STK433-040N-E
No.A2101-6/11
Recommended external components
STK433-040N-E/060N-E/130N-E/330N-E
Parts
Location
Recommended
value
Circuit purpose
Above
Recommended value
Below
Recommended value
R01, R23
100
/1W
Resistance for Ripple filter. (Fuse resistance is recommended.
Ripple filter is constituted with C03, C23.)
Short-through current
may decrease at
high frequency.
Short-through current
may increase at high
frequency.
R02, R03, R04
1k
Resistance for input filters.
-
R05, R06, R07
56k
Input impedance is determined.
Output neutral voltage(VN) shift.
(It is referred that R05=R08, R06=R09)
R08, R09, R10
56k
Voltage Gain (VG) is determined with R11, R12, R13
-
R11, R12, R13
1.8k
Voltage Gain (VG) is determined with R8, R9, R10
(As for VG, it is desirable to set up by R11, R12, R13)
It may oscillate.
(Vg < 30dB)
With especially no
problem
R14, R15, R16
4.7
Resistance for oscillation prevention.
-
R17, R18, R19
4.7
/1W
Resistance for oscillation prevention.
-
R20, R21, R22
0.22
/2W
(040N-E,060N-E)
0.22
/5W
(130N-E,330N-E)
This resistance is used as detection resistance of the protection
circuit application.
Decrease of
Maximum output
Power
It may cause thermal
runaway
R30
Note *5
Select Restriction resistance, for the impression voltage of ‘#17 (Stand-By) pin’ must not exceed the maximum
rating.
C01, C02
100
F/50V
Capacitor for oscillation prevention.
Locate near the HIC as much as possible.
Power supply impedance is lowered and stable operation of
the IC is carried out. (Electrolytic capacitor is recommended.)
-
C03, C23
100
F/50V
Decoupling capacitor
The Ripple ingredient mixed in an input side Is removed from a
power supply line. (Ripple filter is constituted with R01, R23.)
The change in the Ripple ingredient mixed in
an input side from a power supply line
C04, C05, C06
2.2
F/50V
Input coupling capacitor.(for DC current prevention.)
-
C07, C08, C09
470pF
Input filter capacitor
A high frequency noise is reduced with the filter constituted by
R02, R03, R04
-
C10, C11, C12
3pF
Capacitor for oscillation prevention.
It may oscillate.
C13, C14, C15
10
F/10V
Negative feedback capacitor.
The cutoff frequency of a low cycle changes.
(fL = 1/(2
C13 R11))
The voltage gain (VG)
of low frequency is
extended. However,
the pop noise at the
time of a power
supply injection also
becomes large.
The voltage gain (VG)
of low frequency
decreases.
C16, C17, C18
0.1
F
Capacitor for oscillation prevention.
It may oscillate.
C19, C20, C21
100pF (040N-E)
56pF (060N-E)
N.C. (130N-E,
330N-E)
Capacitor for oscillation prevention.
It may oscillate.
L01, L02, L03
3
H
Coil for oscillation prevention.
With especially
no problem
It may oscillate.