参数资料
型号: ST6280BQ6/XXX
厂商: STMICROELECTRONICS
元件分类: 微控制器/微处理器
英文描述: 8-BIT, MROM, 8 MHz, MICROCONTROLLER, PQFP100
封装: PLASTIC, QFP-100
文件页数: 44/80页
文件大小: 934K
代理商: ST6280BQ6/XXX
Obsolete
Product(s)
- Obsolete
Product(s)
49/80
ST62T80B/E80B
4.4 U. A. R. T. (Universal Asynchronous Receiver/Transmitter)
The UART provides the basic hardware for asyn-
chronous serial communication which, combined
with an appropriate software routine, gives a serial
interface providing communication with common
baud rates (up to 38,400 Baud with an 8MHz ex-
ternal oscillator) and flexible character formats.
Operating in Half-Duplex mode only, the UART
uses 11-bit characters comprising 1 start bit, 9 data
bits and 1 Stop bit. Parity is supported by software
only for transmit and for checking the received par-
ity bit (bit 9). Transmitted data is sent directly, while
received data is buffered allowing further data
characters to be received while the data is being
read out of the receive buffer register. Data trans-
mit has priority over data being received.
The UART is supplied with an MCU internal clock
that is also available in WAIT mode of the processor.
4.4.1 PORTS INTERFACING
RXD reception line and TXD emission line are
sharing the same external pins as two I/O lines.
Therefore, UART configuration requires to set
these two I/O lines through the relevant ports reg-
isters. The I/O line common with RXD line must be
defined as input mode (with or without pull-up)
while the I/O line common with TXD line must be
defined as output mode (Push-pull or open drain).
The transmitted data is inverted and can therefore
use a single transistor buffering stage. Defined as
input, the RXD line can be read at any time as an
I/O line during the UART operation. The TXD pin
follows I/O port registers value when UARTOE bit
is cleared, which means when no serial transmis-
sion is in progress. As a consequence, a perma-
nent high level has to be written onto the I/O port in
order to achieve a proper stop condition on the
TXD line when no transmission is active.
Figure 25. UART Block Diagram
CO
NTRO
L
LO
GIC
TO
C
ORE
START
DETECTOR
DATA SHIFT
REGISTER
D8 D7 D6 D5 D4 D3 D2 D1 D0
CONTROL REGISTER
BAUD RATE
RECEIVE BUFFER
REGISTER
PROGRAMMABLE
DIVIDER
DIN
DOUT
D9
BAUD RATE x 8
WRITE
READ
RXD1
TXD1
UARTOE
RX and TX
INTERRUPTS
TXD
DR
0
MUX
1
fINT
VR02009
49
相关PDF资料
PDF描述
ST6285Q6/XX 8-BIT, MROM, 8.4 MHz, MICROCONTROLLER, PQFP80
ST62E25CF1 8-BIT, UVPROM, 8 MHz, MICROCONTROLLER, CDIP28
ST62P15CB3 MICROCONTROLLER, PDIP28
ST6215CB3/CCC MICROCONTROLLER, PDIP28
ST62P15CM3 MICROCONTROLLER, PDSO28
相关代理商/技术参数
参数描述
ST6280-EMU2 功能描述:开发板和工具包 - 其他处理器 ST62 Emulator Board RoHS:否 制造商:Freescale Semiconductor 产品:Development Systems 工具用于评估:P3041 核心:e500mc 接口类型:I2C, SPI, USB 工作电源电压:
ST6280-P/QFP 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:REAL TIME EMULATION DEVELOPMENT TOOLS FOR ST6 MCU FAMILY
ST6280Q1/XX 制造商:未知厂家 制造商全称:未知厂家 功能描述:8-Bit Microcontroller
ST6280Q6/XX 制造商:未知厂家 制造商全称:未知厂家 功能描述:8-Bit Microcontroller
ST6281T6/HEA/TR 制造商:STMicroelectronics 功能描述: