参数资料
型号: SL15316ZI-XXX
元件分类: XO, clock
英文描述: OTHER CLOCK GENERATOR, PDSO16
封装: 0.173 INCH, ROHS COMPLIANT, TSSOP-16
文件页数: 7/12页
文件大小: 276K
代理商: SL15316ZI-XXX
Rev 1.0, August 7, 2008
Page 4 of 12
SL15316
General Description
The primary source of EMI from digital circuits is the
system clock and all the other synchronous clocks and
control signals derived from the system clock. The well
know techniques of filtering (suppression) and shielding
(containment), while effective, can cost money, board
space and longer development time.
A more effective and efficient technique to reduce EMI is
Spread Spectrum Clock Generator (SSCG) technique.
Instead of using constant clock frequency, the SSCG
technique modulates (spreads) the system clock with a
much smaller frequency, to reduce EMI emissions at its
source: The System Clock.
The
SL15316
is
designed
using
SpectraLinear
proprietary phase-locked loop (PLL) and Spread
Spectrum Technologies (SST) to synthesize and
modulate (spread) the system clock such that the energy
is spread out over a wider bandwidth. This reduces the
peak value of the radiated emissions at the fundamental
and the harmonics. This reduction in radiated energy
can significantly reduce the cost of complying with
regulatory agency requirements and improve time-to-
market without degrading system performance.
The SL15316 operates from 3.3V to 2.5V power supply
range. Separate VDDO power supply is provided for thre
(3) output clock drivers. The supply voltage on these pins
could be 3.3V to 25V or 1.8V as long as VDDO≤VDD
condition is met.
The SL15316 is available in 16-pin TSSOP package with
Commercial Temperature range of 0 to 70
°C and
Industrial Temperature range of –40 to 85°C.
Input Frequency Range
The input frequency range is from 8.0 to 48.0 MHz for
crystals and ceramic resonators. If an external clock is
used, the input frequency range is from 3 to 166 MHz.
Output Frequency Range and Outputs
Up to five (5) outputs can be programmed as SSCLK or
REFCLK. SSCLK output can be synthesized to any value
from 3 to 200 MHz with spread using input frequency.
The spread at SSCLK pins can be stopped by SSON#
input control pin, If SSON# pin is HIGH (VDD), the
frequency at this pin is the synthesized to the nominal
value of the input frequency and there is no spread.
REFOUT is the buffered output of the oscillator and is
the same frequency as the input frequency without
spread. However, REFOUT value can also be divided by
using the output divider. The SSCLK is the programmed
and synthesized value of the input clock. The remaining
SSCLKs could be the same value providing fanout of up
to 5 or the frequency can be divided from also 2 to 32. In
this case, the spread % value is the same as the original
programmed spread % value. By using only first order
crystals, SL15316 can synthesize output frequency up to
200 MHz, eliminating the need for higher order Crystals
(Xtals) and Crystal Oscillators (XOs). This reduces the
cost while improving the system clock accuracy,
performance and reliability.
Programmable CL (Crystal Load)
The SL15316 provides programmable on-chip capacitors
at XIN/CLKIN (Pin-3) and XOUT (Pin-2). The resolution of
this programmable capacitor is 6-bits with LSB value of
0.5pF. When all bits are off the pin capacitance is
CXIN=CXOUT =7.0pF (minimum value). When all bits are
on the pin capacitance is CXIN=CXOUT=38pF (maximum
value). The values of CXIN and CXOUT based on the CL
(Crystal Load Capacitor) can be calculated as:
CXIN=CXOUT=2CL-CPCB. Refer to the Page-10 for
additional information on crystal load (CL).
In addition, if an external clock is used, the capacitance at
Pin-4 (XIN/CLKIN) can programmed to control the edge
rate of this input clock, providing additional EMI control.
Programmable Modulation Frequency
The Spread Spectrum Clock (SSC) modulation default
value is 31.5 kHz. The higher values of 60, 90 and 120
kHz can also be programmed. Less than 25 kHz
modulation frequency is not recommended to stay out of
the range audio frequency bandwidth since this frequency
could be detected as a noise by the audio receivers within
the vicinity.
Programmable Spread Percent (%)
The spread percent (%) value is programmable from +/-
0.125% to +/-2.5% (center spread) or -0.25% to -5.0%
(down spread) for all SSCLK frequencies. It is possible to
program smaller or larger non-standard values of spread
percent. Contact SLI if these non-standard spread percent
values are required in the application.
SSON# or Function Select (FS)
The SL15316 Pins 7, 12 and 15 could be programmed as
either SSON# to enable or disable the programmed
spread percent value or as Frequency Select (FS). If
SSON# is used, when this pin is pulled high (VDD), the
spread is stopped and the frequency is the nominal value
without spread. If low (GND), the frequency is the nominal
value with the spread.
If FS function is used, the output pins could be
programmed for different set of frequencies or spread %
as selected by FS. SSCLK value can be any frequency
from 3 to 200MHz, but the spread % is the same percent
value. REFOUT is the same frequency as the input
reference clock or divide by from 2 to 32 without spread.
The SL15316 allows a fan-out of up to 5 clocks, meaning
that Pins 7, 11, 12, 13 and 15 can be programmed to the
same frequencies with or without spread.
Power Down (PD#) or Output Enable (OE)
The SL15316 Pins 7, 11, 12, 13 and 15 could also be
programmed as either PD# or OE. PD# powers down the
entire chip whereas OE only disables the output buffers to
Hi-Z.
Spread Spectrum Clock Modulation Frequency
The modulation frequency of spread spectrum clock can
be programmed from 25 to 120kHz.
相关PDF资料
PDF描述
ST7PLITES2Y0M6 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PDSO16
ST7PLITE20F2B6 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PDIP20
ST72521BR9T6/XXX 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP64
SC2200UFH-266BF 32-BIT, 266 MHz, MICROPROCESSOR, PBGA481
ST72324BK2T6/XXX 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP32
相关代理商/技术参数
参数描述
SL15316ZI-XXXT 制造商:SPECTRALINEAR 制造商全称:SPECTRALINEAR 功能描述:Programmable Spread Spectrum Clock Generator (SSCG)
SL1533004 制造商:AMETHERM 制造商全称:AMETHERM Circuit Protection Thermistors 功能描述:Circuit Protection Thermistors
SL1-53-36G 制造商:Fischer Elektronik GmbH & Co KG 功能描述:Bulk
SL1-53-36Z 制造商:Fischer Elektronik GmbH & Co KG 功能描述:Bulk
SL1540004 制造商:AMETHERM 制造商全称:AMETHERM Circuit Protection Thermistors 功能描述:Circuit Protection Thermistors