参数资料
型号: SN65LVDS386EVM
厂商: Texas Instruments, Inc.
元件分类: 外设及接口
英文描述: Single Supply RS232C Line Driver/Receiver(?????μ?o?RS232C ?o?????????¨???2???2??????)
中文描述: 单电源RS232C接口线路驱动器/接收器(单电源RS232C接口线收发器(2发2收))
文件页数: 11/24页
文件大小: 308K
代理商: SN65LVDS386EVM
SN65LVDS386 16-Channel LVDS Line Receiver
2-5
The Evaluation Boards
2.2
SN65LVDS386 16-Channel LVDS Line Receiver
The SN65LVDS386EVM accepts 16 LVDS inputs and generates 16 LVTTL
outputs (refer to the schematic in Appendix I). Connectors P3 through P7
(right-side edge) accept the differential LVDS inputs and connector P1/P2 pro-
vides the LVTTL output signals. The as shippedconfiguration of the
SN65LVDS386 EVM also contains external resistors required for basic opera-
tion and testing of the device. Resistors R1 through R16 are 100-
resistors
which terminate each LVDS input channel. These are installed on the under-
side of the SN65LVDS386EVM, very close to the input pins of the device.
The LVTTL output-channels path (etch on the PWB) contains two padswhere
external resistors may be installed. Resistors R17 through R32 are series re-
sistors where zero-ohm resistors are normally installed. These are followed by
resistors R33 through R48, which allow a pull-down resistor to be installed af-
ter the series resistor (R17 through R32). As shipped, these pull-down resis-
tors are not installed. The combination of these series (R17 through R32) and
pull-down resistors (R 33 through R48) allow the user to install a divider net-
work if desired. This might be necessary if the outputs are to be measured with
an instrument having a 50-
input impedance. By installing a 475-
series re-
sistor and a 50-
pull down resistor, a 20:1 divider is created (the 50-
pull-
down in parallel with the 50-
input impedance equals 25
, plus the 475-
series impedance of the instrument, for a total load of 500
on the output of
the receiver). As shipped, there is no resistor divider installed, and each device
LVTTL output is routed directly to the P1/P2 connectors through a 0-
resistor
(R17 through R32).
The remaining components are connectors for V
CC
and GND connections,
and decoupling capacitors for the LVDS device (these components are the
same for both EVM configurations).
There are also four jumpers (JMP1 through JMP4 ) located next to the P1/P2
connector row. These jumpers control the enable/disable for each four-chan-
nel (quad) section of the device. Each of these jumpers consist of three pins
and a jumper short. The center pin is connected to the device and the outer
pins (top and bottom) are V
CC
and GND. The jumper short can be moved so
contact is made between V
CC
and the enable/disable pin, or between GND
and the enable/disable pin. As shipped, the jumper shorts are installed to V
CC
so that all four sections of the device are enabled.
相关PDF资料
PDF描述
SN65LVDS387EVM Single Supply RS232C Line Driver/Receiver(?????μ?o?RS232C ?o?????????¨???2???2??????)
SN65LVDT390DRG4 HIGH-SPEED DIFFERENTIAL LINE RECEIVERS
SN65LVDTS33D HIGH-SPEED DIFFERENTIAL RECEIVERS
SN7400DRE4 QUADRUPLE 2-INPUT POSITIVE-NAND GATES
SN7400DRG4 QUADRUPLE 2-INPUT POSITIVE-NAND GATES
相关代理商/技术参数
参数描述
SN65LVDS387DGG 功能描述:LVDS 接口集成电路 16Ch HS Diff RoHS:否 制造商:Texas Instruments 激励器数量:4 接收机数量:4 数据速率:155.5 Mbps 工作电源电压:5 V 最大功率耗散:1025 mW 最大工作温度:+ 85 C 封装 / 箱体:SOIC-16 Narrow 封装:Reel
SN65LVDS387DGGG4 功能描述:LVDS 接口集成电路 16Ch HS Diff RoHS:否 制造商:Texas Instruments 激励器数量:4 接收机数量:4 数据速率:155.5 Mbps 工作电源电压:5 V 最大功率耗散:1025 mW 最大工作温度:+ 85 C 封装 / 箱体:SOIC-16 Narrow 封装:Reel
SN65LVDS387DGGR 功能描述:LVDS 接口集成电路 16-Channel LVDS Driver RoHS:否 制造商:Texas Instruments 激励器数量:4 接收机数量:4 数据速率:155.5 Mbps 工作电源电压:5 V 最大功率耗散:1025 mW 最大工作温度:+ 85 C 封装 / 箱体:SOIC-16 Narrow 封装:Reel
SN65LVDS387DGGRG4 功能描述:LVDS 接口集成电路 16-Channel LVDS Driver RoHS:否 制造商:Texas Instruments 激励器数量:4 接收机数量:4 数据速率:155.5 Mbps 工作电源电压:5 V 最大功率耗散:1025 mW 最大工作温度:+ 85 C 封装 / 箱体:SOIC-16 Narrow 封装:Reel
SN65LVDS387EVM 功能描述:其他开发工具 16-Ch LVDS Driver Eval Mod RoHS:否 制造商:Parallax 产品:ELEV-8 Hex Upgrade Kits 类型:Robotics 工具用于评估:ELEV-8 Quadcopter 工作电源电压: