- 您现在的位置：买卖IC网 > PDF目录18736 > STM1E-SFP02 (Maxim Integrated)MOD TXRX COPPER MSA SFP PDF资料下载
参数资料
| 型号： | STM1E-SFP02 |
| 厂商： | Maxim Integrated |
| 文件页数： | 5/16页 |
| 文件大小： | 0K |
| 描述： | MOD TXRX COPPER MSA SFP |
| 标准包装： | 1 |
| 应用： | 电信 |
| 电源电压： | 3.15 V ~ 3.45 V |
| 电流 - 接收： | 100mA |
| 数据接口： | 串行，USB |
| 工作温度： | -20°C ~ 85°C |
| 封装/外壳： | 模块，连接器 |
| 包装： | 散装 |
STM1E-SFPxx 155Mbps Copper Transceiver
Final Datasheet
Host Interface Pinout
Pin
1
2
3
Name
VeeT
Tx Fault
Tx Disable
Description
Transmitter ground.
Not supported in STM1E-SFPxx. Grounded internally.
Transmit Disable. When pin is high or open, the transmitter is powered
Notes
Note 1
down and tri-stated.
4
5
6
7
MOD-DEF2
MOD-DEF1
MOD-DEF0
Rate Select
Module Definition 2. Bi-directional data pin of two wire serial ID
interface. This pin is open-drain and may be wired-ORed with other
open-drain or open-collector devices.
Module Definition 1. Clock pin of two wire serial ID interface. Data is
clocked into EEPROM device on the positive edge and clocked out on
the negative edge.
Module Definition 0. Grounded internally. Used to notify host system
that an SFP is present.
Not supported in STM1E-SFPxx. Floating internally.
8
RLOS
Receive Loss of Signal. Asserted when the received signal is less than
Note 2
approximately 19dB below nominal for 110 UI. The RLOS condition is
cleared when the received signal is greater than approximately 18dB
below nominal for 110 UI.
9 VeeR Receiver ground. Note 1
10 VeeR Receiver ground. Note 1
11 VeeR Receiver ground. Note 1
12 RD-
13 RD+
Recovered receive NRZ data output (inverted).
Recovered receive NRZ data output.
14 VeeR Receiver ground. Note 1
15 VccR Receiver power supply (+3.3V). Note 3
16 VccT Transmitter power supply (+3.3V). Note 3
17 VeeT Transmitter ground. Note 1
18 TD+
19 TD-
Transmit NRZ data input.
Transmit NRZ data input (inverted).
20 VeeT Transmitter ground. Note 1
Notes:
1. Transmit and Receive grounds are connected directly together internally. For STM1E-SFP08 version,
circuit grounds are also connected to frame/chassis ground.
2. During Rx LOS conditions, the receive data outputs RD+/- are squelched. See Receiver Loss of Signal
Condition section for more information on LOS detection for STM-1e interfaces.
3. Transmit and Receive power supplies are connected together internally.
STM1E-SFPxx Datasheet
-5-
August 2008 v2-2
相关PDF资料 |
PDF描述 |
|---|---|
| 7C-40.000MBB-T | OSC 40.000 MHZ 3.3V SMD |
| OH300-61003CV-010.0M | OSC OCVCXO 10.000 MHZ 3.3V |
| FI212L062007-T | FILTER LOWPASS DTV DVB-H SMD |
| OH100-61003CV-010.0M | OSC OCVCXO 10.000 MHZ 3.3V |
| PIXLITE-SO-PLFE | MODULE ZIGBEE SW FAST 24-SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| STM1E-SFP02 #DUPLICATE# | 制造商:Maxim Integrated Products 功能描述: |
| STM1E-SFP-03 | 制造商:Maxim Integrated Products 功能描述:- Rail/Tube |
| STM1E-SFP08 | 功能描述:LIN 收发器 155Mbps Copper Transceiver RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
| STM1E-SFP16 | 功能描述:LIN 收发器 RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
| STM1E-SFP22 | 功能描述:LIN 收发器 RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
发布紧急采购，3分钟左右您将得到回复。