- 您现在的位置：买卖IC网 > PDF目录98147 > STCL1120YBFCWY5 (STMICROELECTRONICS) 12 MHz, OTHER CLOCK GENERATOR, PDSO5 PDF资料下载
参数资料
| 型号： | STCL1120YBFCWY5 |
| 厂商： | STMICROELECTRONICS |
| 元件分类： | 时钟产生/分配 |
| 英文描述： | 12 MHz, OTHER CLOCK GENERATOR, PDSO5 |
| 封装： | ROHS COMPLIANT, SOT-23, 5 PIN |
| 文件页数： | 15/17页 |
| 文件大小： | 147K |
| 代理商： | STCL1120YBFCWY5 |
STCL1100 STCL1120 STCL1160
Operation
7/17
3
Operation
Use of the STCL1xx0 silicon oscillator device is very simple. Once power is applied to VCC
pin, a CMOS-compatible square wave output signal is provided on the FOUT output pin (in
active mode the Chip Enable (CE) input pin must be at a logic high level).
3.1
Chip Enable (CE)
This feature allows the user to stop the clock and significantly reduce the current
consumption when the application is put into power saving mode.
When used to clock the microprocessor in place of a crystal, the need for chip enable input
stems from a difference in the way microprocessors normally disable their clock. In the case
of a crystal or ceramic resonator, when going into power saving mode, the processor simply
opens the internal Xtal inverter feedback which results in stopping the crystal oscillations;
however in the case of the silicon oscillators this would not work and the oscillator would
continue to run. So in order to use this feature, one of the microprocessor's output pins must
be configured to control the silicon oscillator's Chip Enable (CE) input, see Typical
application circuit diagram. To minimize standby current of the oscillator device, no internal
pull-up resistor is implemented on the CE input, thus the input level must be permanently
defined by the controlling signal.
3.2
Transition to disable
The device provides additional 32 complete clock cycles after the chip enable input went
inactive to allow the clocked microprocessor to complete pipelined instructions before going
into sleep mode. Then during disable the output remains low.
3.3
Fast startup and wakeup from disable
The total startup time until oscillations internally stabilize and remain within specifications is
50 s max from the point when VCC reached min operating voltage (at power on) or from the
point when CE went active (wakeup from disable mode). The output remains low even
during initial 16 cycles after CE went active to provide stabilized valid output waveform
already from the first output cycle, see Table 3: DC and AC parameters and Figure 8:
milliseconds typical for crystal oscillators or hundreds of microseconds for ceramic
resonators.
相关PDF资料 |
PDF描述 |
|---|---|
| STE10/100E | 1 CHANNEL(S), 100M bps, LOCAL AREA NETWORK CONTROLLER, PQFP128 |
| STEL-1173/CM | 8-BIT, DSP-NUM CONTROLLED OSCILLATOR, PQCC44 |
| STEL-1375A+80 | SPECIALTY MICROPROCESSOR CIRCUIT, DIP35 |
| STEL-1376 | SPECIALTY MICROPROCESSOR CIRCUIT, DIP65 |
| STEL-1377Q | SPECIALTY MICROPROCESSOR CIRCUIT, DIP63 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| STCL1120YBFCWY7 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:High frequency silicon oscillator family |
| STCL1160 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:High frequency silicon oscillator family |
| STCL1160YBFCWY5 | 功能描述:标准时钟振荡器 High Freq silicon oscillator RoHS:否 制造商:AVX 产品:Standard Clock Oscillators 封装 / 箱体:7 mm x 5 mm 频率:75 MHz 频率稳定性:50 PPM 电源电压:2.5 V 负载电容: 端接类型:SMD/SMT 最小工作温度:0 C 最大工作温度:+ 70 C 输出格式:LVDS 尺寸: 封装:Reel 系列: |
| STCL1160YBFCWY7 | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:High frequency silicon oscillator family |
| STCL132K | 制造商:STMICROELECTRONICS 制造商全称:STMicroelectronics 功能描述:32,768 Hz silicon oscillator |
发布紧急采购，3分钟左右您将得到回复。