the leading edge of the
primary switching waveforms can cause the PWM latch
to be erroneously reset at the start of the switching cycle
when operating in current mode control. To prevent this
problem, leading edge blanking is commonly used to
disable the current comparator during the early portion
of the primary-side switching cycle. The Si85xx
eliminates leading-edge noise spikes by including them
in the signal integration. As shown in the output
waveform of Figure 8 (Si8502 waveform measured
directly on OUT pin with no external filter), noise present
in the input waveform is eliminated without the use of
blanking.
The Si85xx is a very robust current sensor. Its maximum
input current rate of change is limited to 1000 A/μs. The
maximum peak ac input current limit is 200 A. The
thermal limit or continuous dc current flow limit is 30 A.
Exceeding these limits may cause long-term reliability
issues. Refer to “AN329: Extending the Full-Scale
Range of the Si85xx” for more information.
12
Preliminary Rev. 0.4
相关PDF资料
PDF描述
7L-19.200MCS-T OSC VCTCXO 19.200 MHZ 2.5V SMD
3781-8-8 CORD MINIGRABBER PATCH 8" GRAY
3781-8-7 CORD MINIGRABBER PATCH 8" VIOLET
3781-8-6 CORD MINIGRABBER PATCH 8" BLUE
3781-8-5 CORD MINIGRABBER PATCH 8" GREEN
相关代理商/技术参数
参数描述
SI8501-C-IMR 制造商:Silicon Laboratories Inc 功能描述:5A CURRENT SENSOR, SINGLE OUTPUT 1KV QFN12 - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:SENSOR CURRENT 5A 5.5V UNI 12QFN 制造商:Silicon Laboratories Inc 功能描述:5A Current Sensor Single Output 1kV
Si8501-C-IS 功能描述:板上安装电流传感器 5A SINGLE OUTPUT 5kV RoHS:否 制造商:Honeywell 电流额定值:+/- 56 A 传感器/变换器类型: 电源电压:4.75 VDC to 5.25 VDC 响应时间:< 0.2 us 输出电压: 工作温度:- 40 C to + 85 C 准确性:+/- 0.24 % 频率范围:
SI8501-C-ISR 制造商:Silicon Laboratories Inc 功能描述:5A CURRENT SENSOR, SINGLE OUTPUT 5KV SOIC20 - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:SENSOR CURR 5A 5.5V UNI 20SOIC 制造商:Silicon Laboratories Inc 功能描述:5A Current Sensor Single Output 5kV
SI-8501L 制造商:Sanken Electric Co Ltd 功能描述:Switching Mode Regulator 5-Pin 制造商:Sanken Electric Co Ltd 功能描述:IC REG BUCK ADJ 1A EI-19 制造商:ALLEGRO 功能描述:IC, LINEAR VOLTAGE REGULATOR 5V TO-220-6, Primary Input Voltage:20V, Output Volt 制造商:Allegro MicroSystems LLC 功能描述:IC, LINEAR VOLTAGE REGULATOR 5V TO-220-6, Primary Input Voltage:20V, Output Voltage Min:4.8V, Output Voltage Max:5.2V, Output Voltage Fixed:5V, No. of Pins:6, No. of Outputs:1, Output Current:1A, Operating Temperature Min:-20C , RoHS Compliant: Yes
Si8502-B-GM 功能描述:板上安装电流传感器 10A Current Sensr Single Out RoHS:否 制造商:Honeywell 电流额定值:+/- 56 A 传感器/变换器类型: 电源电压:4.75 VDC to 5.25 VDC 响应时间:< 0.2 us 输出电压: 工作温度:- 40 C to + 85 C 准确性:+/- 0.24 % 频率范围: