参数资料
| 型号： | ST16C650ACQ48-F |
| 厂商： | Exar Corporation |
| 文件页数： | 28/50页 |
| 文件大小： | 0K |
| 描述： | IC UART FIFO 32B 48TQFP |
| 标准包装： | 250 |
| 特点： | * |
| 通道数： | 1，UART |
| FIFO's： | 32 字节 |
| 规程： | 打印机，RS232，RS422，RS485 |
| 电源电压： | 2.9 V ~ 5.5 V |
| 带并行端口： | 是 |
| 带IrDA 编码器/解码器： | 是 |
| 带故障启动位检测功能： | 是 |
| 带调制解调器控制功能： | 是 |
| 带CMOS： | 是 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-TQFP |
| 供应商设备封装： | 48-TQFP（7x7） |
| 包装： | 托盘 |
| 其它名称： | 1016-1662 ST16C650ACQ48-F-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页当前第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页
ST16C650A
34
2.90V TO 5.5V UART WITH 32-BYTE FIFO
REV. 5.0.3
MSR[6]: RI Input Status
RI# (active high, logical 1). Normally this bit is the compliment of the RI# input. In the loopback mode this bit is
equivalent to bit-2 in the MCR register. The RI# input may be used as a general purpose input when the
modem interface is not used.
MSR[7]: CD Input Status
CD# (active high, logical 1). Normally this bit is the compliment of the CD# input. In the loopback mode this bit
is equivalent to bit-3 in the MCR register. The CD# input may be used as a general purpose input when the
modem interface is not used.
4.11
Infrared Transmit Pulse Width Control Register (IRPW) - Write Only
The IRPW register allows the user to program the encoder’s pulse width. This cuts the LED on-time, hence,
reducing power consumption.
IRPW [7:0]: Pulse width control
A 0x00 value (default) will set the pulse width to normal width of 3/16 of the data bit rate. The programmable
infrared pulse width can be calculated using the following equation:
Infrared pulse width (PW) = Crystal clock period x ‘N’, where ‘N’ is the value in IRPW from 1 to 255.
Examples:
Crystal frequency = 14.7456MHz (clock period of 67.82ns)
PW = 67.82 x ‘N’ or ranges from 67.82ns to 17.29ms
Caution: Never allow PW to exceed the operating data rate bit period, else the encoder stops.
4.12
Scratch Pad Register (SPR)
This is an 8-bit general purpose register for the user to store temporary data. The content of this register is
preserved during sleep mode but becomes 0xFF (default) after a reset or a power off-on cycle.
4.13
Baud Rate Generator Divisors (DLL and DLM) - Read/Write
The Baud Rate Generator (BRG) is a 16-bit counter that generates the data rate for the transmitter. The rate is
programmed through registers DLL and DLM which are only accessible when LCR bit-7 is set to ‘1’. See
Programmable Baud Rate Generator section for more details. The concatenation of the contents of DLM and
DLL gives the 16-bit divisor value which is used to calculate the baud rate:
Baud Rate = (Clock Frequency / 16) / Divisor
Also see MCR bit-7 and Table 4.
4.14
Device Identification Register (DVID) - Read Only
This register contains the device ID (0x04 for ST16C650A). Prior to reading this register, DLL and DLM should
be set to 0x00.
4.15
Device Revision Register (DREV) - Read Only
This register contains the device revision information. For example, 0x01 means revision A. Prior to reading
this register, DLL and DLM should be set to 0x00.
4.16
Enhanced Feature Register (EFR)
Enhanced features are enabled or disabled using this register. Bit 0-3 provide single or dual consecutive
character software flow control selection (see Table 12). When the Xon1 and Xon2 and Xoff1 and Xoff2 modes
are selected, the double 8-bit words are concatenated into two sequential characters. Caution: note that
whenever changing the TX or RX flow control bits, always reset all bits back to logic 0 (disable) before
programming a new setting.
相关PDF资料 |
PDF描述 |
|---|---|
| XR68M752IM48-F | IC UART FIFO 64B DUAL 48TQFP |
| XR16M752IM48-F | IC UART FIFO 34B DUAL 48TQFP |
| ST16C450CQ48-F | IC UART SINGLE 48TQFP |
| ST16C2450IQ48-F | IC UART FIFO DUAL 48TQFP |
| MAX7314AEG+T | IC I/O EXPANDER I2C 16B 24QSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ST16C650ACQ48TR-F | 制造商:Exar Corporation 功能描述:UART 1-CH 32Byte FIFO 3.3V/5V 48-Pin TQFP T/R 制造商:Exar Corporation 功能描述:ST16C650ACQ48TR-F |
| ST16C650AIJ44 | 制造商:EXAR 制造商全称:EXAR 功能描述:2.90V TO 5.5V UART WITH 32-BYTE FIFO |
| ST16C650AIJ44-F | 功能描述:UART 接口集成电路 UART W/32BYTEFIFO RoHS:否 制造商:Texas Instruments 通道数量:2 数据速率:3 Mbps 电源电压-最大:3.6 V 电源电压-最小:2.7 V 电源电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:LQFP-48 封装:Reel |
| ST16C650AIP40 | 制造商:EXAR 制造商全称:EXAR 功能描述:2.90V TO 5.5V UART WITH 32-BYTE FIFO |
| ST16C650AIQ48 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述:UART, 48 Pin, Plastic, TQFP |
发布紧急采购，3分钟左右您将得到回复。