- 您现在的位置：买卖IC网 > PDF目录14217 > SP7651ER-L/TR (Exar Corporation)IC REG BUCK SYNC ADJ 3A 26DFN PDF资料下载
参数资料
| 型号： | SP7651ER-L/TR |
| 厂商： | Exar Corporation |
| 文件页数： | 5/15页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 3A 26DFN |
| 标准包装： | 3,000 |
| 系列： | Power Blox™ |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 19 V |
| 输入电压： | 2.5 V ~ 20 V |
| PWM 型： | 电压模式 |
| 频率 - 开关： | 900kHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 26-VFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 26-DFN（7x4） |
| 其它名称： | SP7651ER-L/TR-ND |
safely begin down conversion, and an inter-
nal V CC UVLO ensures that the controller
itself has enough voltage to properly operate.
Other protection features include thermal
shutdown and short-circuit detection. In the
event that either a thermal, short-circuit, or
UVLO fault is detected, the SP765 is forced
into an idle state where the output drivers are
held off for a finite period before a re-start
is attempted.
Soft Start
“Soft Start” is achieved when a power con-
verter ramps up the output voltage while
controlling the magnitude of the input sup-
ply source current. In a modern step down
converter, ramping up the positive terminal
of the error amplifier controls soft start. As a
result, excess source current can be defined
as the current required to charge the output
capacitor.
I VIN = C OUT * (?V OUT / ?T SOFT-START )
The SP765 provides the user with the op-
tion to program the soft start rate by tying
a capacitor from the SS pin to GND. The
selection of this capacitor is based on the
0μA pullup current present at the SS pin
and the 0.8V reference voltage. Therefore,
the excess source can be redefined as:
I VIN = C OUT * (?V OUT * 0μA / (C SS * 0.8V)
Under Voltage Lock Out (UVLO)
The SP765 contains two separate UVLO
comparators to monitor the internal bias (V CC )
and conversion (V IN ) voltages independently.
The V CC UVLO threshold is internally set
to 4.25V, whereas the V IN UVLO threshold
is programmable through the UVIN pin.
When the UVIN pin is greater than 2.5V,
the SP765 is permitted to start up pend-
ing the removal of all other faults. Both the
V CC and V IN UVLO comparators have been
designed with hysteresis to prevent noise
from resetting a fault.
THEORY OF OPERATION
Thermal and Short-Circuit
Protection
Because the SP765 is designed to drive
large output current, there is a chance that the
power converter will become too hot. There-
fore, an internal thermal shutdown (145°C)
has been included to prevent the IC from
malfunctioning at extreme temperatures.
A short-circuit detection comparator has
also been included in the SP765 to protect
against an accidental short at the output
of the power converter. This comparator
constantly monitors the positive and nega-
tive terminals of the error amplifier, and if
the V FB pin falls more than 250mV (typical)
below the positive reference, a short-circuit
fault is set. Because the SS pin overrides the
internal 0.8V reference during soft start, the
SP765 is capable of detecting short-circuit
faults throughout the duration of soft start as
well as in regular operation.
Handling of Faults:
Upon the detection of power (UVLO), ther-
mal, or short-circuit faults, the SP765 is
forced into an idle state where the SS and
COMP pins are pulled low and the NFETS
are held off. In the event of UVLO fault, the
SP765 remains in this idle state until the
UVLO fault is removed. Upon the detection
of a thermal or short-circuit fault, an internal
200ms timer is activated. In the event of a
short-circuit fault, a re-start is attempted im-
mediately after the 200ms timeout expires.
Whereas, when a thermal fault is detected
the 200ms delay continuously recycles and a
re-start cannot be attempted until the thermal
fault is removed and the timer expires.
Error Amplifier and Voltage Loop
Since the heart of the SP765 voltage error
loop is a high performance, wide bandwidth
transconductance amplifier, great care
should be taken to select the optimal compen-
sation network. Because of the amplifier ’s
Rev J: 3/ 4/07
SP765 Wide Input Voltage Range 3A, 900kHz, Buck Regulator
5
? Copyright 2007 Sipex Corporation
相关PDF资料 |
PDF描述 |
|---|---|
| HM66A-03158R2NLF13 | SHIELDED POWER INDUCTORS |
| EEC31DRYI-S93 | CONN EDGECARD 62POS DIP .100 SLD |
| HM66A-03156R8NLF13 | SHIELDED POWER INDUCTORS |
| EEC36DRTI-S93 | CONN EDGECARD 72POS DIP .100 SLD |
| ADP2105ACPZ-3.3-R7 | IC REG BUCK SYNC 3.3V 1A 16LFCSP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP7652 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Wide Input Voltage Range 6A, 600kHz, Buck Regulator |
| SP7652_06 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Wide Input Voltage Range 6A, 600kHz, Buck Regulator |
| SP7652EB | 功能描述:电源管理IC开发工具 Eval Board for SP7652 Series RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| SP7652ER | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: |
| SP7652ER/TR | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Wide Input Voltage Range 6A, 600kHz, Buck Regulator |
发布紧急采购，3分钟左右您将得到回复。