- 您现在的位置：买卖IC网 > Datasheet目录364 > SSL3250AHN/C1,528 (NXP Semiconductors)IC LED DRVR PHOTO FLASH 16-HVQFN Datasheet资料下载
参数资料
| 型号： | SSL3250AHN/C1,528 |
| 厂商： | NXP Semiconductors |
| 文件页数： | 5/26页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR PHOTO FLASH 16-HVQFN |
| 产品培训模块： | LED Controllers |
| 标准包装： | 1 |
| 拓扑： | PWM，升压（升压） |
| 输出数： | 1 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 闪灯/白光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 1.08MHz ~ 1.32MHz |
| 电源电压： | 2.7 V ~ 5.5 V |
| 输出电压： | 9.5V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-VFQFN 裸露焊盘 |
| 供应商设备封装： | 16-HVQFN |
| 包装： | 标准包装 |
| 工作温度： | -40°C ~ 85°C |
| 其它名称： | 568-4718-6 |
NXP Semiconductors
SSL3250A
Photo flash dual LED driver
8. Functional description
8.1 Introduction
The SSL3250A is an asynchronous boost converter intended to drive either a single high
power flash LED or two high power flash LEDs in series. The main LED current is
controlled by the output voltage of the boost converter and the integrated linear current
sink. The SSL3250A has two interface modes and five operational modes. The control
interface is selected by the interface select pin IF_SEL. Depending on the interface mode
selected, the device can either be controlled by an I 2 C interface or by external enable
lines. Both interface modes control the five operational modes. These operational modes
are:
?
?
?
?
?
Shut-down mode
Standby mode
Indicator mode
Torch mode
Flash mode
The first mode is entered by putting a LOW level on the activate pin (ACT). This pin is
common for both interface modes. The operational modes Torch and Flash apply to the
same main LED current source, and the Indicator mode applies to a separate indicator
LED current source. Only when the I 2 C interface mode is enabled, the operational modes
Indicator, Flash and/or Torch can be used in parallel.
In normal operation, the regulated converter uses Pulse Width Modulation (PWM), so the
switching frequency is constant in all modes.
In applications where the required main LED voltage is lower than the applied input
voltage, the converter switches to linear mode. The excess voltage difference between
the required LED voltage and the input voltage is now compensated by increasing the
voltage over the current sink and therefore on the LED pin.
Apart from the main LED(s), a separate indicator LED can be driven from the SSL3250A.
This indicator LED is driven by a linear current sink circuit that operates independently
from the switch mode converter for the main LED(s).
8.2 Interface modes
The device is equipped I 2 C mode and Direct enable mode interfaces. Which interface
mode is used, is defined by the level of the IF_SEL pin at the start-up of the device
(V ACT → LOW to HIGH). The state of the IF_SEL pin should be kept static after powering
up the device. Table 4 shows the interface possibilities.
Table 4.
Interface modes
IF_SEL
Interface mode
Relevant controls
0
I 2 C
mode
SDA, SCL, STRB, ACT, R_FL, INT.
SSL3250A_5
1
Direct enable mode
EN1, EN2, ACT, INT, R_TR, R_FL, R_IND, INT.
? NXP B.V. 2009. All rights reserved.
Product data sheet
Rev. 05 — 16 December 2009
5 of 26
相关PDF资料 |
PDF描述 |
|---|---|
| SST25LF020A-33-4C-QAE-T | IC FLASH SER 2MB 33HZ SPI 8WSON |
| SST25VF010A-33-4I-QAE-T | IC FLASH SER 1MB 33MHZ SPI 8WSON |
| SST25VF016B-50-4C-S2AF-T | IC FLASH SER 16M 50MHZ SPI 8SOIC |
| SST25VF020-20-4C-QAE-T | IC FLASH SER 2MB 20MHZ SPI 8WSON |
| SST25VF020B-80-4C-QAE-T | IC FLASH SER 2MB 80MHZ SPI 8WSON |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SSL3252 | 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:Smart, simple solutions for the 12 most common design concerns |
| SSL3252UK/C2,515 | 功能描述:LED照明驱动器 Photo flash LED driver RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| SSL33 | 功能描述:肖特基二极管与整流器 Low VF 3Amp 30v SMD Schottky Rect RoHS:否 制造商:Skyworks Solutions, Inc. 产品:Schottky Diodes 峰值反向电压:2 V 正向连续电流:50 mA 最大浪涌电流: 配置:Crossover Quad 恢复时间: 正向电压下降:370 mV 最大反向漏泄电流: 最大功率耗散:75 mW 工作温度范围:- 65 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:SOT-143 封装:Reel |
| SSL33 R6 | 制造商:SKMI/Taiwan 功能描述:Diode Schottky 30V 3A 2-Pin SMC T/R |
| SSL34 | 功能描述:肖特基二极管与整流器 Low VF 3Amp 40v SMD Schottky Rect RoHS:否 制造商:Skyworks Solutions, Inc. 产品:Schottky Diodes 峰值反向电压:2 V 正向连续电流:50 mA 最大浪涌电流: 配置:Crossover Quad 恢复时间: 正向电压下降:370 mV 最大反向漏泄电流: 最大功率耗散:75 mW 工作温度范围:- 65 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:SOT-143 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。