- 您现在的位置：买卖IC网 > PDF目录10200 > SP238ACT-L/TR (Exar Corporation)IC DVR/RCVR RS232 MULTI 24WSOIC PDF资料下载
参数资料
| 型号： | SP238ACT-L/TR |
| 厂商： | Exar Corporation |
| 文件页数： | 10/12页 |
| 文件大小： | 0K |
| 描述： | IC DVR/RCVR RS232 MULTI 24WSOIC |
| 标准包装： | 1,500 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 4/4 |
| 规程： | RS232 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 24-SOIC W |
| 包装： | 带卷 (TR) |
7
Exar Corporation 48720 Kato Road, Fremont CA, 94538 (50)668-707 www.exar.com
SP238A_00_0740
Figure 2. High Voltage Short-Circuit Protection
ibM Modem Port interconnections
inteRFace eXaMPle - a MoDeM
on tHe ibM Pc SeRial PoRt
TheRS-232standarddefines22serialinterface
signals. These signals consist of ground lines,
timing, data, control and test signals, plus a set
of signals rarely used for a second data channel.
Many of these signal lines are not used in typical
RS-232applications;infact,theIBM PC serial
port is implemented using only nine pins.
For example, consider the case of a PC using this
nine pin port to communicate with a peripheral
device such as a modem. We see the following
activity on each of the RS-232 lines as the com-
puterandmodemareactivatedandcommunicate
with each other as well as the remote modem at
the other end of the phone line.
Signal Ground (GnD)
The Signal Ground pin acts as a reference for all
the other signals. This pin is simply maintained
at a 0V level to serve as a level to which all
othersignalsarereferenced.BoththePCand
the modem will have this line connected to their
respective internal ground lines.
Data terminal Ready (DtR)
This is the pin the computer uses to tell pe-
ripheral devices that it is on-line and ready to
communicate.
Data Set Ready (DSR)
Peripheraldevicesusethislinetotellthecomputer
that they are on-line and ready to communicate.
When the modem is turned on and has completed
its self-test routine (assuming it does one), it will
send a signal to the PC by asserting this line
.
Request to Send (RtS)
The computer activates this line to notify the
peripheral device that it is ready to send data. In
thisexample,thecomputernotifiesthemodem
that it is ready to send data to be transmitted by
the modem.
clear to Send (ctS)
This is the line on which the peripheral device
tells the computer that it is ready to receive data
from the computer. If the modem was not ready,
i.e. it was performing a loop-back self-test, for
example, it would not assert this line. Once the
modem was ready to receive data from the PC,
it would assert this line. When it receives the
ctS signal from the modem, the PC knows that
a data transmission path has been established
between itself and the modem.
Protection From Shorts exceeding
±15V
The driver outputs are protected against shorts
to ground, other driver outputs, and V+ or V-. For
protection against voltages exceeding ±5V, two
back-to-back zener diodes connected to clamp
the outputs to an acceptable voltage level are
recommended. (Refer to Figure 2.)
application examples
相关PDF资料 |
PDF描述 |
|---|---|
| ADM232LJR-REEL | IC TXRX RS-232 DUAL 5V 16SOIC |
| ADM101EARM-REEL7 | IC TXRX RS-232 SINGLE 5V 10MSOP |
| CXS3106A1610S | CONN PLUG 3POS STRGHT SKT |
| VE-2WP-MY | CONVERTER MOD DC/DC 13.8V 50W |
| VE-2WN-MY | CONVERTER MOD DC/DC 18.5V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP238ACX | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:+5V Powered Multi-Channel RS-232 Drivers/Receivers |
| SP238AES | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:+5V Powered Multi-Channel RS-232 Drivers/Receivers |
| SP238AES-L | 制造商:Exar Corporation 功能描述: |
| SP238AET | 制造商:Exar Corporation 功能描述: |
| SP238AET/TR | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:+5V Powered Multi-Channel RS-232 Drivers/Receivers |
发布紧急采购，3分钟左右您将得到回复。