参数资料
型号: STM32F103ZGH7TR
厂商: STMICROELECTRONICS
元件分类: 微控制器/微处理器
英文描述: 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PBGA144
封装: 10 X 10 MM, 0.80 MM PITCH, ROHS COMPLIANT, LFBGA-144
文件页数: 7/45页
文件大小: 803K
代理商: STM32F103ZGH7TR
STM32F103xF, STM32F103xG
Description
Doc ID 17144 Rev 2
2.3.14
Voltage regulator
The regulator has three operation modes: main (MR), low power (LPR) and power down.
MR is used in the nominal regulation mode (Run)
LPR is used in the Stop modes.
Power down is used in Standby mode: the regulator output is in high impedance: the
kernel circuitry is powered down, inducing zero consumption (but the contents of the
registers and SRAM are lost)
This regulator is always enabled after reset. It is disabled in Standby mode.
2.3.15
Low-power modes
The STM32F103xF and STM32F103xG performance line supports three low-power modes
to achieve the best compromise between low power consumption, short startup time and
available wakeup sources:
Sleep mode
In Sleep mode, only the CPU is stopped. All peripherals continue to operate and can
wake up the CPU when an interrupt/event occurs.
Stop mode
Stop mode achieves the lowest power consumption while retaining the content of
SRAM and registers. All clocks in the 1.8 V domain are stopped, the PLL, the HSI RC
and the HSE crystal oscillators are disabled. The voltage regulator can also be put
either in normal or in low-power mode.
The device can be woken up from Stop mode by any of the EXTI line. The EXTI line
source can be one of the 16 external lines, the PVD output, the RTC alarm or the USB
wakeup.
Standby mode
The Standby mode is used to achieve the lowest power consumption. The internal
voltage regulator is switched off so that the entire 1.8 V domain is powered off. The
PLL, the HSI RC and the HSE crystal oscillators are also switched off. After entering
Standby mode, SRAM and register contents are lost except for registers in the Backup
domain and Standby circuitry.
The device exits Standby mode when an external reset (NRST pin), an IWDG reset, a
rising edge on the WKUP pin, or an RTC alarm occurs.
Note:
The RTC, the IWDG, and the corresponding clock sources are not stopped by entering Stop
or Standby mode.
2.3.16
DMA
The flexible 12-channel general-purpose DMAs (7 channels for DMA1 and 5 channels for
DMA2) are able to manage memory-to-memory, peripheral-to-memory and memory-to-
peripheral transfers. The two DMA controllers support circular buffer management,
removing the need for user code intervention when the controller reaches the end of the
buffer.
Each channel is connected to dedicated hardware DMA requests, with support for software
trigger on each channel. Configuration is made by software and transfer sizes between
source and destination are independent.
相关PDF资料
PDF描述
STM32F103ZFT7XXX 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, PQFP144
STM32F107VBH7XXX 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, BGA100
STM32F107VBH6XXX 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, BGA100
STM32F105VBH7XXX 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, BGA100
STM32F105VCH6TR 32-BIT, FLASH, 72 MHz, RISC MICROCONTROLLER, BGA100
相关代理商/技术参数
参数描述
STM32F103ZGT6 功能描述:ARM微控制器 - MCU ARM Cortex M3 32-Bit 1Mbyte Flash 72 MHz RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
STM32F105/107 制造商:STMicroelectronics 功能描述:105/107 series development kit
STM32F105FVCT1 制造商:STMicroelectronics 功能描述:32-BIT CORTEX - Trays
STM32F105R8T6 功能描述:ARM微控制器 - MCU 32BIT Cortex 64/25 CONNECTIVITY LINE M3 RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT
STM32F105RBT6 功能描述:ARM微控制器 - MCU 32BIT Cortex 64/25 CONNECTIVITY LINE M3 RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT